The transport and retention of bacteria in porous media, such as aquifer, are governed by the solid-liquid interface characteristics and bacterial mobility. The secretion of extracellular polymeric substance (EPS) by bacteria modifies their surface property, and thereby has effects on their adhesion to surface. The role of EPS in bacterial mobility within saturated quartz sand media is uncertain, as both promoting and inhibitory effects have been reported, and underlying mechanisms remain unclear. In this study, the effects of EPS on bacterial transport behavior and possible underlying mechanism were investigated at 4 concentrations (0 mg L-1, 50 mg L-1, 200 mg L-1 and 1000 mg L-1) using laboratory simulation experiments in conjunction with Extend Derjaguin-Landau-Verweu-Overbeek (XDLVO) modeling. The results showed that EPS facilitated bacterial mobility at all tested concentrations. It could be partially explained by the increased energy barrier between bacterial cells and quartz sand surface in the presence of EPS. The XDLVO sphere-plate model predicted that EPS induced a higher electrostatic double layer (EDL) repulsive force, Lewis acid-base (AB) and steric stabilization (ST), as well as a lower Lifshitz-van der Waals (LW) attractive force. However, at the highest EPS concentration (1000 mg L-1), the promotion of EPS on bacterial mobility weakened as a result of lower repulsive interactions between cells, which was supported by observed enhanced bacterial aggregation. Consequently, the increased aggregation led to greater bio-colloidal straining and ripening in the sand column, weakening the positive impact of EPS on bacterial transport. These findings suggested that EPS exhibited concentration-dependent effects on bacterial surface properties and transport behavior and revealed non-intuitive dual effects of EPS on those processes.

Microplastics (MPs) vary in shape and surface characteristics in the environment. The attachment of MPs to surfaces can be studied using the Derjaguin-Landau-Verwey-Overbeek (DLVO) theory. However, this theory does not account for the shape MPs. Therefore, we investigated the attachment of spherical, pear-shaped, and peanut-shaped polystyrene MPs to quartz sand in NaCl and CaCl2 solutions using batch tests. The attachment of MPs to quartz sand was quantified using the attachment efficiency (alpha). Subsequently, alpha behaviors were interpreted using energy barriers (EBs) and interaction minima obtained from extended DLVO calculations, which were performed using an equivalent sphere model (ESM) and a newly developed equivalent Cassini model (ECM) to account for the shape of the MPs. The ESM failed to interpret the alpha behavior of the three MP shapes because it predicted high EBs and shallow minima. The alpha values for spherical MPs (0.62-1.00 in NaCl and 0.48-0.96 in CaCl2) were higher than those for pear- and peanut-shaped MPs (0.01-0.63 in NaCl and 0.02-0.46 in CaCl2, and 0.01-0.59 in NaCl and 0.02-0.40 in CaCl2, respectively). Conversely, the ECM could interpret the alpha behavior of pear- and peanut-shaped MPs either by changes in EBs or interaction minima as a function of orientation angles and electrolyte ionic strength. Therefore, the particle shape must be considered to improve the attachment analyses.

Microalgae have emerged as potential candidates for biomass production and pollutant removal. However, expensive biomass harvesting, insufficient biomass productivity, and low energy intensity limit the large-scale production of microalgae. To break through these bottlenecks, a novel technology of immobilized microalgae culture coupled with wastewater treatment has received increasing attention in recent years. In this review, the characteristics of two immobilized microalgae culture technologies are first presented and then their mechanisms are discussed in terms of biofilm formation theories, including thermodynamic theory, Derjaguin-Landau-Verwei-Overbeek theory (DLVO) and its extended theory (xDLVO), as well as ionic cross-linking mechanisms in the process of microalgae encapsulated in alginate. The main factors (algal strains, carriers, and culture conditions) affecting the growth of microalgae are also discussed. It is also summarized that immobilized microalgae show considerable potential for nitrogen and phosphorus removal, heavy metal removal, pesticide and antibiotic removal in wastewater treatment. The role of bacteria in the cultivation of microalgae by immobilization techniques and their application in wastewater treatment are clarified. This is economically feasible and technically superior. The problems and challenges faced by immobilized microalgae are finally presented.

Biofouling limits applications of membrane technology in wastewater treatment, but dosing additives to membrane tanks is an effective method to alleviate biofouling. In this study, biochar derived from corncob and pyrolyzed at 300, 500, and 700°C was dosed to determine the underlying anti-biofouling mechanism. The effects of the biochar on the membrane properties and foulant behavior were systematically investigated. The results showed that biochar delayed the occurrence of the fouling transition (0.5-3.0 h), and decreased the flux decline rate, thus achieving a higher water flux (3.1-3.7 times of the control group). Biochar altered membrane surface properties, and increased the membrane surface charge, roughness, and hydrophilicity, which all contributed to higher membrane permeability. Moreover, adding biochar reduced the number of foulants in the fouling layer, particularly protein substances. The flux model fit and the XDLVO theory further revealed the mitigating effect of biochar on membrane biofouling. At the initial intermediate-blocking stage, the effect of biochar on membrane fouling was determined by its properties, and adsorption capacity to the foulants, BC500 presented the best mitigation performance. At the later cake-filtration stage, the role of biochar in membrane fouling was strongly associated with protein content in the fouling layer, and the minimum rate of flux decline occurred in BC300. This study promotes the understanding and development of biochar to alleviate membrane biofouling.

While pioneering methods have demonstrated that bacterial N-acyl homoserine lactone (AHL) signaling molecules can influence the growth and self-aggregation of suspended microalgae, whether AHLs can affect the initial adhesion to a carrier has remained an open question. Here we revealed that the microalgae exhibited different adhesion potential under AHL mediation, where the performance was affiliated to both AHL types and concentrations. The result can be well explained by the interaction energy theory, where the energy barrier between the carriers and the cells varied due to AHL mediation. Depth analyses revealed that AHL acted through modifying the properties of the surface electron donor of the cells, which were dependent upon three major components, i.e., extracellular protein (PN) secretion, the PN secondary structure, and the PN amino acid composition. These findings expand the known diversity of AHLs mediation on microalgal initial adhesion and metabolisms, which may interface with other major cycles and become helpful to theoretically guide the application of AHLs in microalgal culture and harvesting.

The co-occurrence of microplastics (MPs) and organic contaminants in aquatic environment can complexify their environmental fate via sorption interactions, especially when the properties of MPs can even vary due to the aging effect. Thus, quantitatively clarifying the sorption mechanisms is required to understand their environmental impacts. This study selected popularly occurring carbamazepine (CBZ) and four types of MPs as model systems, including polyethylene, polyvinyl chloride, polyethylene terephthalate and polystyrene in their pristine and aged forms, to investigate the sorption isotherms, kinetics, and desorption. The variation of MPs during the aging process were analyzed with scanning electron microscopy, contact angle, Fourier transform infrared spectroscopy, and X-ray photoelectron spectroscopy. It was found that the aging process elevated the sorption capacity and intensified the desorption hysteresis of CBZ on MPs via increasing the surface roughness, decreasing the particle size, and altering the surficial chemistry of all MPs. The extended Derjaguin-Landau-Verwey-Overbeek (XDLVO) theory was innovatively applied hereby to calculate the interfacial free energies and revealed that the hydrophobic interaction was significantly lessened after aging for all MPs with the slightly enhanced van der Waals interaction. Then the total interfacial free energies were dropped down for all MPs, which resulted in their declined specific sorption capacity. This work reveals the sorption mechanisms of CBZ on pristine and aged MPs with XDLVO and provides a useful reference to study the sorption of other neutral organics onto MPs.

Membrane fouling and the trade-off between membrane permeability and selectivity restrict the potential applications of membrane filtration for water treatment. ZIF-8 was found having great permeability and antibiofouling performance, but with issue on particle aggregation makes it difficult to achieve high ZIFs loading and fabricate a defect-free molecular sieving membrane in previous research. In this study, we formed a scalable antibiofouling surface with improved permeability and fouling resistance on a PEI-ZIF-PAA membrane using a layer-by-layer assembly technique. The synergistic effects of being sandwiched between two different polyelectrolyte layers with opposite charges endowed the ZIF nanoparticles with improved stability and scalability for membrane modification. The PEI-ZIF-PAA membrane exhibited a satisfactory water flux of 120.78 LMH, which was 46.97% higher than that of the pristine PES membrane. The normalized water flux loss was serious in the absence of ZIF-8, and the flux increased with the ZIF-8 concentration. Antifouling tests suggested that the PEI-ZIF-PAA membrane possessed good antifouling performance due to the much higher surface hydrophilicity and positive Lewis acid-base interactions with foulants. The HA rejection increased with the ZIF-8 concentration and reached a maximum of 92.1% in the presence of 1.00% (w/v) ZIF-8. The membrane regeneration was tested under physical and chemical cleaning with flux recovery rates of about 85% and 95%. XDLVO analysis showed that the total interaction energy between HA and the PEI-ZIF-8-PAA membrane was 26.45 mJ/m2, and the superior antifouling performance was mainly attributed to Lewis acid-base interactions. This study indicates that ZIF-8 nanocrystals are promising materials for fabricating novel membranes for sewage treatment.

Wastewater treatment plants (WWTPs) are key components for the capture of microplastics (MPs) before they are released into natural waterways. Removal efficiencies as high as 99% may be achieved but sub-micron MPs as well as nanoplastics have been overlooked because of analytical limitations. Furthermore, short MP fibres are of concern because of their low capture rate as well as the lack of understanding of their influence on purification system efficiency. This study has investigated the impact of poly(ethylene terephthalate) (PET) short nanofibres on the performance of polyvinylidene fluoride (PVDF) ultrafiltration membranes during cross-flow operation. Model MP fibres with an average length of 10 ± 7 μm and a diameter of 142 ± 40 nm were prepared via a combination of electrospinning and fine cutting using a cryomicrotome. The manufactured MPs were added to both pure and synthetic domestic wastewater at a concentration of 1 mg.L-1 to determine their impact on the performance of PVDF ultrafiltration membranes. The results show that PET fibres attach to the membrane in a disorganised manner with low pore coverage. The water flux was decreased by 8% for MPs in pure water and no noticeable effect in wastewater after 3 days of filtration. Additionally, the nutrient removal efficiency of the membrane was not altered by the presence of PET MPs. These findings show that MP fibres do not significantly influence the early stages of filtration for a standard concentration of MPs in wastewater treatment plant studies.

Microbial reduction of ferrihydrite is prevalent in natural environments and plays an important role in reductive dissolution of Fe(III) minerals. With consistent release of anthropogenic graphene oxide (GO) into water bodies, new changes in the Fe(III)-reducing microorganisms/ferrihydrite binary system demand attention. Herein, we focused on the interaction of GO and bacterial cells in view of colloidal stability and interfacial forces, and on the consequences for microbial ferrihydrite reduction. The results showed that the addition of GO decreased the bioreduction efficiency of ferrihydrite down to 1/15 of the control. Meanwhile, the GO nanosheets were found not depositing on ferrihydrite but spontaneously aggregating with Shewanella spp., the representative dissimilatory Fe(III) reduction bacterial species. Using the extended Derjaguin-Landau-Verwey-Overbeek (XDLVO) theory and atomic force microscopy (AFM), the aggregation process can be interpreted in three steps according to the interaction energy calculation, namely, colloidal instability, reversible aggregation and irreversible aggregation. The motility of living cells seems the reason inducing the colloidal instability between GO and bacteria. While, the aggregation remains reversible even the secondary minimum achieved at the separation distance of 8.74-9.24 nm from XDLVO. When the separation distance <5.74-6.01 nm, the adhesion work predominates and causes irreversible aggregation, validated by AFM. Additionally, the probable ecological risks raised by this aggregation behavior for the imbalance of iron biogeochemical cycle were demonstrated.

The interfacial interaction between pollutants and organisms is a critical process in controlling the environmental fates of pollutants; however, in situ assay of the interaction is still a great challenge. Here, in situ determination of dissociation constants (Kd) for ZnO nanoparticles (ZnO NPs) from live algal cells disturbed by different-charged surfactants was established using microscale thermophoresis (MST). Moreover, in situ measurement of the adhesion force between the ZnO NPs probe and live single cell was performed using an atomic force microscope (AFM). Results showed that the cationic cetyltrimethylammonium chloride (CTAC) and anionic sodium dodecylbenzenesulfonate (SDBS) increased but nonionic Triton X-100 (TX-100) decreased the adhesion of ZnO NPs on cells. However, the force signature exhibited a smooth single retracted peak at short distances in the SDBS- and TX-100-treated groups, distinguished from the \"see-saw\" pattern peak in the CTAC-treated groups. The extended Derjaguin-Landau-Verway-Overbeek (XDLVO) calculation further confirmed that SDBS and TX-100 mainly disturbed the short-range hydration on the NP-cell interface, while CTAC reduced the long-range electrostatic repulsion. Furthermore, an excellent linear correlation between Zn bioaccumulation and two parameters (Kd and adhesion force) indicated that NP-cell interfacial interactions affected Zn bioaccumulation. Thus, in situ assay provides a quantitative basis for the pollutant-organism interfacial interaction to evaluate the environmental fate and ecological risk of pollutants.