Research indicates that COVID-19 has had adverse effects on the mental health of adolescents, exacerbating their negative psychological states. The purpose of this study is to investigate the impact of Physical Literacy (PL) on Negative Mental State caused by COVID-19 (NMSC) and identify potential factors related to NMSC and PL in Chinese adolescents. This cross-sectional study involved a total of 729 Chinese high school students with an average age of 16.2 ± 1.1 years. Participants\' demographic data, PL data, and NMSC data were collected. PL and NMSC were measured using the self-reported Portuguese Physical Literacy Assessment Questionnaire (PPLA-Q), the Stress and Anxiety to Viral Epidemics-6 (SAVE-6), and the Fear of COVID-19 Scale (FCV-19). Adolescents in the current study demonstrated higher levels of NMSC and lower PL, with average scores of 3.45 and 2.26, respectively (on a scale of 5). Through multiple linear regression analysis, Motivation (MO), Confidence (CO), Emotional Regulation (ER), and Physical Regulation (PR) were identified as factors influencing NMSC in adolescents. The study findings contribute to providing guidance for actions aimed at alleviating NMSC among adolescents.

The influence of n-octylammonium iodide (OAI, passive layer) on the types of phases formed in a (MACl)0.33FA0.99MA0.01Pb(I0.99Br0.01)3 perovskite film was studied using X-ray diffraction. Using UV spectrophotometric techniques, it was determined how varied OAI additive layer ratios affected the linear and nonlinear optical characteristics of glass substrates/FTO/compact TiO2/mesoporous TiO2/(MACl)0.33FA0.99MA0.01Pb(I0.99Br0.01)3 films. All films\' direct optical bandgap energies were determined to be 1.54 eV. The effects of OAI addition on the films\' photoluminescence intensity and emitted colors were also investigated. For the fabricated perovskite solar cells (PSCs) without an OAI passivation layer, the corresponding power conversion efficiency (PCE), open-circuit voltage (VOC), short-circuit current density (JSC), and fill factor (FF) values were 18.8%, 1.02 V, 24.6 mAcm-2, and 75%, respectively. When the concentration of OAI reached 2 mg, the maximum obtained values of PCE, VOC, JSC, and FF were 20.2%, 1.06 V, 24.2 mAcm-2, and 79%, respectively. The decreased trap density and increased recombination resistance were responsible for the improvement in solar cell performance.

UNASSIGNED: To investigate the diversity and average values of bifurcation angles in a large population to help develop new methods.
UNASSIGNED: One thousand five individuals (504 females, 501 male) who visited the Cardiology Polyclinic of Fırat University Hospital with the complaint of chest pain between 2010 and 2015 were evaluated retrospectively. Bifurcation angle measurements between LMCA-CX, CX-LAD, LMCA-LAD, CX-OM1, CX-OM2, LAD-D1, LAD-D2, RCA-RMD, RCA-RVD and PDA-PL were evaluated in all cases.
UNASSIGNED: Bifurcation angles between LMCA-LAD, LMCA-Cx and LAD-Cx branches with \"> 90 wide angle bifurcations\", and Cx-OM1, Cx-OM2, LAD-D1, LAD-D2, RCA-RMD and PDA-PL with \"<70 Y type bifurcation angle\" were found to be high in male and female individuals. The RCA-RVD in female individuals was \"<70 Y-type bifurcation\" in 14 (2.8%) people, \"> 70-90 T-type bifurcation\" in 209 (41.5%) people, and \"> 90 wide angle bifurcation\" in 281 (55.8%) people. Results for male subjects were compatible with this. The correlations of all angles were examined. Robust positive correlations (p≤0.001) were found for the angular measurements between the main branches and the side branches (Cx-OM1, Cx-OM2, LAD-D1, LAD-D2 and RCA-RMD, PDA-PL).
UNASSIGNED: With the help of developing technology, we believe that all this coronary angiography data will guide bifurcation stent techniques, which are essential alternatives to bypass.

Introduction: Spectroscopic properties of Xeloda chemodrug have been studied over varying concentrations ranging between 0.001 and 10 mg/mL, using laser-induced fluorescence (LIF) spectroscopy. The alternative photoluminescence (PL) and near infrared (NIR) measurements are carried out to authenticate the obtained results by the LIF method. Methods: The XeCl laser as the excitation coherent source with 160 mJ/pulse at 308 nm is employed for LIF measurements of the fluorophore of interest in the modular spectroscopic set-up. Results: Xeloda as a significant chemodrug acts as a notable fluorophore. LIF, PL and NIR spectroscopy techniques are employed to investigate the spectral properties of the chemodrug in terms of concentration. The maximum LIF peak intensity of Xeloda is achieved at λmax=410.5 nm and the characteristic concentration of CP1=0.05 mg/mL. PL signals are in good agreement with the data given by the LIF measurements. The characteristic NIR spectra of Xeloda as solid evidence of chemical bonding formation attest to fluorescence quenching at the fluorophore concentration of ~ 0.2 mg/ mL. Besides, the spectral shift of fluorescence signals which is obtained in terms of fluorophore concentration- demonstrating as a diagnostic marker for the purpose of optimized chemotherapy. Conclusion: Xeloda exhibits outstanding fluorescence properties over the allowable concentration in human serum (Cmax). These characteristics could benefit potential advantage of simultaneous laser-based imaging of cell-chemodrug interaction over in-vivo studies.

This study presented an analysis of the TeO2/GeO2 molar ratio in an oxide glass system. A family of melt-quenched glasses with the range of 0-35 mol% of GeO2 has been characterized by using DSC, Raman, MIR, refractive index, PLE, PL spectra, and time-resolved spectral measurements. The increase in the content of germanium oxide caused an increase in the transition temperature but a decrease in the refractive index. The photoluminescence spectra of europium ions were examined under the excitation of 465 nm, corresponding to 7F0 → 5D2 transition. The PSB (phonon sidebands) analysis was carried out to determine the phonon energy of the glass hosts. It was reported that the red (5D0 → 7F2) to orange (5D0 → 7F1) fluorescence intensity ratio for Eu3+ ions decreased from 4.49 (Te0Ge) to 3.33 (Te15Ge) and showed a constant increase from 4.58 (Te20Ge) to 4.88 (Te35Ge). These optical features were explained in structural studies, especially changes in the coordination of [4]Ge to [6]Ge. The most extended lifetime was reported for the Eu3+ doped glass with the highest content of GeO2. This glass was successfully used for the drawing of optical fiber.

We have investigated the electrical and optical properties of Cd0.9Zn0.1Te:(In,Pb) wafers obtained from the tip, middle, and tail of the same ingot grown by modified vertical Bridgman method using I-V measurement, Hall measurement, IR Transmittance, IR Microscopy and Photoluminescence (PL) spectroscopy. I-V results show that the resistivity of the tip, middle, and tail wafers are 1.8 × 1010, 1.21 × 109, and 1.2 × 1010 Ω·cm, respectively, reflecting native deep level defects dominating in tip and tail wafers for high resistivity compared to the middle part. Hall measurement shows the conductivity type changes from n at the tip to p at the tail in the growth direction. IR Transmittance for tail, middle, and tip is about 58.3%, 55.5%, and 54.1%, respectively. IR microscopy shows the density of Te/inclusions at tip, middle, and tail are 1 × 103, 6 × 102 and 15 × 103/cm2 respectively. Photoluminescence (PL) spectra reflect that neutral acceptor exciton (A0,X) and neutral donor exciton (D0,X) of tip and tail wafers have high intensity corresponding to their high resistivity compared to the middle wafer, which has resistivity a little lower. These types of materials have a large number of applications in radiation detection.

Nanowire solar cells have the potential to reach the same efficiencies as the world-record III-V solar cells while using a fraction of the material. For solar energy harvesting, large-area nanowire solar cells have to be processed. In this work, we demonstrate the synthesis of epitaxial InP nanowire arrays on a 2 inch wafer. We define five array areas with different nanowire diameters on the same wafer. We use a photoluminescence mapper to characterize the sample optically and compare it to a homogeneously exposed reference wafer. Both steady-state and time-resolved photoluminescence maps are used to study the material\'s quality. From a mapping of reflectance spectra, we simultaneously extract the diameter and length of the nanowires over the full wafer. The extracted knowledge of large-scale nanowire synthesis will be crucial for the upscaling of nanowire-based solar cells, and the demonstrated wafer-scale characterization methods will be central for quality control during manufacturing.

Cd1-xZnxTe (0 ≤ x ≤ 0.1) ingots were obtained by Bridgman\'s method using two different speeds in order to find the optimal conditions for single-crystalline growth. Crystalline quality was studied by chemical etching, the elemental composition by wavelength dispersive spectroscopy (WDS), tellurium (Te) precipitates/inclusions concentration by differential scanning calorimetry (DSC), optical transmission by Fourier transformed infrared spectrometry (FTIR), and band gap energy (Egap) by photoluminescence (PL). It was observed that the ingots grown at a lower speed were those of the best crystalline quality, having at most three grains of different crystallographic orientation. The average dislocations density in all of them were similar and correspond to materials of good quality. EPMA results indicated that the homogeneity in the composition was excellent in the ingots central part. The concentration of Te precipitates/inclusions in all ingots was below the instrument (DSC) detection limit, 0.25% wt/wt. In the case of wafers from Cd0.96Zn0.04Te and Cd0.90Zn0.10Te ingots, the optical transmission was better than that of commercial materials and varied between 60% and 70%, while for pure CdTe, the transmission range was between 50% and 55%, the latter being decreased by the presence of Te precipitates/inclusions. The band gap energy Eg of different wafers was experimentally obtained by PL measurements at 76 K. We observed that Eg increased with the Zn concentration of the wafers, following a linear regression comparable to those proposed in the literature, and consistent with the results obtained with other techniques.

The development of an efficient method to patterning 2D MoS2 into a desired topographic structure is of particular importance to bridge the way towards the ultimate device. Herein, we demonstrate a patterning strategy by combining the electron beam lithography with the surface covalent functionalization. This strategy allows us to generate delicate MoS2 ribbon patterns with a minimum feature size of 2 μm in a high throughput rate. The patterned monolayer MoS2 domain consists of a spatially well-defined heterophase homojunction and alternately distributed surface characteristics, which holds great interest for further exploration of MoS2 based devices.

BACKGROUND: Polypodium leucotomos (PL) is a natural extract from tropical fern leaves with antioxidant and anti-inflammatory properties. It has been implicated as a potential treatment agent in multiple dermatologic conditions. OBJECTIVE: Here, we review the mechanism of action and current dermatologic applications of PL and extrapolate potential future dermatologic applications of PL. DESIGN: An extensive literature review on Pubmed was conducted in search of relevant background information and human studies utilizing PL for the treatment of dermatologic conditions. METHODS: Using the PubMed database, a literature search was conducted to identify relevant publications. \"Polypodium leucotomos\" was input as the key search criterion. The results were filtered by species (human) and language (English). Only papers with dermatologic applications were selected. Additionally, relevant publications found in the reference sections of selected articles were manually searched and selected. Included articles explore the origin, basic science mechanism, and various dermatologic applications of PL studied in humans. Each article was thoroughly studied by all authors and applicable data from each was used for the compilation of this review article. RESULTS: See Table 1 for a summary of dermatologic applications of PL based on available human clinical studies. LIMITATIONS: There was a limited number of human studies concerning the use of PL for treatment of dermatologic conditions and, of the available studies, many were of a small sample size. CONCLUSION: PL has a clinically significant role for the treatment and prevention of certain dermatologic conditions including: photoprotection, photocarcinogenesis, photoaging, vitiligo, melasma, and polymorphic light eruption. There is supporting evidence for its use in malignant melanoma high-risk patients, for enhanced actinic keratosis clearance following photodynamic therapy, and for symptomatic relief in atopic dermatitis. Potential clinical uses that require additional human clinical studies include solar urticaria, post-inflammatory hyperpigmentation, cutaneous lupus erythematosus, and other photosensitive cutaneous disorders.