Aim This study aimed to explore the morphology and complexity of mandibular anterior teeth in a Western Saudi Arabian sub-population using cone beam computed tomography (CBCT). Methodology CBCT scans from 818 patients were evaluated, and 3193 mandibular anterior teeth were analyzed for the number of roots, canal, canal configurations, separation level, bilateral symmetry, and gender associations. Results The results showed that all examined central and lateral incisors had a single root, and the majority exhibited a single canal. The prevalence of two canals in mandibular central and lateral incisors was 20.1% and 23.2%, respectively, resulting in an overall prevalence of 21.7% for two root canals in mandibular anterior teeth. The separation level of the two canals was predominantly located in the middle third of the root. Type I canal configuration was the most common, followed by type III. A high degree of bilateral symmetry in the number of canals and canal configurations was noted. Conclusion The findings contribute to the understanding of root canal anatomy in the Saudi population and provide valuable information for endodontic treatment planning.

In recent years, cone-beam computed tomography (CBCT) has been widely used to evaluate patients\' root canal anatomy due to its high resolution and noninvasive nature. As voxel size is one of the most important parameters affecting CBCT image quality, the current study evaluated the diagnostic potential of CBCT with 4 different voxel sizes in the detection of double root canal systems and accessory canals (ACs) in permanent mandibular incisors.
A total of 106 extracted mandibular permanent incisors were collected from the dental clinics, and then were scanned by using micro-CT with a voxel size of 9 μm. The teeth were then fixed in the tooth sockets of human dry mandibles and scanned by using a CBCT device with 4 different voxel sizes (300, 200, 250, and 125 μm). Four observers detected in blind the root canal morphology of the teeth according to the CBCT images, and the presence or absence of a double root canal system, and the presence or absence of ACs, were scored according to a 5-point scale, respectively. Receiver operating characteristic (ROC) analysis was performed, and DeLong test was used to compare the area under the curve (AUC) values and the micro-CT data was taken as a gold standard.
Among 106 sample teeth, 25 specimens with a double root canal system were identified by the micro-CT. ROC curve analysis of the data obtained by the four observers showed that in the detection of double root canal systems, the AUC values ranged from 0.765 to 0.889 for 300 μm voxel size, from 0.877 to 0.926 for 250 μm voxel size, from 0.893 to 0.967 for 200 μm voxel size, and from 0.914 to 0.967 for 125 μm voxel size (all p < 0.01). In general, we observed a trend that the AUC values, sensitivity, and specialty increased with the decrease in the voxel size, and significantly higher AUC values were detected in 125 μm voxel size images. In the detection of ACs, ROC curve analysis showed that among the four observers, the AUC values ranged from 0.554 to 0.639 for 300 μm voxel size, from 0.532 to 0.654 for 250 μm voxel size, from 0.567 to 0.626 for 200 μm voxel size, and from 0.638 to 0.678 for 125 μm voxel size. CBCT images at a voxel size of 125 μm had a weak diagnostic potential (AUC: 0.5-0.7, all p < 0.05) in the detection of AC, with a lower sensitivity ranging from 36.8 to 57.9% and a higher specialty ranging from 73.6 to 98.8%.
CBCT with 300 μm voxel size could only provide moderate diagnostic accuracy in the detection of a double canal system in mandibular incisors. CBCT with a voxel size of 125 μm exhibited high diagnostic value in the detection of double canal systems, while showing low but statistically significant value in the detection of ACs.

OBJECTIVE: This retrospective study aims to analyze the root canal morphology of permanent mandibular incisors and the bifurcating/merging sites of root canal systems in children aged 9-12 in a Chinese subpopulation.Design Cone-beam computed tomography scans of 976 healthy, untreated and fully developed mandibular incisors were collected. Root canal morphology was identified by Vertucci\'s classification. Combined three-dimensional reconstruction and visualization techniques were used to locate bifurcating/merging sites in root canals.
RESULTS: Vertucci I was the most common classification of mandibular central incisors (42.3%) while Vertucci III was most common in mandibular lateral incisors (37.9%). Females more frequently showed Vertucci I classification (49.5% central incisors and 36.7% lateral incisors) while Vertucci III was most common among males (44.5% central incisors and 41.0% lateral incisors). The difference in canal classification by sex was statistically significant (p < 0.05). 58.7% of Vertucci V canals bifurcated in the apical third (AT) in central incisors, while 69.5% bifurcated in the middle third (MT) in lateral incisors. Bifurcating and merging in AT (44.3%) was the most common style of Vertucci III canals in central incisors, while bifurcating in MT and merging in AT (53.8%) was the most common in lateral incisors.
CONCLUSIONS: The root canal morphology of mandibular incisors in children aged 9-12 was different from that reported in previous studies on adults, and closely related to sex. Males had significantly greater canal variability than females. Lateral incisors had greater canal variability than central incisors. The bifurcating/merging sites were closely related to tooth type.

Hypodontia is an inherited condition involving the absence of one to six teeth. The permanent dentition is the most frequently affected; however, it may also affect the primary dentition. A congenitally missing tooth (CMT) is the most common dental abnormality, with the missing mandibular second premolar, maxillary lateral incisor, maxillary second premolar, and mandibular central incisor accounting for 90% of CMT in hypodontia studies. The etiology of CMT has been attributed to environmental and genetic contributing factors, with the latter having a strong influence. It may occur in isolation or in association with syndromes. Congenitally missing mandibular incisor is more common in the Asian population and females. Depending on the number and location of missing teeth, hypodontia may be a considerable issue for the clinician since it may impact occlusal balance, mastication, speech, and esthetics and often requires a multidisciplinary approach. Missing mandibular incisors are of particular interest to orthodontists because of the possibility of mandibular retrognathism, the potential for the development of malocclusion, and difficulty in achieving a balanced occlusion. This case report describes the skeletal and dental features of a nonsyndromic familial occurrence of missing mandibular incisors in three generations. A comprehensive literature search was also performed to review the familial cases with missing mandibular incisors.
UNASSIGNED: Selvaraj M, Sennimalai K, Samrit VD, et al. A Rare Incidence of Nonsyndromic Mandibular Incisor Agenesis in a Three-generation Family: Case Report and Literature Review. Int J Clin Pediatr Dent 2023;16(2):388-395.

Lip bumper (LB) therapy is used as a treatment approach for mild to moderate crowding without extraction of teeth. Previous studies demonstrated that LB increases arch length through molar uprighting and lateral expansion. However, the effects of LB on mandibular incisors are inconclusive. The controversial results from different studies may be due to limitations including absence of a control group and/or use of 2D radiography. To address this issue, the current retrospective longitudinal CBCT study compared a rapid maxillary expansion (RME) group with no lower treatment [16 patients (9 females, 7 males); median age 8.86 years at T1 and 11.82 years at T2] and an RME + LB group [18 patients (13 females, 5 males); median age 9.46 years at T1 and 12.10 years at T2]. The CBCTs taken before and after phase 1 treatment were 3D superimposed based on the mandibular structure and were measured to determine the angular and linear changes of the mandibular incisors over the course of LB treatment. For comparisons between different timepoints within a group, a Wilcoxon matched-pairs signed rank test was used. For intergroup comparisons, a Mann-Whitney U test was used. Both groups showed eruption and protrusion of the mandibular incisors during the observation period, while there was no significant change in proclination of the lower incisors. When comparing the discrepancy of change between groups, there was no statistically significant difference detected. In summary, by utilizing a longitudinal 3D database, the current study demonstrated that the effect of LB on the position of the mandibular incisors is limited.

UNASSIGNED: Treatment of incisors\' agenesis is challenging that arouses orthodontists\' interests. The purpose of this study was to compare the craniofacial pattern of individuals with or without congenitally missing mandibular incisors.
UNASSIGNED: This retrospective study included patients receiving orthodontic consultation between 1999 and 2019 at the Orthodontic Division of the Dental Department of Taipei Medical University Hospital. Cephalometric measurements were obtained through manual tracing and by using computer software. A total of 31 measurements were obtained to evaluate skeletal, dental and soft tissues, and chin morphology. A multivariate analysis of covariance, analysis of covariance, and Scheffé\'s post hoc tests were used to analyze the differences among a group of patients with one congenitally missing mandibular incisor (M1), a group of patients with two congenitally missing mandibular incisors (M2), and the control group. Student\'s t-test was used to analyze the differences between the M1 or M2 group and the control group. Significance was set at P < 0.05.
UNASSIGNED: Significant differences were observed between the M and control groups in terms of lower incisor angulation and facial balance. Regarding chin morphology, significant differences were noted between the M and control groups and also among the M1, M2, and control groups.
UNASSIGNED: The lower incisors of the M group are more retroclined than those of the control group, resulting in retrusive lower lips. Facial balance varies between the M and control groups. Congenitally missing mandibular incisors affect chin morphology, making the chin button prominent.

Martins JNR et al. Influence of Demographic Factors on the Prevalence of a Second Root Canal in Mandibular Anterior Teeth - A Systematic Review and Meta-Analysis of Cross-Sectional Studies Using Cone Beam Computed Tomography. Arch Oral Biol. 2020 Aug;116:104,749. doi: 10.1016/j.archoralbio.2020.104749.
No funding was obtained for this research TYPE OF STUDY/DESIGN: Systematic review with meta-analysis.

This study aimed to compare the main root canal configurations of mandibular incisors (MI) in a Brazilian population using Vertucci and Ahmed et al. classifications. One hundred and sixty-five human permanent MI were scanned using a micro-CT. Two examiners classified the samples according to Vertucci and Ahmed et al. classification. Kappa coefficient was employed. The majority of MI had a single root canal (52.1%). Type III Vertucci and 1 MI1-2-1 Ahmed et al. was the most common 2-canal MI (20%). In the apical third, the presence of one, two and three canals was found in 81.8%, 15.2% and 3% respectively. In the cervical and middle thirds, one, two and three canals were found in 86%, 12.2% and 1.8% respectively. Ahmed et al. classification was able to classify the entire sample studied, whereas 11 teeth (6.66%) did not fit Vertucci\'s classification.

OBJECTIVE: The aim of this study was to analyze the morphologic features of alveolus in relatively healthy maxillary and mandibular incisors using cone-beam-computed tomography (CBCT).
METHODS: CBCT images of 318 patients were retrospectively acquired. Alveolar bone in incisive area was divided into: type 1 (thick), type 2 (relatively thick with mono-plate concavity), type 3 (thin with double-plate concavities), and type 4 (vulnerably thin). Alveolus prevalence and widths were analyzed statistically relative to age, gender, and molar relationship.
RESULTS: Prevalence of type 1 alveolus was 78.9% in maxillary central incisors, 15.1% in maxillary lateral incisors, 24.1% in mandibular central incisors, and 5.0% in mandibular lateral incisors. Type 2 alveolus was commonly observed in the maxillary lateral incisors (82.2%), mandibular central incisors (66.2%), and mandibular lateral incisors (87.9%). Prevalence of type 3 and 4 alveoli ranged from 0.0 to 9.4%. As for maxillary central incisors, type 1 was the widest both at the alveolar crest (7.77 ± 0.58 mm) and apical area (9.05 ± 1.86 mm), while type 3 had the lowest width at the apical region (4.08 ± 0.51 mm). Among maxillary central incisors, prevalence of type 1 tended to decrease with age. At all maxillary and mandibular incisor sites, alveolus widths were significantly thicker in males than in females. At maxillary lateral incisor and mandibular incisor sites, prevalence of alveolus type was significantly different among three molar relationships.
CONCLUSIONS: A 4-type classification system was suggested for alveolus morphology in incisive region. Identification of alveolus type might aid in the corresponding treatment.

This study aimed to evaluate the prevalence of internal symmetry (the number and morphology of root canals) in the mandibular incisors using cone beam computed tomography (CBCT). A total of 302 CBCT scans involving 1,208 mandibular incisors were evaluated using the Vertucci\'s classification regarding the number and configuration of root canals. The central mandibular incisors exhibited two root canals in 22.6% of patients and lateral incisors in 24.3% of patients. Most teeth (76.4%) had a type I configuration (a single root canal, 1-1), 21.7% had type II (2-1), 1.1% had type V (1-2), and 0.8% had type IV (2-2). Teeth with a type-III configuration (1-2-1) were not found. In total, 17.5% of patients had a symmetric appearance of the two-canalled central mandibular incisors and 20.5% had a bilateral appearance of the two-canal lateral incisors. Moreover, in 12.3% of the patients, all four incisors showed two root canals. The highest degree of symmetry was found in incisors that had one root canal (central incisors: 217 of 302, lateral incisors: 229 of 302), followed by type 2-1 incisors (central incisors 50, lateral incisors 58). The influence of sex and age on the prevalence of symmetries was not significant. Concluding, the internal anatomy of the mandibular incisors cannot not be sufficiently predicted from the root canal anatomy of the contralateral tooth. Thorough clinical and radiographic inspection of each tooth remains mandatory to address the internal anatomy of the mandibular incisors correctly.