Nanomaterial-mediated antibacterial photodynamic therapy (aPDT) emerges as a promising treatment against antibiotic-resistant bacterial biofilms. Specifically, titanium dioxide nanoparticles (TiO2 NPs) are being investigated as photosensitizers in aPDT to address biofilm related diseases. To enhance their photocatalytic performance in the visible spectral range for biomedical applications, various strategies have been adopted, including reduction of TiO2 NPs. However, despite improvements in visible-light photoactivity, reduced TiO2 NPs have yet to reach their expected performance primarily due to the instability of oxygen vacancies and their tendency to reoxidize easily. To address this, we present a two-step approach to fabricate highly visible-light active and stable TiO2 NP photocatalysts, involving nitrogen doping followed by a magnesium-assisted reductive annealing process. X-ray photoelectron spectroscopy analysis of the synthesized reduced nitrogen-doped TiO2 NPs (H:Mg-N-TiO2 NPs) reveals that the presence of nitrogen stabilizes oxygen vacancies and reduced Ti species, leading to increased production of reactive oxygen species under visible-light excitation. The improved aPDT efficiency translates to a 3-fold enhancement in the antibiofilm activity of nitrogen-doped compared to undoped reduced TiO2 NPs against both Gram-positive (Streptococcus mutans) and Gram-negative (Porphyromonas gingivalis, Fusobacterium nucleatum) oral pathogens. These results underscore the potential of H:Mg-N-TiO2 NPs in aPDT for combating bacterial biofilms effectively.

Fabricating highly efficient and robust oxygen reduction reaction (ORR) electrocatalysts is challenging but desirable for practical Zn-air batteries. As an early transition-metal oxide, zirconium dioxide (ZrO2) has emerged as an interesting catalyst owing to its unique characteristics of high stability, anti-toxicity, good catalytic activity, and small oxygen adsorption enthalpies. However, its intrinsically poor electrical conductivity makes it difficult to serve as an ORR electrocatalyst. Herein, we report ultrafine N-doped ZrO2 nanoparticles embedded in an N-doped porous carbon matrix as an ORR electrocatalyst (N-ZrO2/NC). The N-ZrO2/NC catalyst displays excellent activity and long-term durability with a half-wave potential (E1/2) of 0.84 V and a selectivity for the four-electron reduction of oxygen in 0.1 M KOH. Upon employment in a Zn-air battery, N-ZrO2/NC presented an intriguing power density of 185.9 mW cm-2 and a high specific capacity of 797.9 mA h gZn -1, exceeding those of commercial Pt/C (122.1 mW cm-2 and 782.5 mA h gZn -1). This excellent performance is mainly attributed to the ultrafine ZrO2 nanoparticles, the conductive carbon substrate, and the modified electronic band structure of ZrO2 after N-doping. Density functional theory calculations demonstrated that N-doping can reduce the band-gap of ZrO2 from 3.96 eV to 3.33 eV through the hybridization of the p state of the N atom with the 2p state of the oxygen atom; this provides enhanced electrical conductivity and results in faster electron-transfer kinetics. This work provides a new approach for the design of other enhanced semiconductor and insulator materials.

Cyclo-meta-phenylenes doped with nitrogen atoms at the periphery were designed and synthesized. The syntheses of the macrocyclic structures were achieved with one-pot Suzuki-Miyaura coupling to arrange phenylene rings and pyridinylene rings in an alternating fashion. Analyses with UV-vis spectroscopy showed changes in the photophysical properties with nitrogen doping, and X-ray crystallographic analyses experimentally revealed the presence of biased charges on the peripheral nitrogen atoms.

In this study, the effect of defects on the acceptor properties of nitrogen-doped ZnO nanoparticles (NPs) was investigated through the fabrication of light-emitting diodes (LEDs). Nitrogen-doped ZnO NPs were synthesized by an arc discharge in-gas evaporation method and post-annealed at 800 °C in an oxygen and nitrogen atmosphere. The annealed ZnO NPs were characterized by X-ray diffraction, scanning electron microscopy, Raman spectroscopy, and photoluminescence spectroscopy. It was found that the annealing of nitrogen-doped ZnO NPs in a nitrogen environment increased the number of zinc vacancies, while annealing in an oxygen environment increased the number of oxygen vacancies due to nitrogen desorption. The output characteristics of LEDs fabricated with oxygen-annealed NPs were degraded, while those with nitrogen-annealed NPs were significantly improved. From these results, the contribution of zinc vacancies to acceptor formation in ZnO NPs was confirmed for the first time in actual pn junction devices.

Carbonization of biomass residues followed by activation has great potential to become a safe process for the production of various carbon materials for various applications. Demand for commercial use of biomass-based carbon materials is growing rapidly in advanced technologies, including in the energy sector, as catalysts, batteries and capacitor electrodes. In this study, carbon materials were synthesized from hardwood using two carbonization methods, followed by activation with H3PO4, KOH and NaOH and doping with nitrogen. Their chemical composition, porous structure, thermal stability and structural order of samples were studied. It was shown that, despite the differences, the synthesized carbon materials are active catalysts for oxygen reduction reactions. Among the investigated carbon materials, NaOH-activated samples exhibited the lowest Tafel slope values, of -90.6 and -88.0 mV dec-1, which are very close to the values of commercial Pt/C at -86.6 mV dec-1.

Although titanium dioxide (TiO2) has a wide range of potential applications, the photocatalytic performance of TiO2 is limited by both its limited photoresponse range and fast recombination of the photogenerated charge carriers. In this work, the preparation of nitrogen (N)-doped TiO2 accompanied by the introduction of oxygen vacancy (Vo) has been achieved via a facile annealing treatment with urea as the N source. During the annealing treatment, the presence of urea not only realizes the N-doping of TiO2 but also creates Vo in N-doped TiO2 (N-TiO2), which is also suitable for commercial TiO2 (P25). Unexpectedly, the annealing treatment-induced decrease in the specific surface area of N-TiO2 is inhibited by the N-doping and, thus, more active sites are maintained. Therefore, both the N-doping and formation of Vo as well as the increased active sites contribute to the excellent photocatalytic performance of N-TiO2 under visible light irradiation. Our work offers a facile strategy for the preparation of N-TiO2 with Vo via the annealing treatment with urea.

Every late autumn, fluttering poplar leaves scatter throughout the campus and city streets. In this work, poplar leaves were used as the raw material, while H3PO4 and KOH were used as activators and urea was used as the nitrogen source to prepare biomass based-activated carbons (ACs) to capture CO2. The pore structures, functional groups and morphology, and desorption performance of the prepared ACs were characterized; the CO2 adsorption, regeneration, and kinetics were also evaluated. The results showed that H3PO4 and urea obviously promoted the development of pore structures and pyrrole nitrogen (N-5), while KOH and urea were more conductive to the formation of hydroxyl (-OH) and ether (C-O) functional groups. At optimal operating conditions, the CO2 adsorption capacity of H3PO4- and KOH-activated poplar leaves after urea treatment reached 4.07 and 3.85 mmol/g, respectively, at room temperature; both showed stable regenerative behaviour after ten adsorption-desorption cycles.

Low-range light absorption and rapid recombination of photo-generated charge carriers have prevented the occurrence of effective and applicable photocatalysis for decades. Quantum dots (QDs) offer a solution due to their size-controlled photon properties and charge separation capabilities. Herein, well-dispersed interstitial nitrogen-doped TiO2 QDs with stable oxygen vacancies (N-TiO2-x-VO) are fabricated by using a low-temperature, annealing-assisted hydrothermal method. Remarkably, electrostatic repulsion prevented aggregation arising from negative charges accumulated in situ on the surface of N-TiO2-x-VO, enabling complete solar spectrum utilization (200-800 nm) with a 2.5 eV bandgap. Enhanced UV-vis photocatalytic H2 evolution rate (HER) reached 2757 µmol g-1 h-1, 41.6 times higher than commercial TiO2 (66 µmol g-1 h-1). Strikingly, under visible light, HER rate was 189 µmol g-1 h-1. Experimental and simulated studies of mechanisms reveal that VO can serve as an electron reservoir of photo-generated charge carriers on N-doped active sites, and consequently, enhance the separation rate of exciton pairs. Moreover, the negative free energy (-0.35 V) indicates more favorable thermodynamics for HER as compared with bulk TiO2 (0.66 V). This research work paves a new way of developing efficient photocatalytic strategies of HER that are applicable in the sustainable carbon-zero energy supply.

The increasing presence of microbial and emerging organic contaminants pose detrimental effects on the environment and ecosystem such as diseases, pandemics and toxicity. Most of these synthetic pollutants are biorecalcitrant and therefore persist in the environment. Conventional water treatment methods are not effective thereby necessitating the development of advanced techniques such as photocatalysis and membrane processes. In this study, visible light-driven photocatalytic membrane was synthesized through the immobilization of nitrogen-doped nanoparticles onto the polyvinylidene fluoride (PVDF) membrane and performance evaluated with E.coli microbial contaminant removal. Characterization was done using Fourier transform infrared spectra, X-ray diffraction (XRD), water contact angle, Scanning Electron Microscopy-Energy Dispersive X-ray (SEM-EDX). The Nitrogen-doping of titanium dioxide red-shifted the light absorption to a visible range of 440 nm from 400 nm. Nitrogen dopant was detected at 1420 cm-1and 1170 cm-1 for nitrogen doped nanoparticles and 1346-1417 cm-1 for nitrogen doped titanium dioxide PVDF membrane. SEM-EDX confirmed presences of nitrogen in nitrogen doped titanium dioxide nanoparticles on membrane surface with nitrogen elemental composition of 0.01 % wt. The water contact angle reduced by 81.39o from 120.14o to 38.75o because of PVA immobilization of nitrogen-doped titanium dioxide and glutaraldehyde crosslinking. Nitrogen doping resulted in visible light active photocatalytic membranes with better hydrophilicity and fouling resistance. 8.42 E.coli log removal and a relative flux of 0.35 was obtained within 75 min. The developed photocatalytic membrane enables the use of sunlight hence a less costly method for decontamination of wastewater.

New binary carbon composites (GDY-NCNTs and GDY-CNTs) with a three-dimensional porous structure, which are synthesized by an in situ growth method, are adopted in this article. The GDY-NCNTs composites exhibit excellent specific capacitance performance (679 F g-1, 2 mV s-1, 139% increase compared to GDY-CNTs) and good cycling stability (with a capacity retention rate of up to 116% after 10000 cycles). The three-dimensional porous structure not only promotes ion transfer and increases the effective specific surface area to improve its specific capacitance performance but also adapts to the volume expansion and contraction during the charging and discharging process to improve its cycling stability. The presence of nitrogen doping in the carbon nanotubes of GDY-NCNTs increases the surface defects of the composites, provides more electrochemical points, and improves the surface wettability of the composites, further improving the electrochemical performance of the composites.