The influence of decreasing the entanglement density of macromolecules on the crystallization of the β-form of polypropylene was investigated. Polypropylene with seven times less entanglement was obtained from a solution in xylene, and its properties were compared with those of fully entangled polypropylene. To obtain a high β-phase content, the polymer was nucleated using calcium pimelate. In non-isothermal crystallization studies, accelerated growth of β-crystals was found, increasing the crystallization temperature. Also, the isothermal crystallization was fastest in the nucleated, partially disentangled polypropylene. Increased growth rate of spherulites and enhanced nucleation activity in the presence of more mobile macromolecules were responsible for the high rate of melt conversion to crystals in the disentangled polypropylene. It was also observed that the equilibrium melting temperature of β-crystals is lower after disentangling macromolecules. Better conditions for crystal building after reduction of entanglements resulted in enhanced crystallization according to regime II.

With the rapid development of new energy and the upgrading of electronic devices, structurally stable phase change materials (PCMs) have attracted widespread attentions from both academia and industries. Traditional cross-linking, composites, or microencapsulation methods for preparation of form stable PCMs usually sacrifice part of the phase change enthalpy and recyclability. Based on the basic polymer viscoelasticity and crystallization theories, here, a kind of novel recyclable polymeric PCM is developed by simple solution mixing ultrahigh molecular weight of polyethylene oxide (UHMWPEO) with its chemical identical oligomer polyethylene glycol (PEG). Rheological and leakage-proof experiments confirm that, even containing 90% of phase change fraction PEG oligomers, long-term of structure stability of PCMs can be achieved when the molecular weight of UHMWPEO is higher than 7000 kg mol-1 due to their ultralong terminal relaxation time and large number of entanglements per chain. Furthermore, because of the reduced overall entanglement concentration, phase change enthalpy of PCMs can be greatly promoted, even reaching to ≈185 J g-1, which is larger than any PEG-based form stable PCMs in literatures. This work provides a new strategy and mechanism for designing physical-entanglements-supported form stable PCMs with ultrahigh phase change enthalpies.

Understanding and characterizing semi-crystalline models with crystalline and amorphous segments is crucial for industrial applications. A coarse-grained molecular dynamics (CGMD) simulations study probed the crystal network formation in high-density polyethylene (HDPE) from melt, and shed light on tensile properties for microstructure analysis. Modified Paul-Yoon-Smith (PYS/R) forcefield parameters are used to compute the interatomic forces among the PE chains. The isothermal crystallization at 300 K and 1 atm predicts the multi-nucleus crystal growth; moreover, the lamellar crystal stems and amorphous region are alternatively oriented. A one-dimensional density distribution along the alternative lamellar stems further confirms the ordering of the lamellar-stack orientation. Using this plastic model preparation approach, the semi-crystalline model density (ρcr) of ca. 0.913 g·cm-3 and amorphous model density (ρam) of ca. 0.856 g·cm-3 are obtained. Furthermore, the ratio of ρcr/ρam ≈ 1.06 is in good agreement with computational (≈1.096) and experimental (≈1.14) data, ensuring the reliability of the simulations. The degree of crystallinity (χc) of the model is ca. 52% at 300 K. Nevertheless, there is a gradual increase in crystallinity over the specified time, indicating the alignment of the lamellar stems during crystallization. The characteristic stress-strain curve mimicking tensile tests along the z-axis orientation exhibits a reversible sharp elastic regime, tensile strength at yield ca. 100 MPa, and a non-reversible tensile strength at break of 350%. The cavitation mechanism embraces the alignment of lamellar stems along the deformation axis. The study highlights an explanatory model of crystal network formation for the PE model using a PYS/R forcefield, and it produces a microstructure with ordered lamellar and amorphous segments with robust mechanical properties, which aids in predicting the microstructure-mechanical property relationships in plastics under applied forces.

This article troubles touch as requiring embodied proximity, through an affective account of virtual touch during coronatime. Interested in doing academia differently, we started an online Barad readingwriting group from different locations. The coronatime void was not a vacuum, but a plenitude of possibilities for intimacy, pedagogy, learning, creativity, and adventure. Although physically apart, we met daily through Zoom, and we touched and were touched by each other and the texts we read. A montage of writing fragments and a collective artwork, based on the Massive_Micro project, highlight virtual touching. Undone, redone, and reconfigured, we became a diffractive human/nonhuman multiplicity.

The administration of Mg ions is advantageous in pathological scenarios such as pre-enclampsia and forms of neuroinflammation (e.g. stroke or injury); yet, few systems exist for their sustained delivery. Here, we present the (static light scattering and diffusing-wave spectroscopy) characterization of magnesium alginate (MgAlg) as a potentially injectable vehicle ifor the delivery of Mg. Differently from other divalent cations, Mg does not readily induce gelation: it acts within MgAlg coils, making them more rigid and less prone to entangle. As a result, below a threshold concentration (notionally below 0.5 % wt.) MgAlg are inherently less viscous than those of sodium alginate (NaAlg), which is a major advantage for injectables; at higher concentrations, however, (stable, Mg-based) aggregation starts occurring. Importantly, Mg can then be released e.g. in artificial cerebrospinal fluid, via a slow (hours) process of ion exchange. Finally, we here show that MgAlg protects rat neural stem cells from the consequence of an oxidative insult (100 μM H2O2), an effect that we can only ascribe to the sustained liberation of Mg ions, since it was not shown by NaAlg, MgSO4 or the NaAlg/MgSO4 combination. Our results therefore indicate that MgAlg is a promising vehicle for Mg delivery under pathological (inflammatory) conditions.

One-third of protein domains in the CATH database contain a recently discovered tertiary topological motif: non-covalent lasso entanglements, in which a segment of the protein backbone forms a loop closed by non-covalent interactions between residues and is threaded one or more times by the N- or C-terminal backbone segment. Unknown is how frequently this structural motif appears across the proteomes of organisms. And the correlation of these motifs with various classes of protein function and biological processes have not been quantified. Here, using a combination of protein crystal structures, AlphaFold2 predictions, and Gene Ontology terms we show that in E. coli, S. cerevisiae and H. sapiens that 71%, 52% and 49% of globular proteins contain one-or-more non-covalent lasso entanglements in their native fold, and that some of these are highly complex with multiple threading events. Further, proteins containing these tertiary motifs are consistently enriched in certain functions and biological processes across these organisms and depleted in others, strongly indicating an influence of evolutionary selection pressures acting positively and negatively on the distribution of these motifs. Together, these results demonstrate that non-covalent lasso entanglements are widespread and indicate they may be extensively utilized for protein function and subcellular processes, thus impacting phenotype.

Mechanical recycling is the most efficient way to reduce plastic pollution due to its ability to maintain the intrinsic properties of plastics as well as provide economic benefits involved in other types of recycling. On the other hand, molecular dynamics (MD) simulations provide key insights into structural deformation, lamellar crystalline axis (c-axis) orientations, and reorganization, which are essential for understanding plastic behavior during structural deformations. To simulate the influence of structural deformations in high-density polyethylene (HDPE) during mechanical recycling while paying attention to obtaining an alternate lamellar orientation, the authors examine a specific way of preparing stacked lamella-oriented HDPE united atom (UA) models, starting from a single 1000 UA (C1000) chain of crystalline conformations and then packing such chain conformations into 2-chain, 10-chain, 15-chain, and 20-chain semi-crystalline models. The 2-chain, 10-chain, and 15-chain models yielded HDPE microstructures with the desired alternating lamellar orientations and entangled amorphous segments. On the other hand, the 20-chain model displayed multi-nucleus crystal growth instead of the lamellar-stack orientation. Structural characterization using a one-dimensional density profile and local order parameter {P2(r)} analyses demonstrated lamellar-stack orientation formation. All semi-crystalline models displayed the total density (ρ) and degree of crystallinity (χ) range of 0.90-0.94 g/cm-3 and ≥42-45%, respectively. A notable stress yield (σ_yield) ≈ 100-120 MPa and a superior elongation at break (ε_break) ~250% was observed under uniaxial strain deformation along the lamellar-stack orientation. Similarly, during the MD simulations, the microstructure phase change represented the average number of entanglements per chain (). From the present study, it can be recommended that the 10-chain alternate lamellar-stack orientation model is the most reliable miniature model for HDPE that can mimic industrially relevant plastic behavior in various conditions.

Ti-series oxide ceramics in the form of aerogels, such as TiO2, SrTiO3, BaTiO3, and CaCu3Ti4O12, hold tremendous potential as functional materials owing to their excellent optical, dielectric, and catalytic properties. Unfortunately, these inorganic aerogels are usually brittle and prone to pulverization owing to weak inter-particulate interactions, resulting in restricted application performance and serious health risks. Herein, a novel strategy is reported to synthesize an elastic form of an aerogel-like, highly porous structure, in which activity-switchable Ti-series oxide sols transform from the metastable state to the active state during electrospinning, resulting in condensation and solidification at the whipping stage to obtain curled nanofibers. These curled nanofibers are further entangled when flying in the air to form a physically interlocked, elastic network mimicking the microstructure of high-elasticity hydrogels. This strategy provides a library of Ti-series oxide nanofiber sponges with unprecedented stretchability, compressibility, and bendability, possessing extensive opportunities for greener, safer, and broader applications as integrated or wearable functional devices. As a proof-of-concept demonstration, a new, elastic form of TiO2, composed of both \"white\" and \"black\" TiO2 nanofiber sponges, is constructed as spontaneous air-conditioning textiles in smart clothing, buildings, and vehicles, with unique bidirectional regulation of radiative cooling in summer and solar heating in winter.

Staudinger taught us that macromolecules were made up of covalently bonded monomer repeat units chaining up as polymer chains. This paradigm is not challenged in this paper. The main question raised in polymer physics remains: how do these long chains interact and move as a group when submitted to shear deformation at high temperature when they are viscous liquids? The current consensus is that we need to distinguish two cases: the deformation of \"un-entangled chains\" for macromolecules with molecular weight, M, smaller than Me, \"the entanglement molecular weight\", and the deformation of \"entangled\" chains for M > Me. The current paradigm stipulates that the properties of polymers derive from the statistical characteristics of the macromolecule itself, the designated statistical system that defines the thermodynamic state of the polymer. The current paradigm claims that the viscoelasticity of un-entangled melts is well described by the Rouse model and that the entanglement issues raised when M > Me, are well understood by the reptation model introduced by de Gennes and colleagues. Both models can be classified in the category of \"chain dynamics statistics\". In this paper, we examine in detail the failures and the current challenges facing the current paradigm of polymer rheology: the Rouse model for un-entangled melts, the reptation model for entangled melts, the time-temperature superposition principle, the strain-induced time dependence of viscosity, shear-refinement and sustained-orientation. The basic failure of the current paradigm and its inherent inability to fully describe the experimental reality is documented in this paper. In the discussion and conclusion sections of the paper, we suggest that a different solution to explain the viscoelasticity of polymer chains and of their \"entanglement\" is needed. This requires a change in paradigm to describe the dynamics of the interactions within the chains and across the chains. A brief description of our currently proposed open dissipative statistical approach, \"the Grain-Field Statistics\", is presented.

BACKGROUND: From a nuclear spin prospective, water exists as para and ortho nuclear spin isomers (isotopomers). Spin interconversions in isolated molecules of water are forbidden, but many recent reports have shown them to happen in bulk, through dynamic proton exchanges happening between interconnected networks of a large array of water molecules. In this contribution, a possible explanation for an unexpected slow or delayed interconversion of ortho-para water in ice observed in an earlier reported experiment is provided. Using the results of quantum mechanical investigations, we have discussed the roles played by Bjerrum defects in the dynamic proton exchanges and ortho-para spin state interconversions. We guess that at the sites of the Bjerrum defects, there are possibilities of quantum entanglements of states, through pairwise interactions. Based on the perfectly correlated exchange happening via a replica transition state, we speculate that it can have significant influences on ortho-para interconversions of water. We also conjecture that the overall ortho-para interconversion is not a continuous process, rather can be imagined to be happening serendipitously, but within the boundary of the rules of quantum mechanics.
METHODS: All computations were performed with Gaussian 09 program. B3LYP/6-31++G(d,p) methodology was used to compute all the stationary points. Further energy corrections were computed using CCSD(T)/aug-cc-pVTZ methodology. Intrinsic reaction coordinate (IRC) path computations were carried out for the transition states.