This study examines the effects of limb dominance and lead limb in task initiation on the kinetics and kinematics of step-off drop landings. Nineteen male participants performed drop landings led by the dominant and non-dominant limbs at 45-cm and 60-cm drop heights. Ground reaction force (GRF) and lower body kinematic data were collected. Between-limb time differences at the initial ground contact were calculated to indicate temporal asymmetry. Statistical Parametric Mapping (SPM) was applied for waveform analysis while two-way repeated measures ANOVA was used for discrete parameters. SPM results revealed greater GRF and lesser ankle dorsiflexion in the lead limb compared to the trail limb in 3 out of 4 landing conditions. The dominant limb displayed a greater forefoot loading rate (45 cm: p=.009, ηp2 = 0.438; 60 cm: p=.035, ηp2 = 0.225) and greater ankle joint quasi-stiffness (45 cm: p < .001, ηp2 = 0.360; 60 cm: p < .001, ηp2 = 0.597) than the non-dominant limb. Not all 380 trials were lead-limb first landings, with a smaller between-limb time difference (p=.009, d = 0.60) at 60 cm (4.1 ± 2.3 ms) than 45 cm (5.6 ± 2.7 ms). In conclusion, the step-off drop landing is not an ideal protocol for examining bilateral asymmetry in lower limb biomechanics due to potential biases introduced by limb dominance and the step-off limb.

The development of floral organs, crucial for the establishment of floral symmetry and morphology in higher plants, is regulated by MADS-box genes. In sunflower, the capitulum is comprised of ray and disc florets with various floral organs. In the sunflower long petal mutant (lpm), the abnormal disc (ray-like) floret possesses prolongated petals and degenerated stamens, resulting in a transformation from zygomorphic to actinomorphic symmetry. In this study, we investigated the effect of MADS-box genes on floral organs, particularly on petals, using WT and lpm plants as materials. Based on our RNA-seq data, 29 MADS-box candidate genes were identified, and their roles on floral organ development, especially in petals, were explored, by analyzing the expression levels in various tissues in WT and lpm plants through RNA-sequencing and qPCR. The results suggested that HaMADS3, HaMADS7, and HaMADS8 could regulate petal development in sunflower. High levels of HaMADS3 that relieved the inhibition of cell proliferation, together with low levels of HaMADS7 and HaMADS8, promoted petal prolongation and maintained the morphology of ray florets. In contrast, low levels of HaMADS3 and high levels of HaMADS7 and HaMADS8 repressed petal extension and maintained the morphology of disc florets. Their coordination may contribute to the differentiation of disc and ray florets in sunflower and maintain the balance between attracting pollinators and producing offspring. Meanwhile, Pearson correlation analysis between petal length and expression levels of MADS-box genes further indicated their involvement in petal prolongation. Additionally, the analysis of cis-acting elements indicated that these three MADS-box genes may regulate petal development and floral symmetry establishment by regulating the expression activity of HaCYC2c. Our findings can provide some new understanding of the molecular regulatory network of petal development and floral morphology formation, as well as the differentiation of disc and ray florets in sunflower.

Unicystic ameloblastoma (UAM) of the jaw can be effectively reduced in volume through decompression, which promotes bone regeneration and restores jaw symmetry. This study quantitatively evaluated changes in mandible volume and symmetry following decompression of mandibular UAM. This study included 17 patients who underwent surgical decompression followed by second-stage curettage for mandibular UAM. Preoperative and postoperative three-dimensional computed tomography (CT) images were collected. Bone volume and the area of cortical perforation were measured to assess bone growth during decompression. Mandibular volumetric symmetry was analyzed by calculating the volumetric ratio of the two sides of the mandible. Twelve pairs of landmarks were identified on the surface of the lesion regions, and their coordinates were used to calculate the mean asymmetry index (AI) of the mandible. Paired t-tests and the Mann-Whitney U test were used for statistical analysis, with p < 0.05 considered indicative of statistical significance. The mean duration of decompression was 9.41 ± 3.28 months. The mean bone volume increased by 8.07 ± 2.41%, and cortical perforation recovery was 71.97 ± 14.99%. The volumetric symmetry of the mandible improved significantly (p < 0.05), and a statistically significant decrease in AI was observed (p < 0.05). In conclusion, UAM decompression enhances bone growth and symmetry recovery of the mandible. The present evaluation technique is clinically useful for quantitatively assessing mandibular asymmetry.

UNASSIGNED: This study aimed to investigate the symmetry of the Chinese pelvis.
UNASSIGNED: Computed tomography scan images of each of 50 Chinese pelvises were converted to 3D models and the left sides of the pelvises were reflected on Mimics software. Then, the reflected left side model was aligned with the right side using the closest point algorithm function of Geomagic software to perform symmetry analysis. The volume and surface area of either side of the pelvises were also calculated. The mean standard deviation (SD), the mean percentage of permissible deviations within the ±2 mm range, the percentage differences in volume and surface area were measured to compare pelvic symmetry. In addition, the distribution of pelvic bilateral symmetry associated with both age and sex were compared.
UNASSIGNED: The mean SD was 1.15 ± 0.16 mm and the mean percentage of permissible deviations was 90.82% ± 4.67%. The deviation color maps showed that the specific areas of asymmetry were primarily localized to major muscle or ligament attachment sites and the sacroiliac joint surfaces. There was no significant difference between the bilateral sides of the pelvis in either volume or surface area. Additionally, no difference in any indexes was exhibited in relation to sex and age distribution.
UNASSIGNED: Our results demonstrated that the pelvis has high bilateral symmetry, which confirmed the potential of using contralateral pelvic models to create fully patient-specific and custom-made pelvic implants applicable for the treatment of fracture and bony destruction.

Degeneracy and symmetry have a profound relation in quantum systems. Here, we report gate-tunable subband degeneracy in PbTe nanowires with a nearly symmetric cross-sectional shape. The degeneracy is revealed in electron transport by the absence of a quantized plateau. Utilizing a dual gate design, we can apply an electric field to lift the degeneracy, reflected as emergence of the plateau. This degeneracy and its tunable lifting were challenging to observe in previous nanowire experiments, possibly due to disorder. Numerical simulations can qualitatively capture our observation, shedding light on device parameters for future applications.

Bridgman once reflected on thermodynamics that the laws of thermodynamics were formulated in their present form by the great founders of thermodynamics, Kelvin and Clausius, before all the essential physical facts were in, and there has been no adequate reexamination of the fundamentals since. Thermodynamics still has unknown possibilities waiting to be explored. This paper begins with a brief review of Clausius\'s work on the second law of thermodynamics and a reassessment of the content of Clausius\'s statement. The review tells that what Clausius originally referred to as the second law of thermodynamics was, in fact, the theorem of equivalence of transformations (TET) in a reversible cycle. On this basis, a new symmetric form of Clausius\'s TET is proposed. This theorem says that the two transformations, i.e., the transformation of heat to work and the transformation of work from high pressure to low pressure, should be equivalent in a reversible work-to-heat cycle. New thermodynamic cyclic laws are developed on the basis of the cycle with two work reservoirs (two pressures), which enriches the fundamental of the second law of thermodynamics.

There are many methods to treat keloid, including various excision operations, laser, injection and radiotherapy. However, few studies have explored the effectiveness of single-hole punch excision in keloid treatment. This study aimed to investigate the efficacy and safety of lateral punch excision combined with intralesional steroid injection for keloid treatment through self-control trial. In this self-controlled trial, 50 patients meet the diagnosis of nodular keloid, and try to choose left-right symmetrical control, one skin lesion in the control group (50 skin lesionsin total) and the other in the observation group (50 skin lesions in total).The keloids in the treatment group were initially treated with punch excision combined with intralesional steroid injection, followed by injection treatment alone. Keloids in the control group received intralesional steroid injection alone. The Vancouver Scar Scale (VSS) of the keloid before and after the punch excision was evaluated; the keloid scores at different time points and the number of injection treatments required in both groups were compared, and adverse reactions were observed. The effective rate of the observation group was 86.0%, which was significantly higher than that of the control group (66.0%), and the recurrence rate of 22% was lower than that of the control group (χ2 = 4.141,63417), all of which were statistically significant (all P < 0.05). At the end of treatment, the VSS and total injection times in the observation group were significantly lower than those in the control group (t = 5.900,3.361), with statistical significance (P < 0.01). The combination of single-hole punch excision and intralesional steroid injection is an effective method to treat multiple nodular keloids, shortening the treatment course of tralesional steroid injection without obvious adverse reactions.

This study aimed to compare the ground reaction forces (GRFs) and spatio-temporal parameters as well as their asymmetry ratios in gait between individuals wearing a transfemoral prosthetic simulator (TFSim) and individuals with unilateral transfemoral amputation (TFAmp) across a range of walking speeds (2.0-5.5 km h-1). The study recruited 10 non-disabled individuals using TFSim and 10 individuals with unilateral TFAmp using a transfemoral prosthesis. Data were collected using an instrumented treadmill with built-in force plates, and subsequently, the GRFs and spatio-temporal parameters, as well as their asymmetry ratios, were analysed. When comparing the TFSim and TFAmp groups, no significant differences were found among the gait parameters and asymmetry ratios of all tested metrics except the vertical GRFs. The TFSim may not realistically reproduce the vertical GRFs during the weight acceptance and push-off phases. The structural and functional variations in prosthetic limbs and components between the TFSim and TFAmp groups may be primary contributors to the difference in the vertical GRFs. These results suggest that TFSim might be able to emulate the gait of individuals with TFAmp regarding the majority of spatio-temporal and GRF parameters. However, the vertical GRFs of TFSim should be interpreted with caution.

Shape morphing in bistable kirigami enables remarkable functionalities appealing to a diverse range of applications across the spectrum of length scale. At the core of their shape shifting lies the architecture of their repeating unit, where highly deformable slits and quasi-rigid rotating units often exhibit multiple symmetries that confer isotropic deployment obeying uniform scaling transformation. In this work, symmetry breaking in bistable kirigami is investigated to access geometric frustration and anisotropic morphing, enabling arbitrarily scaled deployment in planar and spatial bistable domains. With an analysis on their symmetry properties complemented by a systematic investigation integrating semi-analytical derivations, numerical simulations, and experiments on elastic kirigami sheets, this work unveils the fundamental relations between slit symmetry, geometric frustration, and anisotropic bistable deployment. Furthermore, asymmetric kirigami units are leveraged in planar and flat-to-3D demonstrations to showcase the pivotal role of shear deformation in achieving target shapes and functions so far unattainable with uniformly stretchable kirigami. The insights provided in this work unveil the role of slit symmetry breaking in controlling the anisotropic bistable deployment of soft kirigami metamaterials, enriching the range of achievable functionalities for applications spanning deployable space structures, wearable technologies, and soft machines.

Different head positions affect the responses of the vestibular semicircular canals (SCCs) to angular movement. Specific head positions can relieve vestibular disorders caused by excessive stimulating SCCs. In this study, we quantitatively explored responses of human SCCs using numerical simulations of fluid-structure interaction and vestibulo-ocular reflex (VOR) experiments under different forward-leaning angles of the head, including 0°, 10°, 20°, 30°, 40°, 50°, and 60°. It was found that the horizontal nystagmus slow-phase velocity and corresponding biomechanical responses of the cupula in horizontal SCC increased with the forward-leaning angles of the head, reached a maximum when the head was tilted 30° forward, and then gradually decreased. However, no obvious vertical or torsional nystagmus was observed in the VOR experiments. In the numerical model of bilateral SCCs, the biomechanical responses of the cupula in the left anterior SCC and the right anterior SCC showed the same trends; they decreased with the forward-leaning angles, reached a minimum at a 40° forward tilt of the head, and then gradually increased. Similarly, the biomechanical responses of the cupula in the left posterior SCC and in the right posterior SCC followed a same trend, decreasing with the forward-leaning angles, reaching a minimum at a 30° forward tilt of the head, and then gradually increasing. Additionally, the biomechanical responses of the cupula in both the anterior and posterior SCCs consistently remained lower than those observed in the horizontal SCCs across all measured head positions. The occurrence of these numerical results was attributed to the consistent maintenance of mutual symmetry in the bilateral SCCs with respect to the mid-sagittal plane containing the axis of rotation. This symmetry affected the distribution of endolymph pressure, resulting in biomechanical responses of the cupula in each pair of symmetrical SCCs exhibiting same tendencies under different forward-leaning angles of the head. These results provided a reliable numerical basis for future research to relieve vestibular diseases induced by spatial orientation of SCCs.