Over two decades, the area with sugarcane has more than doubled, from 4.8 million hectares in 2000 to 10 million in 2018, in Brazil. São Paulo State is mostly responsible for the sugarcane production in the country, accounting for 51% of the national production. In 2008, a study was conducted analysing the relationship between sugarcane cultivation and the aquatic macroinvertebrate community, showing the impacts of sugarcane on the macroinvertebrate aquatic fauna. The present study aims to gather actual information on the aquatic macroinvertebrate community in the same streams studied in 2008, to make a historical comparison with studies previously carried out. Eight streams were selected; four located in areas of sugarcane cultivation and four located in preserved areas. Three samples were carried out between 2018 and 2020. The aquatic macroinvertebrates were collected using a D-frame aquatic net (250 μm) including riffle and pools areas and identified using specific identification keys. The results of the historical assessment showed better ecological conditions of the streams in 2008 when compared to 2018 in areas of sugarcane cultivation, suggesting that the environmental impact was maintained and increased after ten years.

Sugarcane (Saccharum officinarum) is an important crop, native to tropical and subtropical regions and it is a major source of sugar and Bioenergy in the world. Abiotic stress is defined as environmental conditions that reduce growth and yield below the optimum level. To tolerate these abiotic stresses, plants initiate several molecular, cellular, and physiological changes. These responses to abiotic stresses are dynamic and complex; they may be reversible or irreversible. Waterlogging is an abiotic stress phenomenon that drastically reduces the growth and survival of sugarcane, which leads to a 15-45% reduction in cane\'s yield. The extent of damage due to waterlogging depends on genotypes, environmental conditions, stage of development and duration of stress. An improved understanding of the physiological, biochemical, and molecular responses of sugarcane to waterlogging stress could help to develop new breeding strategies to sustain high yields against this situation. The present review offers a summary of recent findings on the adaptation of sugarcane to waterlogging stress in terms of growth and development, yield and quality, as well as biochemical and adaptive-molecular processes that may contribute to flooding tolerance.

OBJECTIVE: The extracellular polysaccharide (EPS) is produced by the bacterium Zoogloea sp. and plays a positive role in tissue repair. The purpose of this study was to clinically and histologically compare the effects of EPS in the healing of traumatic oral ulcers in rats with the effects of triamcinolone.
METHODS: Ulcers were induced in the oral mucous of 45 male Wistar rats, divided into three groups: control group, treated with triamcinolone, and treated with biopolymer gel. In the clinical evaluation, we considered the weight variation of the animals and the size of the lesion area, at baseline and on treatment days 1, 3 and 7. The histological parameters evaluated were the type and intensity of the inflammatory infiltration, the presence of necrosis and foreign body granuloma and the degree of re-epithelialization of the lesion.
RESULTS: The reduction of the lesion area was greater in the animals treated with EPS, with no difference in the intensity of the inflammatory infiltration between the groups on days 3 and 7 of treatment.
CONCLUSIONS: The results suggest that topical application of EPS in traumatic oral ulcers of rats promotes faster repair than triamcinolone ointment, without increasing the intensity of inflammatory infiltration under the lesion.

Microcrystalline cellulose (MCC) was successfully synthesized from sugarcane bagasse using a rapid, low-temperature hydrochloric acid (HCl) gas treatment. The primary aim was to develop an energy-efficient \"green\" cellulose extraction process. Response surface methodology optimized the liquid-phase hydrolysis conditions to 3.3 % HCl at 117 °C for 127 min to obtain MCC with 350 degree of polymerization. An alternative gas-phase approach utilizing gaseous HCl diluted in hot 40 °C air was proposed to accelerate MCC production. The cellulose pulp was moistened to 15-18 % moisture content and then exposed to HCl gas, which was absorbed by the moisture in the cellulose fibers to generate a highly concentrated acidic solution that hydrolyzed the cellulose. The cellulose pulp was isolated from depithed bagasse through soda pulping, multistage bleaching and cold alkali purification. Hydrolysis was conducted by saturating the moist cellulose fibers with gaseous HCl mixed with hot air. Extensive analytical characterization using FT-IR, XRD, SEM, TGA, DSC, particle size, and porosity analyses verified comparable physicochemical attributes between MCC samples prepared via liquid and gas phase methods. The gas-produced MCC revealed 85% crystallinity, 71 Å crystallite dimensions, and thermally stable rod-shaped morphology with an average diameter below 200 μm. The similar material properties validate the proposed gas-based technique as an equally effective yet more energy-efficient alternative to conventional aqueous acid hydrolysis for fabricating highly pure MCC powders from lignocellulose. This sustainable approach enables the value-addition of sugarcane bagasse agro-industrial residue into cellulosic nanomaterials for wide-ranging industrial applications. In summary, the key achievements of this work are rapid MCC production under mild temperatures using HCl gas, optimization of liquid phase hydrolysis, successful demonstration of gas phase method, and extensive characterization verifying equivalence between both protocols. The gas methodology offers a greener cellulose extraction process from biomass.

Sugarcane, a major sugar and energy crop worldwide faces an increasing demand for higher yields. Identifying yield-related markers and candidate genes is valuable for breeding high-yield varieties using molecular techniques. In this work, seven yield-related traits were evaluated in a diversity panel of 159 genotypes, derived from Tripidium arundinaceum, Saccharum spontaneum, and modern sugarcane genotypes. All traits exhibited significant genetic variance with high heritability and high correlations. Genetic diversity analysis reveals a genomic decay of 23 kb and an average single nucleotide polymorphism (SNP) number of 25,429 per genotype. These 159 genotypes were divided into 4 subgroups. Genome-wide association analysis identified 47 SNPs associated with brix, spanning 36 quantitative trait loci (QTLs), and 138 SNPs for other traits across 104 QTLs, covering all 32 chromosomes. Interestingly, 12 stable QTLs associated with yield-related traits were identified, which contained 35 candidate genes. This work provides markers and candidate genes for marker-assisted breeding to improve sugarcane yields.

This work conducted experimental combustion on a closed chamber using two different materials: mixture (1:1) sugarcane bagasse/straw and pre-treated biomass. The sampling method was an Andersen cascade impactor with eight stages. Tests were carried out on untreated biomass varying the velocities observed in the sampling duct (4.18; 5.20, 6.85, and 8.21 m.s-1). Pre-treated biomass tests were performed at 4.19 m.s-1 because in this condition there is a higher speed stability inside the duct. During the combustion tests, the concentration of emitted particles was higher for the lower speed range, with an order of 4.19 > 5.40 > 6.85 > 8.21 m.s-1. The higher speeds observed inside the duct behaved as a dragging agent for particulate material. For the tests at the speed of 8.21 m.s-1 where the flow inside the duct was 0.088 m3s-1, this behavior is more evident. Considering the fine diameter particles (< 2.5 µm), they were emitted in a higher concentration, due to the biomass combustion process, which results in higher emission of ultrafine particles. The emission factors (EFs) obtained for PM10 for untreated biomass were in the range of 0.414 and 0.840. On the other hand, considering the pre-treated biomass, these factors were 0.70 and 1.51. The EFs of PM from the burning of the pre-treated biomass were higher when compared to untreated biomass, which is mainly due to the higher temperature of the process due to the higher HHV (higher heating value) of this material, caused by the removal of hemicellulose (4.71 times) and a proportional increase in lignin (1.52 times). Biomass combustion has the potential to partially replace fossil fuels in heat and energy generation. Nevertheless, more stringent and comprehensive legislation should be established to ensure that air quality is maintained. Furthermore, the emission factors obtained in this study might be useful as input data for air quality modeling in the context of sugarcane\'s burning biomass, thus, contributing to the generation of inventories that include emissions of this nature.

Soil fertility management and crop productivity both are inter-related need extensive attention for sustainability. Industries are being built, which over time produces a lot of effluents containing heavy metal(s), which is then dumped on healthy soils and water bodies. Long-term discharge of lead (Pb)-containing wastewater resulted in significant Pb buildup as well as a decrease in soil biological activity. In this experiment, graded dose of Pb, i.e. 0, 100, 150 and 300 mg/kg and pressmud (PM) (0, 2.5, 5, 10 g/kg) were applied to monitor the Pb toxic effect on soil acid and alkaline phosphatase, dehydrogenase activity. Different treatment combinations were formulated and the experiment was conducted in a completely randomized design (CRD) with three replications. In this experiment, spinach crop was used as a test crop. According to the findings, increased Pb levels in the soil lowered dehydrogenase activity (DHA), acid and alkaline phosphatase. The addition of PM enhanced enzymatic activities by decreasing the labile fraction of Pb in the soil. Incorporation of PM improved the soil enzymatic activities as alkaline phosphatase activity > DHA > acid phosphatase activity in the study. This study suggested that the addition of 10 g/kg PM reduced Pb toxicity (contamination level 300 mg/kg) and improved the soil microbial properties in black soil. These findings are very useful for the remediation of Pb contaminated soil with the help of PM, particularly in peri-urban Pb effluent irrigated areas.

In this study, sugarcane molasses essential oils (SMEOs) were extracted by microwave-assisted hydrodistillation (MAHD); the components of SMEOs were identified and analyzed by gas chromatography-mass spectrometry (GC-MS). SMEOs were loaded into mesoporous silica nanoparticles (MSNPs) and their sustained-release activity was evaluated. In vivo anti-inflammatory activity assays pertained to inhibiting the auricle swelling caused by xylene in mice, the peritoneal permeability increased inflammation in mice induced by acetic acid and the inflammation caused by granuloma hyperplasia in mice. We demonstrated that the main components of SMEOs were isoamylol, ethyl acetate, isobutanol, isovaleraldehyde, 2-methyl-butanal, furfural and 2-acetylpyrrole. The SMEOs loaded into MSNPs formed MSNP-SMEOs, which enhanced the stability and slow-release performance compared with SMEOs. The main components of SMEOs can inhibit inflammation, and the development and application of SMEOs in the fields of food and medicine have certain potential.

This paper reports the use of naturally available raw material as sugarcane bagasse (SB) to prepare cost-effective activated carbon. Activated carbon preparation from SB by using ZnCl2 was carried out by chemical activation method. The raw bagasse, its char and activated carbon were characterized on the basis of iodine number, carbon, hydrogen, nitrogen analysis, Fourier-transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), thermogravimetric analysis (TGA) and Brunauer-Emmett-Teller (BET) surface area to check their effectiveness. During activated carbon synthesis, the impregnation ratio of SB and ZnCl2 was maintained at 1:1-1:3 and activation temperature was in the range of 600-900 °C for 1 h. From the characterization study, the highest iodine adsorption of activated carbon was found to be 1140.69 mg/g with a 1:2 ratio at 900 °C whereas char gives an iodine number of 529.63 mg/g at the same temperature. The BET surface area of raw bagasse, its char and activated carbon (SB-Zn2-900) obtained was 4.30, 514.27 and 1386.58 m2/g, respectively, which shows charrification and chemical activation improves surface area. The optimum ratio of impregnation and activation temperature was found to be 1:2 at 900 °C. In this work, activated carbon was successfully prepared and obtained product has better characteristics than previously reported studies.

Probiotics are regarded as a potential source of functional foods for improving the microbiota in human gut. When consumed, these bacteria can control the metabolism of biomolecules, which has numerous positive effects on health. Our objective was to identify a probiotic putative Lactobacillus spp. from fermented sugarcane juice that can prevent α-glucosidase and α-amylase from hydrolyzing carbohydrates. Isolates from fermented sugarcane juice were subjected to biochemical, molecular characterization (16S rRNA) and assessed for probiotic traits. Cell-free supernatant (CS) and extract (CE) and also intact cells (IC) were examined for the inhibitory effect on α-glucosidase and α-amylase. CS of the strain showed the highest inhibition and was subjected to a liquid chromatography-mass spectrometry (LCMS) analysis to determine the organic acid profile. The in silico approach was employed to assess organic acid stability and comprehend enzyme inhibitors\' impact. Nine isolates were retained for further investigation based on the preliminary biochemical evaluation. Limosilactobacillus spp., Levilactobacillus spp., and Lacticaseibacillus spp. were identified based on similarity > 95% in homology search (NCBI database). The strains had a higher survival rate (>98%) than gastric and intestinal fluids, also a high capacity for adhesion (hydrophobicity > 56%; aggregation > 80%; HT-29 cells > 54%; buccal epithelial cells > 54%). The hemolytic assay indicated that the isolates could be considered safe. The isolates\' derivatives inhibited enzymes to varying degrees, with α-glucosidase inhibition ranging from 21 to 85% and α-amylase inhibition from 18 to 75%, respectively. The CS of RAMULAB54 was profiled for organic acid that showed the abundance of hydroxycitric acid, citric acid, and lactic acid indicating their role in the observed inhibitory effects. The in silico approach has led us to understand that hydroxycitric acid has the ability to inhibit both the enzymes (α-glucosidase and α-amylase) effectively. Inhibiting these enzymes helps moderate postprandial hyperglycemia and regulates blood glucose levels. Due to their promising antidiabetic potential, these isolates can be used to enhance intestinal health.