Recycling electronic waste (e-waste) poses risks of metal exposure, potentially leading to health impairments. However, no previous study has focused on this issue in Hong Kong. Therefore, from June 2021 to September 2022, this study collected urine samples from 101 e-waste workers and 100 office workers in Hong Kong to compare their urinary levels of metals using ICP-MS. Among the 15 included metals (with detection rates above the 70 % threshold), eight showed significantly higher urinary concentrations (unit: μg/g creatinine) in e-waste workers compared to office workers: Li (25.09 vs. 33.36), Mn (1.78 vs. 4.15), Ni (2.10 vs. 2.77), Cu (5.81 vs. 9.23), Zn (404.35 vs. 431.52), Sr (151.33 vs. 186.26), Tl (0.35 vs. 0.43), and Pb (0.69 vs. 1.16). E-waste workers in Hong Kong generally exhibited lower metal levels than those in developing regions but higher than their counterparts in developed areas. The urine level of 8-hydroxy-2-deoxyguanosine (8-OHdG) was determined by HPLC-MS/MS, and no significant difference was found between the two groups. Multiple linear regression models revealed no significant association between individual metal and urinary 8-OHdG concentrations. However, the metal mixture was identified to marginally elevate the 8-OHdG concentrations (1.12, 95 %CI: 0.04, 2.19) by quantile g‑computation models, with Mn and Cd playing significant roles in such effect. In conclusion, while the metal levels among Hong Kong e-waste workers compared favorably with their counterparts in other regions, their levels were higher than those of local office workers. This underscores the need for policymakers to prioritize attention to this unique industry.

Mismanagement of hazardous waste (HW) causes severe threats to ecosystems and human health. We conducted a systematic literature review and evaluated the evidence regarding the association between residential exposure to HW and childhood neurobehavioral effects. We consulted international agencies websites and conducted a search on MEDLINE and EMBASE databases by applying a \"Population-Exposure-Comparator-Outcome\" question. The evidence evaluation, based on the quality of the studies and their concordance, was graded in sufficient/limited/inadequate. Documents from international agencies were not found. Of the seventy-five studies screened, nine met the eligibility criteria. Studies agree on the association between residential exposure to HW sites and negative neurodevelopmental effects. The evidence of the association was attributed limited to cognitive and behavioral outcomes, and inadequate to Autism Spectrum Disorder. The evidence was evaluated sufficient for HW sites releasing lead and cognitive disorders. Residential exposure to unsafe HW sites may contribute to childhood neurobehavioral alterations. It is urgent to implement environmental remediation of contaminated sites and counteracting illegal and unsafe HW management practices.

As robot numbers in the home increase, creating a market for second-hand robotic systems is essential to reduce the waste impact of the industry. Via a survey, consumer attitudes of United Kingdom participants towards second-hand robots were investigated; finding that second-hand robots with guarantees have an equal purchasing interest compared to new systems, highlighting the opportunity for manufacturers and retailers to develop certification standards for second-hand robots to move towards a circular economy. Consumer demographics also demonstrated that those most open to the purchase of both new and second-hand systems were women, those aged 18-25 years old, and those who have previously owned a robot for the home. Participants\' prior ownership of second-hand electronic devices (such as phones and laptops) did not affect rates of interest for second-hand robotic systems suggesting that the technology is still too new for people to be able to project their experience of current second-hand electronics to that of a robot. Additionally, this research found the robotics industry can consider the potential market for second-hand robots to be more similar to the second-hand smartphone market than to the household electronics market, and lessons learnt from the concerns raised by consumers for other internet-enabled electronic devices are similar to those concerns for second-hand robots. This provides an opportunity for the industry to break down the barriers for a circular economy earlier in the technology maturity process than has been seen for other electronics.

Electronic waste (e-waste) and diabetes are global challenges to modern societies. However, solving these two challenges together has been challenging until now. Herein, we propose a laser-induced transfer method to fabricate portable glucose sensors by recycling copper from e-waste. We bring up a laser-induced full-automatic fabrication method for synthesizing continuous heterogeneous CuxO (h-CuxO) nano-skeletons electrode for glucose sensing, offering rapid (< 1 min), clean, air-compatible, and continuous fabrication, applicable to a wide range of Cu-containing substrates. Leveraging this approach, h-CuxO nano-skeletons, with an inner core predominantly composed of Cu2O with lower oxygen content, juxtaposed with an outer layer rich in amorphous CuxO (a-CuxO) with higher oxygen content, are derived from discarded printed circuit boards. When employed in glucose detection, the h-CuxO nano-skeletons undergo a structural evolution process, transitioning into rigid Cu2O@CuO nano-skeletons prompted by electrochemical activation. This transformation yields exceptional glucose-sensing performance (sensitivity: 9.893 mA mM-1 cm-2; detection limit: 0.34 μM), outperforming most previously reported glucose sensors. Density functional theory analysis elucidates that the heterogeneous structure facilitates gluconolactone desorption. This glucose detection device has also been downsized to optimize its scalability and portability for convenient integration into people\'s everyday lives.

Electronic waste (e-waste) has been identified as an emerging pollutant and is the fastest growing waste stream at the present time. Significant technological development and modernization within the last decade has led to the rapid accumulation of outdated, broken and unwanted electrical and electronic equipment (EEE). Electronic products mainly consist of a range of metal containing components that, when disposed of improperly, could result in metal constituents leached into the environment and posing a health risk to humans and animals alike. Metal exposure can induce oxidative stress in organisms, which could lead to synergistic, antagonistic and additive effects. The metals found highest in abundance in the simulated e-waste leachate, were nickel (Ni), barium (Ba), zinc (Zn), lithium (Li), iron (Fe), aluminium (Al) and copper (Cu). An acute exposure study was conducted over a 96 h period to determine the potential toxicity of e-waste on the test organism Danio rerio. Biomarker analysis results to assess the biochemical and physiological effects induced by e-waste leachate, showed a statistically significant effect induced on acetylcholinesterase activity, superoxide dismutase, catalase activity, reduced glutathione content, glutathione s-transferase, malondialdehyde and glucose energy available. The Integrated Biomarker Response (IBRv2) analysis revealed a greater biomarker response induced as the exposure concentration of e-waste leachate increased.

A growing amount of waste electrical and electronic equipment (WEEE) indicates the need to verify the effectiveness of its management both nationally and globally. An analysis of the WEEE economy in Poland conducted over 5 years confirmed a 16.64% increase in the mass of collected equipment. The maximum annual mass of electrical and electronic equipment introduced to the market during this period was 607,240 Mg, with the average value exceeding 500,000 Mg. The WEEE category with the largest collected mass was waste code 20 01 36, which exceeded 235,000 Mg, whilst the highest waste weight accumulation rate of 45.98 kg per capita was recorded in one of the smallest voivodeships in Poland. This result showed the diversity of WEEE accumulation on a national scale. Overall, a noticeable increase in the WEEE accumulation rate has occurred as Poland\'s gross domestic product has increased, despite a decreasing population. An analysis based on the waste accumulation indicators, including socioeconomic factors, confirmed the need to develop forms of WEEE recovery and recycling to transition to a circular economy and promote the synergy of activities amongst all players in WEEE management.

The present study focused on to determine the concentration and health risk of heavy metals (Cu, Pb, Zn, Cd, Hg, Cr) in e-waste contaminated soils collected from different provinces of Pakistan. Further, the impact of heavy metals on soil enzyme activities and microbial community was also investigated. The concentration (mg/kg) of Hg, Zn, Fe, Cu, Pb, Cd, and Cr ranged between 0-0.258, 2.284-6.587, 3.005-40.72, 8.67-36.88, 12.05-35.03, 1.03-2.43, and 33.13-60.05, respectively. The results revealed that Lahore site of Punjab province indicated more concentration of heavy metals as compared to other sites. The level of Cr at all sites whereas Hg at only two sites exceeds the World Health Organization standards (WHO) for soil. Soil enzyme activity exhibited dynamic trend among the sites. Maximum enzyme activity was observed for urease followed by phosphatase and catalase. Contamination factor (Cf), Pollution load index (PLI), and geo-accumulation index (Igeo) results showed that all the sites are highly contaminated with Cu, Cd, and Pb. Hazard index (HI) was less than 1 for children and adults suggesting non-carcinogenic health risk. Principle component analysis results depicted relation among Cr, Fr, catalase, and actinomycetes; Cd, OM, urease, and bacteria, and Pb, Cu, Zn, Hg, and phosphatase, suggesting soil enzymes and microbial community profiles were influenced by e-waste pollution. Therefore, there is a dire need to introduce sustainable e-waste recycling techniques as well as to make stringent e-waste management policies to reduce further environmental contamination.

BACKGROUND: Childhood exposure to polycyclic aromatic hydrocarbons (PAHs) or lead (Pb) is associated with epigenetic modifications. However, the effects of their co-exposures on IGF1 (Insulin-like growth factor 1) methylation and the potential role in child physical growth are unclear.
METHODS: From our previous children study (N = 238, ages of 3-6), 75 children with higher total concentrations of urinary ten hydroxyl PAH metabolites (∑10OH-PAHs) from an e-waste recycling area, Guiyu, and 75 with lower ∑10OH-PAHs from Haojiang (reference area) were included. Pb and IGF1 P2 promoter methylation in peripheral blood were also measured. Multivariable linear regression analyses were performed to estimate individual associations, overall effects and interactions of co-exposure to OH-PAHs and Pb on IGF1 methylation were further explored using Bayesian kernel machine regression.
RESULTS: Methylation of IGF1 (CG-232) was lower (38.00 vs. 39.74 %, P < 0.001), but of CG-207 and CG-137 were higher (59.94 vs. 58.41 %; 57.60 vs. 56.28 %, both P < 0.05) in exposed children than the reference. The elevated urinary 2-OHPhe was associated with reduced methylation of CG-232 (B = -0.051, 95 % CI: -0.096, -0.005, P < 0.05), whereas blood Pb was positively associated with methylation of CG-108 (B = 0.106, 95 %CI: 0.013, 0.199, P < 0.05), even after full adjustment. Methylations of CG-224 and 218 significantly decreased when all OH-PAHs and Pb mixtures were set at 35th - 40th and 45th - 55th percentile compared to when all fixed at 50th percentile. There were bivariate interactions of co-exposure to the mixtures on methylations of CG-232, 224, 218, and 108. Methylations correlated with height, weight, were observed in the exposed children.
CONCLUSIONS: Childhood co-exposure to high PAHs and Pb from the e-waste may be associated with IGF1 promoter methylation alterations in peripheral blood. This, in turn, may interrupt the physical growth of preschool children.

Polybrominated diphenyl ethers (PBDEs) and their substitutes, novel brominated flame retardants (NBFRs), are ubiquitously present in the aquatic environment of electronic waste (e-waste) dismantling region, leading to their inevitable absorption and accumulation by aquatic organisms, which can be transferred to human via directly aquatic product consumption or through food chain, thereby posing potential health risks. This study focused on fish samples from Guiyu and its surrounding areas, and found the total PBDEs concentrations were 24-7400 ng/g lw (mean: 1800 ng/g lw) and the total NBFRs concentrations were 14 to 2300 ng/g lw (mean: 310 ng/g lw). Significant positive correlations were found among PBDE congeners, among different NBFRs, and between NBFRs and commercial PBDEs that they replace. ΣPBDEs and ΣNBFRs in the intestine were 620-350,000 and 91-81,000 ng/g lw (mean: 83000 and 12,000 ng/g lw, respectively), significantly exceeding those in the gills, where ΣPBDEs and ΣNBFRs were 14-37,000 and 39-45,000 ng/g lw (mean: 9200 and 2400 ng/g lw, respectively). The ΣPBDEs and ΣNBFRs showed no non-carcinogenic risks to the target population through dietary intake. Despite the significantly higher daily intake of decabromodiphenyl ethane (DBDPE) compared to decabromodiphenyl ether (BDE209), the non-carcinogenic risk associated with BDE209 remained higher than that of DBDPE. Our findings can assist researchers in understanding the presence of BFRs in aquatic organisms, inhabiting e-waste dismantling areas, and in evaluating the associated health risks posed to humans through dietary exposure.

Rhodococcus erythropolis bacterium is known for its remarkable resistance characteristics that can be useful in several biotechnological processes, such as bioremediation. However, there is scarce knowledge concerning the behavior of this strain against different metals. This study sought to investigate the behavior of R. erythropolis ATCC 4277 against the residue of chalcopyrite and e-waste to verify both resistive capacities to the metals present in these residues and their potential use for biomining processes. These tests were carried out in a stirred tank bioreactor for 48 h, at 24ºC, pH 7.0, using a total volume of 2.0 L containing 2.5% (v/v) of a bacterial pre-culture. The pulp density of chalcopyrite was 5% (w/w), and agitation and oxygen flow rates were set to 250 rpm and 1.5 LO2 min-1, respectively. On the other hand, we utilized a waste of computer printed circuit board (WPCB) with a pulp density of 10% (w/w), agitation at 400 rpm, and an oxygen flow rate of 3.0 LO2 min-1. Metal concentration analyses post-fermentation showed that R. erythropolis ATCC 4277 was able to leach about 38% of the Cu present in the chalcopyrite residue (in ~ 24 h), and 49.5% of Fe, 42.3% of Ni, 27.4% of Al, and 15% Cu present in WPCB (in ~ 24 h). In addition, the strain survived well in the environment containing such metals, demonstrating the potential of using this bacterium for waste biomining processes as well as in other processes with these metals.