Fluorescent and colorimetric chemosensors for selective detection of various biologically important analytes have been widely applied in different areas such as biology, physiology, pharmacology, and environmental sciences. The research area based on fluorescent chemosensors has been in existence for about 150 years with the development of large number of fluorescent chemosensors for selective detection of cations as metal ions, anions, reactive species, neutral molecules and different gases etc. Despite the progress made in this field, several problems and challenges still exist. The most important part of sensing is limit of detection (LOD) which is the lowest concentration that can be measured (detected) with statistical significance by means of a given analytical procedure. Although there are so many reports available for detection of millimolar to micromolar range but the development of chemosensors for the detection of analytes in nanomolar range is still a challenging task. Therefore, in our current review we have focused the history and a general overview of the development in the research of fluorescent sensors for selective detection of various analytes at nanomolar level only. The basic principles involved in the design of chemosensors for specific analytes, binding mode, photophysical properties and various directions are also covered here. Summary of physiochemical properties, mechanistic view and type of different chemosensors has been demonstrated concisely in the tabular forms.

A ligand, 2-phenylphthalazin-1(2H)-one (K), was synthesized by refluxing 2-formylbenzoic acid with phenyl hydrazine in presence of ethanol. FTIR, elemental analysis and single crystal XRD techniques were used to elucidate the structure. Fluorimetric turn-off response was recorded when solution of ligand (K) in DMF was treated with aqueous solution of Fe3+ and Fe2+ metal ions. No specific changes were observed on addition of other metal ions (Pb2+, Cd2+, Mn2+, Zn2+, Ba2+, Ni2+, Al3+, Ag1+, Co2+, Ca2+, Cu2+, Mg2+, Cr3+). Limit of Detection (LOD) was calculated for Fe2 and Fe3+as 2.4 µM and 2.5µM respectively, which is quite below to the recommended value 5.4 µM of the Environment Protection Agency of USA. Association constants for Fe3+ and Fe2+ metal ions were determined as 6 × 10-4 M-1 and 3.6 × 10-4 M-1 respectively. Benesi-Hildebrand plot confirmed 1:1 binding ratio between metal ions and ligand.

Selective detection of a metal ion with high selectivity is of great importance to understand its existence and its role in many chemical and biological processes. We report here the synthesis, characterization and Al3+ sensing properties of two rhodamine-based isomers, (E)-2-((2-(allyloxy)benzylidene)amino)ethyl)-3\',6\'-bis(ethylamine)-2\',7\'-dimethylspiro[isoindoline-1,9\'-xanthen]-3-one (L-2-oxy) and (E)-2-((4-(allyloxy)benzylidene)amino)ethyl)-3\',6\'-bis(ethylamine)-2\',7\'-dimethylspiro[isoindoline-1,9\'-xanthen]-3-one (L-4-oxy). L-2-oxyand L-4-oxy show pink coloration, significant enhancement in absorbance at 530 nm and fluorescence intensity at 553 nm in the presence of Al3+ among several cations. Quantum yield and lifetime of the probes increase in the presence of Al3+. LOD values have been determined as low as ∼1.0 nM for both the isomers. DFT study suggests that the cation induces opening of spirolactam ring resulting in the changes of the rhodamine dyes. Additional reason could be Chelation Enhanced Fluorescence (CHEF) effect due to the subsequent chelation of the metal ion. Between two isomers, L-2-oxy displays better sensing ability towards Al3+ in terms of fluorescence enhancement, limit of detection, lifetime enhancement. Both the probes have been utilized in cell imaging studies using rat skeletal myoblast cell line (L6 cell line).

In this study, we report a new syringe aldehyde-derived hydrazinyl-imidazole based fluorescent sensor (L) for sensitive detection of different inorganic quenchers (halide ions, bicarbonate ion, sulphide ion and transition metal ions). The chromophore (L) was obtained in good yield by the 1:1 condensation reaction of 2-hydrazino-4,5-dihydroimidazole hydrobromide and 4-hydroxy-3,5-dimethoxy benzaldehyde. L exhibited strong fluorescence in the visible region (around 380 nm) and its interaction with different quenchers was studied in details via fluorescence technique. For the halide ions series, its sensitivity is higher for NaF (Climit = 4 × 10- 4 M) than for NaCl while the fluorescence quenching occurred mainly through a dynamic process. Similar considerations were observed for HCO3- and S2- quencher too, when static and dynamic quenching take place simultaneously. Regarding transition metal ions, at a fixed ion concentration (4 × 10- 6 M), best performance was achieved for Cu2+ and Fe2+ (fluorescence intensity was reduced by 79% and 84.9% respectively), while for other metal ions, the sensor performance was evaluated and found to be very less (< 40%). Thus, minimum detection limits (10- 6 - 10- 5 M range) recommended the use of such derivatives as highly sensitive sensors capable to monitor delicate changes in varied environments.

Chromium is essential for some biochemical processes, and excess is a big concern that shows adverse effects on human health and the environment. Therefore, it is urgent to design new sensors to detect chromium ions rapidly. The present study discusses the synthesis of piperazine conjoined 1,2,3-triazolyl-γ-propyltriethoxysilanes (4a-4b) and development of 4a as fluorescence turn-on sensor for the detection of Cr3+ ions. The mechanistic insights reveal to the restricted CN rotation and inhibited intramolecular charge transfer (ICT) process. In addition, Job\'s plot and Benesi-Hildebrand plot justify the 1:1 binding affinity with a binding constant of 9.96 × 105 M-1 for [ligand 4a + Cr3+] complex and the limit of detection for Cr3+ ions is observed as 6.06 × 10-8 M. The fluorescence spectral changes, 1H NMR spectra and DFT studies provide evidences for ligand 4a and Cr3+ ions interactions. Further, the reversibility of the ligand 4a from [ligand 4a + Cr3+] complex on the addition of EDTA can be used in the construction of molecular logic gate where Cr3+ and EDTA are considered as inputs and the fluorescence intensity at 398 nm as output. Further, compounds 4a-4b were then evaluated for their antibacterial activity against bacterial strains (Escherichia coliand Staphylococcus aureus), revealing a modest activity. The binding mode of ligand 4a to Staphylococcus aureus (PDB ID - 3U2K) and Escherichia coli (PDB ID - 5Z4O) was investigated using an in-silico molecular docking technique, which revealed that the triazole ring and silanyl group are involved in hydrogen bonding with proteins and may be the cause of the ligand\'s antibacterial activity. The ligand 4a demonstrated a high affinity for binding within the active sites of proteins with binding energies of -7.97 kcal/mol (3U2K) and -8.68 kcal/mol (5Z4O).

暂无摘要。

Synthesis of novel benzophenone-based chemosensor is presented for the selective sensing of Sn2+ ion. Screening of competitive metal ions was performed by competitive experiments. The specific cation recognition ability of chemosensor towards Sn2+ was investigated by experimental (UV-visible, fluorescence spectroscopy, 1H NMR, 13C NMR, FTIR and HRMS) methods and further supported by Density Functional Theory study. The stoichiometric binding ratio and binding constant (Ka) for complex is found to be 1:1 and 1.50×104, respectively. The detection limit of Sn2+ towards chemosensor was found to be 0.3898ppb. Specific selectivity and superiority of chemosensor over another recently reported chemosensor is presented.

A triazole-Schiff base, 4-(5-Chloro-2-hydroxybenzylideneamino)-1H-1,2,4-triazole-5(4H)-thione (HL), exhibits the high selectivity and sensitivity for Zn(2+) in the fluorescence spectrometry over other common metal ions, especially Cd(2+) in DMSO:H2O (1:9, v/v) solution. A 1:1 binding ratio of Zn(2+)/L for the complex has been obtained by Uv-Vis titration experiments and Job\'s plot with the detection limit of 51 nmol/L. The coordination mode of the complex in solution was further confirmed by density functional theory (DFT) calculations. Time-dependent density functional theory (TD-DFT) calculations indicate that a chelation-enhanced fluorescence (CHEF) effect occurs in the process of detecting Zn ion.

The interactions between chemosensors, 3-amino-5-(4,5,6,7-tetrahydro-1H-indol-2-yl)isoxazole-4-carboxamide (AIC) derivatives, and different anions (F(-) Cl(-), Br(-), AcO(-), and H(2)PO(4) (-)) have been theoretically investigated using DFT approaches. It turned out that the unique selectivity of AIC derivatives for F(-) is ascribed to their ability of deprotonating the host sensors. Frontier molecular orbital (FMO) analyses have shown that the vertical electronic transitions of absorption and emission for the sensing signals are characterized as intramolecular charge transfer (ICT). The study of substituent effects suggests that all the substituted derivatives are expected to be promising candidates for fluoride chemosensors both in UV-vis and fluorescence spectra except for derivative with benzo[d]thieno[3,2-b]thiophene fragment that can serve as ratiometric fluorescent fluoride chemosensor only.