Membrane-based pervaporation (PV) for organic solvent dehydration is of great significance in the chemical and petrochemical industries. In this work, high-aluminum ZSM-5 zeolite membranes were synthesized by a fluoride-assisted secondary growth on α-alumina tubular supports using mordenite framework inverted (MFI) nanoseeds (~110 nm) and a template-free synthesis solution with a low Si/Al ratio of 10. Characterization by XRD, EDX, and SEM revealed that the prepared membrane was a pure-phase ZSM-5 zeolite membrane with a Si/Al ratio of 3.8 and a thickness of 2.8 µm. Subsequently, two categories of PV performance parameters (i.e., flux versus separation factor and permeance versus selectivity) were used to systematically examine the effects of operating conditions on the PV dehydration performance of different organic solvents (methanol, ethanol, n-propanol, and isopropanol), and their PV mechanisms were explored. Employing permeance and selectivity effectively disentangles the influence of operating conditions on PV performance, thereby elucidating the inherent contribution of membranes to separation performance. The results show that the mass transfer during PV dehydration of organic solvents was mainly dominated by the adsorption-diffusion mechanism. Furthermore, the diffusion of highly polar water and methanol molecules within membrane pores had a strong mutual slowing-down effect, resulting in significantly lower permeance than other binary systems. However, the mass transfer process for water/low-polar organic solvent (ethanol, n-propanol, and isopropanol) mixtures was mainly controlled by competitive adsorption caused by affinity differences. In addition, the high-aluminum ZSM-5 zeolite membrane exhibited superior PV dehydration performance for water/isopropanol mixtures.

OBJECTIVE: To investigate the impact of a centrifugation method on the surface characteristics, flexural properties, and cytotoxicity of an additively manufactured denture base polymer.
METHODS: The tested specimens were prepared by digital light processing (DLP). A centrifugation method (CENT) was used to remove the residual uncured resin. In addition, the specimens were post-processed with different post-rinsing solutions: isopropanol (IPA), ethanol (EtOH), and tripropylene glycol monomethyl ether (TPM), respectively. A commercial heat-polymerized polymethyl methacrylate was used as a reference (REF). First, the values of surface topography, arithmetical mean height (Sa), and root mean square height (Sq) were measured. Next, flexural strength (FS) and modulus were evaluated. Finally, cytotoxicity was assessed using an extract test. The data were statistically analyzed using a one-way analysis of variance, followed by Tukey\'s multiple comparison test for post-hoc analysis.
RESULTS: The Sa value in the CENT group was lower than in the IPA, EtOH, TPM, and REF groups (p < 0.001). Moreover, the CENT group had lower Sq values than other groups (p < 0.001). The centrifugation method showed a higher FS value (80.92 ± 8.65 MPa) than the EtOH (61.71 ± 12.25 MPa, p < 0.001) and TPM (67.01 ± 9.751 MPa, p = 0.027), while affecting IPA (72.26 ± 8.80 MPa, p = 0.268) and REF (71.39 ± 10.44 MPa, p = 0.231). Also, the centrifugation method showed no evident cytotoxic effects.
CONCLUSIONS: The surfaces treated with a centrifugation method were relatively smooth. Simultaneously, the flexural strength of denture base polymers was enhanced through centrifugation. Finally, no evident cytotoxic effects could be observed from different post-processing procedures.
CONCLUSIONS: The centrifugation method could optimize surface quality and flexural strength of DLP-printed denture base polymers without compromising cytocompatibility, offering an alternative to conventional rinsing post-processing.

The interaction between organic molecules and oxidized catalyst surfaces has frequently been used to study the fuel crossover from the anode to the cathode in direct liquid fuel cells. In such experiments, the oxidized surface is put in contact with the fuel under open circuit conditions, and the evolution of the potential is registered. The open circuit potential (OCP) vs. time features can then inform on the reactivity of the fuel with the oxidized surface and provide valuable information not only to applications in fuel cells but also to the electrochemical reform of those molecules to produce clean hydrogen. In this paper, we present an experimental investigation of the open circuit interaction between ethanol or 2-propanol with oxidized platinum surfaces. Besides the OCP time traces, we have also employed cyclic voltammetry and fast oxide reduction sweep in the presence of the alcohols. Comparable reaction currents are obtained in the cyclic voltammogram, but the electro-oxidation of 2-propanol sets in at considerably lower overpotentials than that of ethanol. At the high potential region, both the magnitude and the potential of the current peak are nearly identical in both cases. In contrast, under open circuit conditions, the interaction of ethanol with the oxidized platinum surface is more pronounced than that found for 2-propanol, and these results are corroborated by the facile reduction of the platinum oxides along the fast backward sweep for the case of the latter.

High-quality DNA is an important guarantee to start downstream experiments in many biological and medical research areas. Magnetic particle-based DNA extraction methods from blood mainly depend on electrostatic adsorption in a low-pH environment. However, the strong acidic environment can influence the DNA stability. Herein, a polydopamine-functionalized magnetic particle (PDA@Fe3O4)-based protocol was developed for DNA extraction from whole blood samples. In the protocol, Mg2+ and Ca2+ were utilized to bridge the adsorption of DNA by PDA@Fe3O4 via the metal-mediated coordination. Isopropanol was found to efficiently promote DNA adsorption by triggering the change of the conformation of DNA from B-form to more compact A-form. In 50 % isopropanol solution, the DNA adsorption efficiency was nearly 100 % in the presence of 0.5 mM Ca2+ or 1.5 mM Mg2+. The role of metal ions and isopropanol in DNA adsorption was explored. The protocol averts the strong acidic environment and PCR inhibitors, such as high concentrations of salt or polyethylene glycol. It demonstrates superiority in DNA yield (59.13 ± 3.63 ng μL-1) over the commercial kit (27.33 ± 4.98 ng μL-1) and phenol-chloroform methods (37.90 ± 0.47 ng μL-1). In addition, to simplify the operastion, an automated nucleic acid extraction device was designed and fabricated to extract whole genomic DNA from blood. The feasibility of the device was verified by extracting DNA from cattle and pig blood samples. The extracted DNA was successfully applied to discriminate the beef authenticity by a duplex PCR system. The results demonstrate that the DNA extraction protocol and the automated device have great potential in blood samples.

This study evaluates the repurposing of expired isopropanol (IPA) COVID-19 disinfectant (64% w/w) to pretreat algal biomass for enhancing methane (CH4) yield. The impact of harvesting methods (centrifugation and polymer flocculation) and microwave pretreatment on CH4 production from Scenedesmus sp. microalgal biomass were also investigated. Results show minimal impact of harvesting methods on the CH4 yield, with wet centrifuged and polymer-harvested biomass exhibiting comparable and low CH4 production at 66 and 74 L/kgvolatile solid, respectively. However, microalgae drying significantly increased CH4 yield compared to wet biomass, attributed to cell shrinkage and enhanced digestibility. Consequently, microwave and IPA pretreatment significantly enhanced CH4 production when applied to dried microalgae, yielding a 135% and 212% increase, respectively, compared to non-pretreated wet biomass. These findings underscore the advantage of using dried Scenedesmus sp. over wet biomass and highlight the synergistic effect of combining oven drying with IPA treatment to boost CH4 production whilst reducing COVID-19 waste.

2-Propanol and n-hexane are widely used (as) chemical reagents in electronic, pharmaceutical, and chemical industries. An efficient separation of the azeotropic system of 2-propanol-n-hexane is of profound practical significance. By using the conductor-like screening model for real solve (COSMO-RS) predictive model, ionic liquids as extractants for separating the azeotropic system of 2-propanol-n-hexane were evaluated with selectivity coefficients (S) and capacity (C) as the evaluation indexes. Based on the evaluation results, one high-performance extractants named hydroxylamine Cl (C8A19) was selected from 435 kinds of ionic liquids designed by combining 29 kinds of anions and 15 kinds of cations. Moreover, the reliability of the model in predicting the vapor-liquid phase equilibrium behavior of 2-propanol-n-hexane system was verified. Then, the effect of C8A19 on the vapor-liquid phase equilibrium of the 2-propanol-n-hexane system was investigated theoretically and experimentally. The results show that the azeotrope of the system can be broken when the molar fraction of C8A19 is 0.02, denoting that C8A19 can be used for enhanced separation of 2-propanol-n-hexane system. On the basis of the aforementioned study, the selectivity mechanism of the extractant was analyzed from the perspective of microscopic molecular interactions by using the descriptor (σ-profiles) of COSMO-RS. This study provides both theoretical and data support for further designing high-performance ionic liquid extractants and extraction process.

BACKGROUND: Root-knot nematodes (RKNs), including Meloidogyne species, are among the most destructive plant-parasites worldwide. Recent evidence suggests that entomopathogenic fungi (EPF) can antagonize RKNs. Such antagonistic effects are likely mediated by toxic metabolites, including volatile organic compounds (VOCs), produced by the fungi. However, how widespread these effects are across EPF species, and which VOCs mediate negative interactions between EPF and RKNs needs to be further elucidated.
RESULTS: First, we evaluated the nematicidal effect of VOCs emitted by 46 EPF isolates against Meloidogyne incognita and found variable toxicity depending on the isolate. Second, we measured the nematicidal effect of highly toxic isolates, including species in the genus Talaromyces, Aspergillus, Clonostachys, and Purpureocillium and, third, we analyzed the nematicidal effect of major VOCs, including 2-methyl-1-propanol, 3-methyl-1-butanol, isopropyl alcohol and 2-methyl-3-pentanone. The mortality of M. incognita juveniles (J2s) was generally high (50%) either via airborne or in-solution contact with VOCs. Moreover, the tested VOCs significantly inhibited egg hatching, and repelled J2s away from the VOCs.
CONCLUSIONS: This study not only provides insights into the ecological function of VOCs in the rhizosphere, but also provides new approaches for developing environmentally friendly control methods of RKNs in agroecosystems. © 2023 Society of Chemical Industry.

The solubility of thiamine nitrate in {(methanol, acetone, isopropanol) + water} solvents will provide essential support for crystallization design and further theoretical studies. In this study, the solubility was experimentally measured over temperatures ranging from 278.15 to 313.15 K under atmospheric pressure using a dynamic method. The solubility increased with increasing temperature at a constant solvent composition. The dissolving capacity of thiamine nitrate in the three binary solvent mixtures at constant temperature in the low ratio of water ranked as water + methanol > water + acetone > water + isopropanol generally. Interestingly, in the high ratio of water systems, especially when the molar concentration of water was greater than 0.6, the dissolving capacity ranked as water + acetone > water + methanol > water + isopropanol. Additionally, the modified Apelblat equation, λh equation, van\'t Hoff equation and NRTL model were used to correlate the solubility data in binary mixtures. It turned out that all the selected thermodynamic models could give satisfactory results. Furthermore, the thermodynamic properties of the dissolution process of thiamine nitrate were also calculated based on the modified van\'t Hoff equation. The results indicate that the dissolution process of the thiamine nitrate in the selected solvents is all endothermic.

The separation of benoxacor enantiomers on six commercial chiral columns was investigated by high-performance liquid chromatography (HPLC) under normal-phase and reversed-phase conditions. The mobile phases included hexane/ethanol, hexane/isopropanol, acetonitrile/water, and methanol/water. The effects of the chiral stationary phases (CSPs), temperature, and mobile phase composition and ratio on the separation of benoxacor enantiomers were examined. Under normal-phase conditions, the two benoxacor enantiomers were completely separated on Chiralpak AD, Chiralpak IC, Lux Cellulose-1, and Lux Cellulose-3 columns and partially separated on a Lux Cellulose-2 column. Under reversed-phase conditions, benoxacor enantiomers were completely separated on a Lux Cellulose-3 column and partially separated on Chiralpak IC and Lux Cellulose-1 columns. Normal-phase HPLC performed better than reversed-phase HPLC for the separation of benoxacor enantiomers. As the column temperature increased from 10 °C to 4 °C, the enthalpy (ΔH) and entropy (ΔS) results indicated that the resolution was strongly affected by the temperature and that the lowest temperature did not always produce the best resolution. An optimized separation method on the Lux Cellulose-3 column was used to investigate the stability of benoxacor enantiomers in solvents and the degradation of benoxacor enantiomers in three types of horticultural soil. Benoxacor enantiomers were stable, and degradation or racemization were not observed in methanol, ethanol, isopropanol, acetonitrile, hexane, or water (pH = 4.0, 7.0, and 9.0). In three horticultural soils, the degradation rate of S-benoxacor was faster than that of R-benoxacor, resulting in soil enrichment with R-benoxacor. The results of this study will help to improve the risk assessment of enantiomer levels of benoxacor in the environment.

Palmitic acid (PA) is considered a major contributor to the inflammation in many metabolic diseases; however, this role has been questioned recently for the complicated procedures in preparing PA-bovine serum albumin (BSA) complex. This study is aimed to evaluate the effect of PA-BSA complexing methods on cell viability and inflammatory responses of BV-2 cells. Three commercially available BSA brands and two types of solvents were compared for their effects on the expression of inflammatory cytokines. Three commonly used proportions of PA-BSA were tested for cell viability and inflammatory responses. We found that all the three types of BSA were proinflammatory. Both ethanol and isopropanol dampened inflammation except that 1% isopropanol treatment increased the IL-1β level by 26%. When reducing the BSA content in PA-BSA solutions from 3:1 to 5:1, a marked increase in cell viability (11%) was seen. To our surprise, reducing BSA content in PA-BSA solutions from 5:1 to 10:1 decreased cell viability by 11%. The 5:1 group exhibited the lowest inflammatory profile. Either PA-BSA or BSA alone increased the entry of LPS to the cytosol, which further caused pyroptosis. In summary, we found 5:1 (PA:BSA) to be the best binding ratio for studying inflammation in BV-2 microglia. The presence of LPS in the cytosol in the context of BSA might be the reason for confounding results from palmitate studies.