Rambutan seeds are by-products generated from fruit-processing factories; the leftover seeds are buried in landfills, generating methane emissions. This work aimed to extract polysaccharides (POLS) from rambutan seeds by using subcritical water extraction (SWE). The effects of defatting pretreatment and operating parameters in SWE were investigated using a Box-Behnken design. The results show that defatting pretreatment significantly enriched the POLS yield, while it had no significant effect on the total sugar content. Using the desirability approach, the suitable feedstock for SWE was defatted rambutan seeds. The maximum desirability of 0.86 was found at a temperature range of 145-150 °C, an extraction time of 15 min, and a liquid-solid ratio of 10:1. The POLS yield and total sugar content were in the range of 52.33-55.63 g/100 g feedstock and 83.37-87.45 g/100 g POLS, respectively. The extracted POLS had an equivalent molecular weight of 413.70 kDa that could be used as an extender in plant-based products. In conclusion, the defatting pretreatment of rambutan seeds not only improved the POLS yield obtained via SWE but also generated additional lipids that could be utilized as an unconventional source of specialty fat.

Pectin was extracted from red dragon fruit (Hylocereus polyrhizus) peel using two different extraction methods: subcritical water extraction (SCWE) and conventional acid extraction (AE), from two different types of peels, fresh peel puree and dried peel powder. SCWE method on fresh peel puree showed an ~18.88 % increase in pectin yield compared to AE. Extracted pectin is classified as low methoxyl pectin (DE: 8.51-50.64 %), with an average molecular weight ranging from 115.23 kDa to 577.84 kDa and a Gal-A content of 44.09 % - 53.90 %. The potential of pectin from fresh peel puree to be applied as a biodegradable film was further explored. Different pectin concentrations (3-5 % w/v) were used to prepare the films. Regarding the film performance, PF-S5, which was produced from SCWE with 5 % of pectin concentration, exhibits better thermal stability (Tdmax 250 °C, residue of 28.69 %) and higher moisture barrier (WVP 5.59 × 10-11 g.cm-1.s-1.Pa-1). In comparison, PF-A showed lower water solubility (45.14-69.15 %), higher water contact angle (33.01° - 44.35°), and better mechanical properties (TS: 2.12-4.11 MPa, EB: 48.72-61.39 %). Higher molecular weight accompanied by higher DE and Gal-A content contributes to better pectin film properties.

In order to valorise winemaking grape stalks, subcritical water extraction at 160 and 180 °C has been carried out to obtain phenolic-rich extracts useful for developing active food packaging materials. Red (R) and white (W) varieties (from Requena, Spain) were used, and thus, four kinds of extracts were obtained. These were characterised as to their composition, thermal stability and antioxidant and antibacterial activity. The extracts were incorporated at 6 wt% into polylactic acid (PLA) films and their effect on the optical and barrier properties of the films and their protective effect against sunflower oil oxidation was analysed. Carbohydrates were the major compounds (25-38%) in the extracts that contained 3.5-6.6% of phenolic compounds, the R extracts being the richest, with higher radical scavenging capacity. Every extract exhibited antibacterial effect against Escherichia coli and Listeria innocua, while PLA films with extracts preserved sunflower oil against oxidation.

The use of green extraction methods that meet the criteria of sustainable and environmentally friendly technologies has been increasing in recent decades due to their many benefits. In this respect, extracts obtained using subcritical water are also gaining increased attention because of their potential antioxidant and antimicrobial properties. Their antimicrobial activity is mainly due to the presence of various polyphenolic compounds. Although the exact mechanism of the antibacterial action of polyphenolic compounds has not yet been fully investigated and described, polyphenols are known to affect the bacterial cell at several cellular levels; among other things, they cause changes and ruptures in the cell membranes of the bacterial cell, affect the inactivation of bacterial enzymes and damage bacterial DNA. The difference in the strength of the antimicrobial activity of the extracts is most likely a result of differences in their lipophilicity and in the number and position of hydroxyl groups and double bonds in the chemical structure of polyphenols. By changing the extraction conditions, especially the temperature, during subcritical water extraction, we affect the solubility of the compounds we want to extract. In general, as the temperature increases, the solubility of polyphenolic compounds also increases, and the reduction of the surface tension of subcritical water at higher temperatures also enables faster dissolution of polyphenolic compounds. Different bacterial strains have different sensitivity to different extracts. However, extracts obtained with subcritical water extraction demonstrate strong antimicrobial activity compared to extracts obtained with conventional methods.

The mushroom industry should implement green extraction technologies; however, there is not enough information on the differences between these techniques expressed as the chemical composition of the resulting extract. In this study, selected types of green extraction techniques (GETs) were used on Chaga (Inonotus obliquus) (Fr.) Pilát from Serbia (IS) and Mongolia (IM) to examine the differences that would enable the composition-based technology choices in the mushroom supplement industry. Subcritical water extraction (SWE), microwave-assisted (MW) extraction, and ultrasonic-assisted extraction (VAE) were used to prepare the extracts. SWE was performed at two different temperatures (120 and 200 °C), while 96% ethanol, 50% ethanol, and water were used for MW and VAE. The yield, the content of total phenols, total proteins, and carbohydrates, qualitative and quantitative analysis of phenolic compounds, carbohydrates, including α- and β- and total glucans, and fatty acids, were determined in the obtained extracts. SWE resulted in a significantly higher yield, total polysaccharide, and glucan content than any other technique. Glucose was the most dominant monosaccharide in the SWE samples, especially those extracted at 200 °C. The MW 50% EtOH extracts showed the highest yield of total phenols. Among the tested phenolic compounds, chlorogenic acid was the most dominant. SWE can be recommended as the most efficient method for extracting commercially important compounds, especially glucans and phenols.

Hesperidin is a phenolic compound usually found in citrus fruits, which is known for its anti-inflammatory and antioxidant properties. This bioactive compound has already been used to formulate medications to treat chronic venous insufficiency. In this work, through a system which allows the in-line coupling of the pressurized liquid extraction (PLE) and high-intensity ultrasound (HIUS) with solid phase extraction (SPE), and analysis by high-performance liquid chromatography with UV-Vis detector (HPLC-UV) in on-line mode, a method was developed to obtain, separate, and quantify hesperidin from the industrial waste of lime. An eco-friendly approach with water and ethanol as extraction solvents was used. Parameters such as temperature (80, 100, and 120 °C) and HIUS power (0, 200, and 400 W) were evaluated regarding hesperidin yield. In this context, the higher hesperidin yield (18.25 ± 1.52 mg/g) was achieved using water at a subcritical state (120 °C and 15 MPa). The adsorbent SepraTM C-18-E isolated hesperidin from the other extracted compounds employing 50% ethanol in the SPE elution. The possibility ofon-lineanalysis coupling a high-performance liquid chromatograph to an ultraviolet detector (HPLC-UV) system was studied and shown to be a feasible approach for developing integrated technologies. Conventional extractions and their antioxidant capacities were evaluated, highlighting the advantages of the HIUS-PLE-SPE extractive method. Furthermore, the on-linechromatographic analysis showed the potential of the HIUS-PLE-SPE- HPLC-UV system to quantify the extracted compounds in real time.

Blueberry fruits have been widely explored for their rich composition of bioactive compounds with recognized health benefits. In contrast, blueberry pruning waste (BPW), generated during the pruning stages of blueberries, has been typically overlooked, even though it can represent a potential source of natural antioxidants. This study aims to characterize the value-added compounds extracted from BPW using green techniques, namely microwave-assisted and subcritical water extraction. The total phenolic content ranged from 157 ± 5 to 335 ± 12 mg GAE/g dw, while the radical scavenging activity determined by a DPPH assay varied from 223 ± 21 to 453 ± 21 mg Trolox equivalents/g dw. Additionally, to ensure the safe application of BPW and its extracts, a screening of pesticides and several environmental contaminants was conducted. Chlorpyrifos-methyl was quantified at a concentration of 4.27 µg/kg in a Bluecrop variety collected in 2019; however, none of the studied compounds were found in the extracts. Despite the presence of a pesticide, this level was below the maximum residue limits for blueberry crops. The results of this study demonstrated the potential of this agro-industrial residue as a natural source of bioactive compounds with high antioxidant activity for food industry applications.

Most organic pollutants are serious environmental concerns globally due to their resistance to biological, chemical, and photolytic degradation. The vast array of uses of organic compounds in daily life causes a massive annual release of these substances into the air, water, and soil. Typical examples of these substances include pesticides, polychlorinated biphenyls (PCBs), and polycyclic aromatic hydrocarbons (PAHs). Since they are persistent and hazardous in the environment, as well as bio-accumulative, sensitive and efficient extraction and detection techniques are required to estimate the level of pollution and assess the ecological consequences. A wide variety of extraction methods, including pressurized liquid extraction, microwave-assisted extraction, supercritical fluid extraction, and subcritical water extraction, have been recently used for the extraction of organic pollutants from the environment. However, subcritical water has proven to be the most effective approach for the extraction of a wide range of organic pollutants from the environment. In this review article, we provide a brief overview of the subcritical water extraction technique and its application to the extraction of PAHs, PCBs, pesticides, pharmaceuticals, and others form environmental matrices. Furthermore, we briefly discuss the influence of key extraction parameters, such as extraction time, pressure, and temperature, on extraction efficiency and recovery.

With the increase in the world population, the overexploitation of the planet\'s natural resources is becoming a worldwide concern. Changes in the way humankind thinks about production and consumption must be undertaken to protect our planet and our way of living. For this change to occur, sustainable development together with a circular economic approach and responsible consumption are key points. Agriculture activities are responsible for more than 10% of the greenhouse gas emissions; moreover, by 2050, it is expected that food production will increase by 60%. The valorization of food waste is therefore of high importance to decrease the environmental footprint of agricultural activities. Fruits and vegetables are wildly consumed worldwide, and grapes are one of the main producers of greenhouse gases. Grape biomass is rich in bioactive compounds that can be used for the food, pharmaceutical and cosmetic industries, and their extraction from this food residue has been the target of several studies. Among the extraction techniques used for the recovery of bioactive compounds from food waste, subcritical water extraction (SWE) has been the least explored. SWE has several advantages over other extraction techniques such as microwave and ultrasound extraction, allowing high yields with the use of only water as the solvent. Therefore, it can be considered a green extraction method following two of the principles of green chemistry: the use of less hazardous synthesis (principle number 3) and the use of safer solvents and auxiliaries (principle number 5). In addition, two of the green extraction principles for natural products are also followed: the use of alternative solvents or water (principle number 2) and the use of a reduced, robust, controlled and safe unit operation (principle number 5). This review is an overview of the extraction process using the SWE of grape biomass in a perspective of the circular economy through valorization of the bioactive compounds extracted. Future perspectives applied to the SWE are also discussed, as well as its ability to be a green extraction technique.

Health-oriented preferences, a demand for innovative food concepts, and technological advances have greatly influenced changes in the food industry and led to remarkable development of the functional food market. Incorporating herbal extracts as a rich source of bioactive compounds (BC) could be an effective solution to meet the high demand of consumers in terms of expanding the high-quality range of functional foods. The aim of this study is the valorization of the bioactive potential of T. montanum L., an understudied Mediterranean plant species, and the in-depth elucidation of a polyphenolic profile with a UHPLC-HR MS/MS and NMR analysis. The total phenolic content (TPC) and antioxidant capacity (AC) were determined on heat-assisted (HAE), microwave-assisted (MAE) and subcritical water (SWE) extracts. In terms of antioxidant capacity, SWE extracts showed the most notable potential (ABTS: 0.402-0.547 mmol eq Trolox g-1 dw, DPPH: 0.336-0.427 mmol eq Trolox g-1 dw). 12 phenolic compounds were identified in the samples of T. montanum from six microlocations in Croatia, including nine phenylethanoid glycosides (PGs) with total yields of 30.36-68.06 mg g-1 dw and 25.88-58.88 mg g-1 dw in HAE and MAE extracts, respectively. Echinacoside, teupolioside, stachysoside A, and poliumoside were the most abundant compounds HAE and MAE extracts, making T. montanum an emerging source of PGs.