The family of polar hybrid perovskites, in which bulk photovoltaic effects (BPVEs) drive steady photocurrent without bias voltage, have shown promising potentials in self-powered polarization-sensitive photodetection. However, reports of BPVEs in 3D perovskites remain scare, being mainly hindered by the limited dipole moment or lack of symmetry breaking. Herein, a polar 3D perovskitoid, (BDA)Pb2Br6 (BDA = NH3C4H8NH3), where the spontaneous polarization (Ps)-induced BPVE drives self-powered photodetection of polarized-light is reported. Emphatically, the edge-sharing Pb2Br10 dimer building unit allows the optical anisotropy and polarity in 3D (BDA)Pb2Br6, which triggers distinct optical absorption dichroism ratio of ≈2.80 and BPVE dictated photocurrent of 3.5 µA cm-2. Strikingly, these merits contribute to a polarization-sensitive photodetection with a high polarization ratio (≈4) under self-powered mode, beyond those of 2D hybrid perovskites and inorganic materials. This study highlights the potential of polar 3D perovskitoids toward intelligent optoelectronic applications.

Although studies have shown that light affects sleep in polar populations, the sample size of most studies is small. This meta-analysis provides the first systematic review of the effects of summer glare, spring and fall moderate daylight, and artificial lighting on general sleep problems (sleep duration, efficiency, and delay). This analysis included 18 studies involving 986 participants. We calculated the random effect size via an evidence-based meta-analysis that analysed the effect of bright/auxiliary light on sleep and the effect of three different types of light on sleep compared with conventional light. There was no significant correlation between specific light types and sleep duration. Intense summer light has a negative effect on sleep time and efficiency. Moderate, natural light in spring and autumn effectively delayed sleep but could not improve sleep efficiency. For artificial fill light, neither blue light nor enhanced white light has been found to have a significant effect. In summary, summer light has a detrimental effect on sleep in polar populations, and moderate natural light may be superior to conventional light. However, specific strategies to improve sleep and artificial lighting in polar populations must be explored further.

Establishing high performance ultraviolet (UV) nonlinear optical (NLO) selenite crystals with well-balanced properties is very challenging attributable to their strong absorption for UV light. Here a rare-earth selenite, Sc(HSeO3 )3 , with excellent UV NLO properties is introduced. Sc(HSeO3 )3 crystallizing in the polar NCS space group, Cc, features a 3D archetiture built up by interconnected ScO6 octahedra and HSeO3 groups. The crystal exhibits remarkably well-balanced UV-NLO functionality, namely, the shortest absorption edge (214 nm) among NLO-active selenites, wide bandgap (5.28 eV), large phase-matchable SHG response (5 × KDP), and sufficiently large birefringence (cal. 0.105 @1064 nm). Detailed DFT calculations have been performed to elucidate the structure-property relationships. This work provides a new example of discovering novel UV NLO selenite materials.

In order to explore the adsorption characteristics of phosphorus from molecules with different molecular structures and varying number of phosphate groups on metal-modified biochar, walnut shell biochar was modified with LaCl3 to prepare lanthanum-loaded biochar (BC-La). Adsorption of four polar components, namely phytic acid (IHP), adenosine-5\'-disodium triphosphate (5-ATP), hydroxyethylidene diphosphonic acid (HEDP), and sodium pyrophosphate (PP), was studied. The adsorption properties and mechanism of phosphorus sorption by BC-La were analyzed by SEM-EDS and FTIR for the different structures. The results showed that the maximum adsorption capacity of BC-La for IHP, 5-ATP, HEDP, and PP was 85.85, 9.04, 15.80, and 14.45 mg/g, respectively. The adsorption capacity was positively correlated with the polarity of organic phosphorus. The adsorption behavior conformed to the quasi second-order kinetic fitting equation, and the increase of temperature was conducive to the removal of all four phosphorus pollutants. BC-La adsorbs IHP and HEDP mainly through electrostatic attraction. The adsorption of 5-ATP and PP is dominated by complexation. The La-modified biochar has broad prospects in water remediation, which can provide a theoretical basis for removal of different forms of phosphorus pollutants and prevention and control of water eutrophication.

High-quality AlN film is a key factor affecting the performance of deep-ultraviolet optoelectronic devices. In this work, high-temperature annealing technology in a nitrogen atmosphere was used to improve the quality of AlN films with different polarities grown by magnetron sputtering. After annealing at 1400-1650 °C, the crystal quality of the AlN films was improved. However, there was a gap between the quality of non-polar and polar films. In addition, compared with the semi-polar film, the quality of the non-polar film was more easily improved by annealing. The anisotropy of both the semi-polar and non-polar films decreased with increasing annealing temperature. The results of Raman spectroscopy, scanning electron microscopy and X-ray photoelectron spectroscopy revealed that the annihilation of impurities and grain boundaries during the annealing process were responsible for the improvement of crystal quality and the differences between the films with different polarities.

The long-term time trends of atmospheric pollutants at eight Arctic monitoring stations are reported. The work was conducted under the Arctic Monitoring and Assessment Programme (AMAP) of the Arctic Council. The monitoring stations were: Alert, Canada; Zeppelin, Svalbard; Stórhöfði, Iceland; Pallas, Finland; Andøya, Norway; Villum Research Station, Greenland; Tiksi and Amderma, Russia. Persistent organic pollutants (POPs) such as α- and γ-hexachlorocyclohexane (HCH), polychlorinated biphenyls (PCBs), α-endosulfan, chlordane, dichlorodiphenyltrichloroethane (DDT) and polybrominated diphenyl ethers (PBDEs) showed declining trends in air at all stations. However, hexachlorobenzene (HCB), one of the initial twelve POPs listed in the Stockholm Convention in 2004, showed either increasing or non-changing trends at the stations. Many POPs demonstrated seasonality but the patterns were not consistent among the chemicals and stations. Some chemicals showed winter minimum and summer maximum concentrations at one station but not another, and vice versa. The ratios of chlordane isomers and DDT species showed that they were aged residues. Time trends of perfluorooctanoic acid (PFOA) and perfluorooctane sulfonic acid (PFOS) were showing decreasing concentrations at Alert, Zeppelin and Andøya. The Chemicals of Emerging Arctic Concern (CEAC) were either showing stable or increasing trends. These include methoxychlor, perfluorohexane sulfonic acid (PFHxS), 6:2 fluorotelomer alcohol, and C9-C11 perfluorocarboxylic acids (PFCAs). We have demonstrated the importance of monitoring CEAC before they are being regulated because model calculations to predict their transport mechanisms and fate cannot be made due to the lack of emission inventories. We should maintain long-term monitoring programmes with consistent data quality in order to evaluate the effectiveness of chemical control efforts taken by countries worldwide.

An increasing number of wrist-worn wearables are being examined in the context of health care. However, studies of their use during physical education (PE) lessons remain scarce.
We aim to examine the reliability and validity of the Fizzo Smart Bracelet (Fizzo) in measuring heart rate (HR) in the laboratory and during PE lessons.
In Study 1, 11 healthy subjects (median age 22.0 years, IQR 3.75 years) twice completed a test that involved running on a treadmill at 6 km/h for 12 minutes and 12 km/h for 5 minutes. During the test, participants wore two Fizzo devices, one each on their left and right wrists, to measure their HR. At the same time, the Polar Team2 Pro (Polar), which is worn on the chest, was used as the standard. In Study 2, we went to 10 schools and measured the HR of 24 students (median age 14.0 years, IQR 2.0 years) during PE lessons. During the PE lessons, each student wore a Polar device on their chest and a Fizzo on their right wrist to measure HR data. At the end of the PE lessons, the students and their teachers completed a questionnaire where they assessed the feasibility of Fizzo. The measurements taken by the left wrist Fizzo and the right wrist Fizzo were compared to estimate reliability, while the Fizzo measurements were compared to the Polar measurements to estimate validity. To measure reliability, intraclass correlation coefficients (ICC), mean difference (MD), standard error of measurement (SEM), and mean absolute percentage errors (MAPE) were used. To measure validity, ICC, limits of agreement (LOA), and MAPE were calculated and Bland-Altman plots were constructed. Percentage values were used to estimate the feasibility of Fizzo.
The Fizzo showed excellent reliability and validity in the laboratory and moderate validity in a PE lesson setting. In Study 1, reliability was excellent (ICC>0.97; MD<0.7; SEM<0.56; MAPE<1.45%). The validity as determined by comparing the left wrist Fizzo and right wrist Fizzo was excellent (ICC>0.98; MAPE<1.85%). Bland-Altman plots showed a strong correlation between left wrist Fizzo measurements (bias=0.48, LOA=-3.94 to 4.89 beats per minute) and right wrist Fizzo measurements (bias=0.56, LOA=-4.60 to 5.72 beats per minute). In Study 2, the validity of the Fizzo was lower compared to that found in Study 1 but still moderate (ICC>0.70; MAPE<9.0%). The Fizzo showed broader LOA in the Bland-Altman plots during the PE lessons (bias=-2.60, LOA=-38.89 to 33.69 beats per minute). Most participants considered the Fizzo very comfortable and easy to put on. All teachers thought the Fizzo was helpful.
When participants ran on a treadmill in the laboratory, both left and right wrist Fizzo measurements were accurate. The validity of the Fizzo was lower in PE lessons but still reached a moderate level. The Fizzo is feasible for use during PE lessons.

By introducing the polar methoxy group into phenyl- or benzyl-phosphonate ligands, four cobalt phosphonates with layered structures are obtained, namely, [Co(4-mopp)(H2 O)] (1), [Co(4-mobp)(H2 O)] (2), [Co(3-mopp)(H2 O)] (3), and [Co(3-mobp)(H2 O)] (4), where 4- or 3-moppH2 is (4- or 3-methoxyphenyl)phosphonic acid and 4- or 3-mobpH2 is (4- or 3-methoxybenzyl)phosphonic acid. Compounds 1, 2, and 4 crystallize in the polar space groups Pmn21 or Pna21 , whereas compound 3 crystallizes in the centrosymmetric space group P21 /n. The layer topologies in the four structures are similar and can be viewed as perovskite type, where the edge-sharing [Co4 O4 ] rhombi are capped by the PO3 C groups. The phenyl and MeO groups in compounds 1-3 are heavily disordered, whereas that in 4 is ordered. Structural comparison based on the data at 296 and 123 K reveals distinct dynamic motion of the organic groups in compounds 1 and 2. The fluctuation of the polar MeO groups in these two compounds is confirmed by dielectric relaxation measurements. In contrast, the fluctuation of polar groups in compounds 3 and 4 is not evident. Interestingly, the dehydrated samples of 3 and 4 (i.e., 3-de and 4-de) exhibit one-step and two-step phase transitions associated with the motion of polar organic groups, as proven by DSC and dielectric measurements. The magnetic properties of compounds 1-4 are investigated, and strong antiferromagnetic interactions are found to mediate between the magnetic centers through μ-O(P) and O-P-O bridges.

Electrocatalytic hydrogen evolution reaction (HER) in alkaline solution is hindered by its sluggish kinetics toward water dissociation. Nickel-based catalysts, as low-cost and effective candidates, show great potentials to replace platinum (Pt)-based materials in the alkaline media. The main challenge regarding this type of catalysts is their relatively poor durability. In this work, we conceive and construct a charge-polarized carbon layer derived from carbon quantum dots (CQDs) on Ni3N nanostructure (Ni3N@CQDs) surfaces, which simultaneously exhibit durable and enhanced catalytic activity. The Ni3N@CQDs shows an overpotential of 69 mV at a current density of 10 mA cm-2 in a 1 M KOH aqueous solution, lower than that of Pt electrode (116 mV) at the same conditions. Density functional theory (DFT) simulations reveal that Ni3N and interfacial oxygen polarize charge distributions between originally equal C-C bonds in CQDs. The partially negatively charged C sites become effective catalytic centers for the key water dissociation step via the formation of new C-H bond (Volmer step) and thus boost the HER activity. Furthermore, the coated carbon is also found to protect interior Ni3N from oxidization/hydroxylation and therefore guarantees its durability. This work provides a practical design of robust and durable HER electrocatalysts based on nonprecious metals.

The effects of elevated ozone on C (carbon), N (nitrogen) and P (phosphorus) ecological stoichiometry and nutrient resorption in different organs including leaves, stems and roots were investigated in poplar clones 546 (P. deltoides cv. \'55/56\' × P. deltoides cv. \'Imperial\') and 107 (P. euramericana cv. \'74/76\') with a different sensitivity to ozone. Plants were exposed to two ozone treatments, NF (non-filtered ambient air) and NF60 (NF with targeted ozone addition of 60 ppb), for 96 days in open top chambers (OTCs). Significant ozone effects on most variables of C, N and P ecological stoichiometry were found except for the C concentration and the N/P in different organs. Elevated ozone increased both N and P concentrations of individual organs while for C/N and C/P ratios a reduction was observed. On these variables, ozone had a greater effect for clone 546 than for clone 107. N concentrations of different leaf positions ranked in the order upper > middle > lower, showing that N was transferred from the lower senescent leaves to the upper ones. This was also indicative of N resorption processes, which increased under elevated ozone. N resorption of clone 546 was 4 times larger than that of clone 107 under ambient air (NF). However, elevated ozone (NF60) had no significant effect on P resorption for both poplar clones, suggesting that their growth was only limited by N, while available P in the soil was enough to sustain growth. Understanding ecological stoichiometric responses under ozone stress is crucial to predict future effects on ecological processes and biogeochemical cycles.