This work reports the synthesis of chiral perovskite heterostructure films by combining a two-dimensional (2D) chiral (R-/S-MBA)2PbI4 perovskite with CsPbBr3 quantum dots (QDs). The as-synthesized chiral heterostructure films exhibit obvious circularly polarized luminescence (CPL) properties, even though pure 2D chiral perovskite cannot present photoluminescence. It indicates that the chirality of the excited state of the QDs originates from the 2D chiral perovskite. The circular polarization-resolved transient absorption (TA) spectra further demonstrate that the CPL response of heterostructure films originates from the energy transfer between the chiral perovskite layer and QDs layer and the suppression of spin relaxation, which induces the imbalance of the spin population of excited states in QDs layer. In addition, the photoluminescence (PL), circular dichroism (CD), and CPL spectra of these heterostructure films can be controlled by varying the thickness and component of the chiral perovskite layer, which demonstrates that the anion exchange between chiral perovskite and CsPbBr3 QDs can tune the chemical composition and optoelectronic properties due to the low bonding energy difference between them and decrease the strain within the QDs layer to reduce the radiative recombination lifetime. This work provides guidance for the synthesis of chiral perovskites with a strong CPL response and further provides insight into the origination of CPL.

The vertical phase distribution of active layers plays a vital role in balancing exciton dissociation and charge transport for achieving efficient polymer solar cells (PSCs). The layer-by-layer (LbL) PSCs are commonly prepared by using sequential spin-coating method from donor and acceptor solutions with distinct solvents and solvent additives. The enhanced exciton dissociation is expected in the LbL PSCs with efficient charge transport in the relatively neat donor or acceptor layers. In this work, a series of LbL all-polymer solar cells (APSCs) were fabricated with PM6 as donor and PY-DT as acceptor, and triplet material m-Ir(CPmPB)3 is deliberately incorporated into PY-DT layer to prolong exciton lifetimes of active layers. The power conversion efficiency (PCE) of LbL APSCs is improved to 18.24% from 17.32% by incorporating 0.3 wt% m-Ir(CPmPB)3 in PY-DT layer, benefiting from the simultaneously enhanced short-circuit current density (JSC) of 25.17 mA cm-2 and fill factor (FF) of 74.70%. The enhancement of PCE is attributed to the efficient energy transfer of m-Ir(CPmPB)3 to PM6 and PY-DT, resulting in the prolonged exciton lifetime in the active layer and the increased exciton diffusion distance. The efficient energy transfer from m-Ir(CPmPB)3 to PM6 and PY-DT layer can be confirmed by the increased photoluminescence (PL) intensity and the prolonged PL lifetime of PM6 and PY-DT in PM6 + m-Ir(CPmPB)3 and PY-DT + m-Ir(CPmPB)3 films. This study indicates that the triplet material as solid additive has great potential in fabricating efficient LbL APSCs by prolonging exciton lifetimes in active layers.

Ultrafast spectroscopic techniques have been vital in studying excitation energy transfer (EET) in photosynthetic light harvesting complexes. In this paper, we simulate the pump-probe spectra of the B850 band of the light harvesting complex 2 (LH2) of purple bacteria, by using the hierarchical equation of motion method and the optical response function approach. The ground state bleach, stimulated emission, and excited state absorption components of the pump-probe spectra are analyzed in detail. The laser pulse-induced population dynamics are also simulated to help understand the main features of the pump-probe spectra and the EET process. It is shown that the excitation energy relaxation is an ultrafast process with multiple time scales. The first 40 fs of the pump-probe spectra is dominated by the relaxation of the k = ±1 states to both the k = 0 and higher energy states. Dynamics on a longer time scale around 200 fs reflects the relaxation of higher energy states to the k = 0 state.

Chemiluminescence resonance energy transfer (CRET) efficiency can be enhanced by confining CRET donors and acceptors within nanoscale spaces. However, this enhanced efficiency is often affected by uncertainties stemming from the random distribution of CRET donors and acceptors in such confined environments. In this study, a novel confined nanospace was created through the surfactant modification of carbon dots (CDs) exhibiting aggregation-induced emission (AIE) characteristics. Hydrophobic CRET donors could be effectively confined within this nanospace. The distance between the CRET donors and acceptors could be controlled by anchoring the AIE-CDs as the CRET acceptors, resulting in significantly improved CRET efficiency. Furthermore, this AIE-CDs-based CRET system was successfully applied to the detection of hydrogen peroxide (H2O2) in rainwater, showcasing its potential for practical applications.

In this Letter, a sensitive DNA sensing platform was developed using an indium-ion-coordinated 1,1,2,2-tetra(4-carboxylphenyl)ethylene (TPE) metal-organic gel (In-MOG) as an aggregation-induced electrochemiluminescence (AIECL) emitter and nanosurface energy transfer (NSET) as an efficient quenching strategy for detecting aflatoxin B1 (AFB1), the most dangerous food toxin. The coordination occurred in indium ions, and carboxyl groups restricted the internal rotation and vibration of TPE molecules, forcing them to release photons via radiative transitions. The quenchers of microfluidic-produced gold nanoparticles were embedded in a long-tailed triangular DNA structure, where the quenching phenomenon aligned with the theory of ECL-NSET under the overlap of spectra and appropriate donor-acceptor spacing. The proposed analytical method showed a sensitive ECL response to AFB1 in the wide concentration range of 0.50-200.00 ng/mL with a limit of detection of 0.17 ng/mL. Experimental results confirmed that constraining luminescent molecules using coordination and bonding to trigger the AIECL phenomenon was a promising method to prepare signal labels for the trace detection of food toxins.

Iron ion (Fe3+) detection is crucial for human health since it plays a crucial role in many physiological activities. In this work, a novel Schiff-base functionalized cyanine derivative (CyPy) was synthesized, which was successfully assembled on the surface of upconversion nanoparticles (UCNPs) through an amphiphilic polymer encapsulation method. In the as-designed nanoprobe, CyPy, a recognizer of Fe3+, is served as energy donor and β-NaYF4:Yb,Er upconversion nanoparticles are adopted as energy acceptor. As a result, a 93-fold enhancement of upconversion luminescence is achieved. The efficient energy transfer from CyPy to β-NaYF4:Yb,Er endows the nanoprobe a high sensitivity for Fe3+ in water with a low detection limit of 0.21 μM. Moreover, the nanoprobe has been successfully applied for Fe3+ determination in human serum and tap water samples with recovery ranges of 95 %-105 % and 97 %-106 %, respectively. Moreover, their relative standard deviations are all below 3.72 %. This work provides a sensitive and efficient methodology for Fe3+ detection in clinical and environmental testing.

Helicenes represent a class of fascinating π compounds with fused yet folded backbones. Despite their broad structural diversity, harnessing helicenes to develop well-defined materials is still a formidable challenge. Here we report the synthesis of crystalline porous helicene materials by exploring helicenes to synthesize covalent 2D lattices and layered π frameworks. Topology-directed polymerization of [6]helicenes and porphyrin creates 2D covalent networks with alternate helicene-porphyrin alignment along the x and y directions at a 1.5-nm interval and develops [6]helicene frameworks through reversed anti-AA stack along the z direction to form segregated [6]helicene and porphyrin columnar π arrays. Notably, this π configuration enables the frameworks to be highly red luminescent with benchmark quantum yields. The [6]helicene frameworks trigger effieicnt intra-framework singlet-to-singlet state energy transfer from [6]helicene to porphyrin and facilitate intermolecular triplet-to-triplet state energy transfer from frameworks to molecular oxygen to produce reactive oxygen species, harvesting a wide range of photons from ultraviolet to near-infrared regions for light emitting and photo-to-chemical conversion. This study introduces a new family of extended frameworks, laying the groundwork for exploring well-defined helicene materials with unprecedented structures and functions.

The near-infrared (NIR) down-conversion process for broadband sensitization has been studied in Eu2+-Nd3+ co-doped BaAl2O4. This material has a broad absorption band of 200-480 nm and can convert photons in the visible region into NIR photons. The NIR emission at 1064 nm, attributed to the Nd3+:4F3/2 → 4I11/2 transition, matches the bandgap of Si, allowing Si solar cells to utilize the solar spectrum better. The energy transfer (ET) process between Eu2+ and Nd3+ was demonstrated using photoluminescence spectra and luminescence decay curves, and Eu2+ may transfer energy to Nd3+ through the cooperative energy transfer (CET) to achieve the down-conversion process. The energy transfer efficiency (ETE) and theoretical quantum efficiency (QE) were 68.61% and 156.34%, respectively, when 4 mol% Nd3+ was introduced. The results indicate that BaAl2O4:Eu2+-Nd3+ can serve as a potential modulator of the solar spectrum and is expected to be applied to Si solar cells.

A ratio luminescence probe was developed for detecting Staphylococcus aureus (S. aureus) based on luminescence energy transfer (LET) using double-wavelength emission (550 nm and 812 nm) upconversion nanoparticles (UCNPs) as donor, gold nanoparticles (AuNPs) as acceptor and the aptamer for S. aureus as the specific recognition and link unit. The LET process could cause luminescence quenching because of the spectral overlap between the acceptor and the donor at 550 nm. In the presence of S. aureus, S. aureus selectively combined with the aptamer, and the AuNPs left the surface of UCNPs, which weakened the quenching effect and restored the luminescence of UCNPs. Based on this, the ratio detection was realized by monitoring the change of the luminescence signal of the probe at 550 nm and taking the luminescence signal at 812 nm as the reference signal. Crucially, the probe has a fast reaction speed, with a reaction time of 25 min, and the detection of S. aureus is realized in the concentration range of 5.0 × 103-3.0 × 105 CFU/ml, with the detection limit of 106 CFU/ml. Therefore, the ratio probe has great potential for detecting of S. aureus in food because of its high sensitivity, fast speed and good selectivity.

A visible-light-initiated energy-transfer enabled radical cyclization for the divergent synthesis of polycyclic γ-sultine derivatives has been developed. The reaction provides an alternative and expeditious access to benzofused γ-sultine frameworks, the analogues of γ-lactones and γ-sultones, and features good functional group compatibility, mild reaction conditions and excellent diastereoselectivity. The robustness and application potential of this method have also been successfully displayed by two gram-scale reactions and the synthesis of polycyclic sultones. Mechanistic studies indicated the transformations through a possible energy-transfer enabled intramolecular radical homolytic substitution or hydrogen atom transfer process mainly.