UNASSIGNED: To evaluate the efficacy and safety of Holmium: Yttrium-Aluminum-Garnet (Ho:YAG) laser in bladder lithotripsy using high-power settings > 100 W.
UNASSIGNED: A combined experimental and clinical study was conducted. The Quanta Cyber: Ho 150 with a 550 μm Quanta optical fiber was utilized in all set-ups. Ablation rates for soft and hard artificial stones were tested in vitro using 100 W and 20 W power settings. In the experiment, a porcine bladder was used. The optical fiber was inserted through a rigid cystoscope, whilst a K-type thermocouple was inserted in the bladder dome. The tested high-power settings were 152 W, 120 W and 105 W. In every trial, the lasing time was over 60 s. In the clinical study, 35 patients underwent transurethral high-power bladder lithotripsy. Laser settings were set between 100 W and 150 W.
UNASSIGNED: Stone mass (stone weight) was significantly lower after stone ablation independently of the stone type or the laser settings. Significantly higher mass decrease and ablation rate were detected in high-power compared to low-power settings. In the experiment, the highest temperature recorded was 32°C at 152 W. At 120 W and 105 W, the peak temperatures didn\'t reach 30°C. In the clinical study, a stone-free rate of 100% and a mean operative time of 43 ± 18 min were reported. All patients stayed in the hospital for one day except for one who presented minor hematuria. Additional complications did not occur.
UNASSIGNED: Ho:YAG laser lithotripsy > 100 W is an effective, fast and safe modality for the treatment of bladder calculi.

UNASSIGNED: Obstruction of a ureteroileal anastomosis after urinary diversion is an unpleasant situation for patients and clinicians alike.
UNASSIGNED: A 48-year-old man who underwent a radical cystectomy for muscle-invasive bladder cancer and urinary diversion using the Wallace technique complained of right back pain. Computed tomography showed right hydronephrosis. Cystoscopy via the ileal conduit revealed complete obstruction of the ureteroileal anastomosis. We performed a bilateral approach (antegrade and retrograde) to use the cut-to-the-light technique. A guidewire and 7Fr single J catheter could be inserted.
UNASSIGNED: The cut-to-the-light technique was useful for complete obstruction of the ureteroileal anastomosis, the length of which was <1 cm. Herein, we report on the cut-to-the-light technique with a literature review.

OBJECTIVE: To compare the efficacy of conventional low power and high power holmium: yttrium aluminum-garnet (Ho: YAG) laser lithotripsy settings during retrograde intrarenal surgery (RIRS).  METHODS: The prospective study was conducted in patients undergoing RIRS for renal stones less than 2 cm diameter. Pulsed Ho:YAG laser (Lumenis® Pulse TM P120 H) was used for laser lithotripsy and the patients were randomized into low power (LP) and high power (HP) laser lithotripsy settings groups. The lasing duration, total laser energy used (Joules), laser energy used to ablate 1 mm3 of stone (Joules/mm3), operative duration, stone ablation speed (mm3/s) and stone free rate were compared.
RESULTS: A total of 120 underwent RIRS with 63 and 57 patients in LP and HP group, respectively. Median stone volume and stone density were comparable between the groups. The total energy used and laser energy used to ablate 1mm3 of stone (Joules/mm3) were significantly higher in the HP group than in LP group (27.9 (16.4-46.2) J/ mm3 vs 9.7 (5.3-17.7) J/ mm3) (p < 0.01). Median (IQR) ablation speed were 0.8 (0.5-1.3) mm3/s and 0.6 (0.4-1) mm3/s in the LP and HP groups, respectively. The median lasing time, operative time and stone free rate were similar in both the groups.
CONCLUSIONS: The total energy used and J/mm3 were lower in the LP group than in HP group with similar lasing duration, operative duration, ablation speed and stone free rate for renal stones less than 2 cm.

UNASSIGNED: For the aging population, surgery for lumbar spinal canal stenosis (LSCS) requires minimally invasive procedures. Recently, trans-sacral epiduroscopic laser decompression for lumbar disc herniation has been reported with good results. In this study, we devised a new method to perform trans-sacral epiduroscopic laser ablation of the ligamentum flavum (LF), known to be the major cause of LSCS. Using a live pig, this study aims to evaluate the efficacy, safety, and drawbacks of this procedure.
UNASSIGNED: Using an epiduroscope, we observed intra-spinal canal structures and then examined the feasibility and problems of a decompression procedure to ablate the LF using holmium:YAG (Ho:YAG) laser. The pig was observed for behavioral changes and neurological deficits after the procedure. Histological analysis was performed to evaluate the amount of tissue ablation and damage to surrounding tissues.
UNASSIGNED: Although it was possible to partially ablate the LF using the Ho:YAG laser under epiduroscopy, it was difficult to maintain a clear field of view, and freely decompressing the target lesion has been a challenge. After the first two experiments, the pig neither showed abnormal behavior nor any signs of pain or paresis. However, in the third experiment, the pig died during the operation. On autopsy, no thermal or mechanical injury was noted around the ablated site, including the dura mater and nerve root. Histological analysis showed that the LF and lamina were deeply ablated as the laser power increased, and no damage was noted on surrounding tissues beyond a depth of 500 μm.
UNASSIGNED: Although Ho:YAG laser could ablate the ligamentum and bone tissues without causing damage to surrounding tissues, it was difficult to completely decompress the LF under epiduroscopy. This method is a potentially highly invasive procedure that requires caution in its clinical application and needs further improvement in terms of the instruments and techniques used.

OBJECTIVE: To compare the risk of laser fiber fracture between Ho:YAG laser and Thulium Fiber Laser (TFL) with different laser fiber diameters, laser settings, and fiber bending radii.
METHODS: Lengths of 200, 272, and 365 μm single use fibers were used with a 30 W Ho:YAG laser and a 50 W Super Pulsed TFL. Laser fibers of 150 µm length were also tested with the TFL only. Five different increasingly smaller bend radii were tested: 1, 0.9, 0.75, 0.6, and 0.45 cm. A total of 13 different laser settings were tested for the Ho:YAG laser: six fragmentation settings with a short pulse duration, and seven dusting settings with a long pulse duration. A total of 33 different laser settings were tested for the TFL. Three laser settings were common two both lasers: 0.5 J × 12 Hz, 0.8 J × 8 Hz, 2 J × 3 Hz. The laser was activated for 5 min or until fiber fracture. Each measurement was performed ten times.
RESULTS: While fiber failures occurred with all fiber diameters with Ho:YAG laser, none were reported with TFL. Identified risk factors of fiber fracture with the Ho:YAG laser were short pulse and high energy for the 365 µm fibers (p = 0.041), but not for the 200 and 272 µm fibers (p = 1 and p = 0.43, respectively). High frequency was not a risk factor of fiber fracture. Fiber diameter also seemed to be a risk factor of fracture. The 200 µm fibers broke more frequently than the 272 and 365 µm ones (p = 0.039). There was a trend for a higher number of fractures with the 365 µm fibers compared to the 272 µm ones, these occurring at a larger bend radius, but this difference was not significant.
CONCLUSIONS: TFL appears to be a safer laser regarding the risk of fiber fracture than Ho:YAG when used with fibers in a deflected position.

The assessment of five different laser treatments in the conservation of wall paintings was devised on the basis of the surface temperature monitoring by infrared thermography (IRT), ultraviolet-induced fluorescence-visible (UV-VIS) imaging, and optical coherence tomography (OCT). A series of yttrium-aluminum-garnet (YAG) lasers were tested for removal of shellac layers from wall painting mock-ups. The mock-ups were realized as buon fresco with different mineral based pigments (earths and iron oxide) on a lime- and sand-based mortar. After the carbonatation process, all the samples were treated with shellac (5% in ethanol). The effects of neodymium (Nd):YAG, holmium (Ho):YAG, and erbium (Er):YAG laser sources, in different operative modes, on average temperature of the surface, color, and morphology were inspected with complementary sensors. The results show the necessity to adopt a combined approach in establishing safe laser operating conditions to avoid any undesired effects induced on the artefacts by the laser treatments. We demonstrate, for the first time, the performance of the Ho:YAG laser in the removal of a conservation treatment.

BACKGROUND: Treatment of broncholithiasis is complex, especially in the case of a large or transbronchial broncholith. Holmium-yttrium aluminum garnet (Ho:YAG) laser lithotripsy may be a useful treatment in broncholithiasis; however, as it is not yet common practice, the optimal parameters are unknown.
METHODS: We performed a single-center retrospective analysis of the clinical data of 13 broncholithiasis patients who underwent Ho:YAG laser lithotripsy from May 2012 to October 2018.
RESULTS: For the 13 patients (2 males and 11 females), Ho:YAG laser lithotripsy was performed 17 times, in total. All procedures were performed under general anesthesia with rigid bronchoscopy. We initially set the Ho:YAG laser to a pulse frequency of 5 Hz and a pulse energy of 0.8 J, gradually increasing these as required. The pulse frequency range we employed was 5-15 Hz, and the pulse energy range was 0.8-1.6 J. All broncholiths were successfully extracted after lithotripsy, and all symptoms improved. Hemoptysis, bronchial esophageal fistula, and pneumonia were the most common complications; however, there were no long-term complications.
CONCLUSIONS: Ho:YAG laser lithotripsy is an effective and safe treatment for broncholithiasis, over a long-term follow up.

Both retrograde and antegrade approach contributed to the success of a delicate endoscopic procedure. Even when guidewire did not pass thorough to the stenosis lesion, lightning and contrast reagents contributed the way through to the stenosis lesion.

Purpose: To evaluate the efficacy of new super pulse thulium fiber laser (SP TFL) and compare it with holmium laser for ureterolithotripsy. Patients and Methods: A total of 174 patients with solitary ureteral calculi were enrolled in 2016 to 2018. Stone sizes ranged between 0.6 and 2.4 cm. The SP TFL FiberLase U2 and 120H Ho:YAG laser with fibers diameters of 400 and 365 μm, respectively, were used. The laser settings were 1 J × 10 Hz = 10 W for both devices. All patients were randomized into two groups. The age, stone size, location, and density were comparable in both groups. The evaluated parameters were operation time, endoscopic view quality, retropulsion grade, stone-free rate, and complication rate. Results: The total operation time and lasering time were longer in the Ho:YAG group (24.7 ± 0.7 minutes vs 32.4 ± 0.7 minutes, p = 0.05), and postoperative stenting was necessary in one vs four cases, respectively. At 30 days of follow-up, no residual stones were observed in the SP TFL group (vs five cases of Ho:YAG). Conclusion: SP TFL technology was associated with excellent efficacy/safety ratio. The SP TFL may be considered as a viable alternative to Ho:YAG laser stone management.

The goal of this study was to assess the ablation, coagulation, and carbonization characteristics of the holmium:YAG (Ho:YAG) laser and thulium fiber lasers (TFL). The Ho:YAG laser (100 W av.power), the quasi-continuous (QCW) TFL (120 W av.power), and the SuperPulsed (SP) TFL (50 W av.power) were compared on a non-frozen porcine kidney. To control the cutting speed (2 or 5 mm/s), an XY translation stage was used. The Ho:YAG was tested using E = 1.5 J and Pav = 40 W or Pav = 70 W settings. The TFL was tested using E = 1.5 J and Pav = 30 W or Pav = 60 W settings. After ex vivo incision, histological analysis was performed in order to estimate thermal damage. At 40 W, the Ho:YAG displayed a shallower cutting at 2 and 5 mm/s (1.1 ± 0.2 mm and 0.5 ± 0.2 mm, respectively) with virtually zero coagulation. While at 70 W, the minimal coagulation depth measured 0.1 ± 0.1 mm. The incisions demonstrated zero carbonization. Both the QCW and SP TFL did show effective cutting at all speeds (2.1 ± 0.2 mm and 1.3 ± 0.2 mm, respectively, at 30 W) with prominent coagulation (0.6 ± 0.1 mm and 0.4 ± 0.1 mm, respectively, at 70 W) and carbonization. Our study introduced the TFL as a novel efficient alternative for soft tissue surgery to the Ho:YAG laser. The SP TFL offers a Ho:YAG-like incision, while QCW TFL allows for fast, deep, and precise cutting with increased carbonization.