Salinity was considered to have effects on the characteristics, performance microbial communities of aerobic granular sludge. This study investigated granulation process with gradual increase of salt under different gradients. Two identical sequencing batch reactors were operated, while the influent of Ra and Rb was subjected to stepwise increments of NaCl concentrations (0-4 g/L and 0-10 g/L). The presence of filamentous bacteria may contribute to granules formed under lower salinity conditions, potentially leading to granules fragmentation. Excellent removal efficiency achieved in both reactors although there was a small accumulation of nitrite in Rb at later stages. The removal efficiencies of chemical oxygen demand (COD), total nitrogen (TN), and total phosphorus (TP) in Ra were 95.31%, 93.70% and 88.66%, while the corresponding removal efficiencies in Rb were 94.19%, 89.79% and 80.74%. Salinity stimulated extracellular polymeric substances (EPS) secretion and enriched EPS producing bacteria to help maintain the integrity and stability of the aerobic granules. Heterotrophic nitrifying bacteria were responsible for NH4+-N and NO2--N oxidation of salinity systems and large number of denitrifying bacteria were detected, which ensure the high removal efficiency of TN in the systems.

Salinity stress is a common challenge in plant growth, impacting seed quality, germination, and general plant health. Sodium chloride (NaCl) ions disrupt membranes, causing ion leakage and reducing seed viability. Gibberellic acid (GA3) treatments have been found to promote germination and mitigate salinity stress on germination and plant growth. \'Bauer\' and \'Muir\' lettuce (Lactuca sativa) seeds were soaked in distilled water (control), 100 mM NaCl, 100 mM NaCl + 50 mg/L GA3, and 100 mM NaCl + 150 mg/L GA3 in Petri dishes and kept in a dark growth chamber at 25 °C for 24 h. After germination, seedlings were monitored using embedded cameras, capturing red, green, and blue (RGB) images from seeding to final harvest. Despite consistent germination rates, \'Bauer\' seeds treated with NaCl showed reduced germination. Surprisingly, the \'Muir\' cultivar\'s final dry weight differed across treatments, with the NaCl and high GA3 concentration combination yielding the poorest results (p < 0.05). This study highlights the efficacy of GA3 applications in improving germination rates. However, at elevated concentrations, it induced excessive hypocotyl elongation and pale seedlings, posing challenges for two-dimensional imaging. Nonetheless, a sigmoidal regression model using projected canopy size accurately predicted dry weight across growth stages and cultivars, emphasizing its reliability despite treatment variations (R2 = 0.96, RMSE = 0.11, p < 0.001).

Hydatid cyst is the metacestode stage of Echinococcus granulosus that occurs in herbivores and humans as intermediate hosts by consuming parasite eggs through forage and vegetables. Carnivores, as definitive hosts, become infected by consuming infected vesicles of herbivores. The most effective treatment for a hydatid cyst is surgical operation. Inactivating E. granulosus protoscoleces through heating, cooling, or chemicals such as sodium chloride can be considered an effective method for controlling hydatidosis in both humans and animals. The main objective of this study was to evaluate the effect of different temperatures and salinity conditions on the survival of Echinococcus granulosus protoscoleces. For this purpose, 50 g of infected liver (in triplicate) was separately treated with different temperatures (+10°C, +50°C, +60°C, +72°C, and -20°C) and concentrations of sodium chloride (5%, 10%, 15%, and 20%) for 3, 6, 12, 24, 48, and 72 h. Additionally, 50 g of infected liver was stored separately in the refrigerator (+4°C) as a control group. The survival rate of the protoscoleces was evaluated by staining with 1% eosin under a light microscope. The results showed that the protoscoleces were significantly affected, with 100% mortality at -20°C after 0.5 h, and complete death at +72°C, +60°C, +50°C, and +10°C after 1, 1.5, 3, and 24 h, respectively (p < 0.005). Similarly, the protoscoleces in the liver mass survived at 5% NaCl after 3 h but died at 10% after 24 h, at 15% after 12 h, and at 20% after 6 h. It is concluded that exposing the liver infected with protoscoleces hydatid cyst to a temperature of -20°C and a sodium chloride concentration of 10% for 24 h is suitable for inactivating the protoscoleces.

This study investigated microplastic (MP) contamination in conventional sea salt farming systems. Various crude sea salt samples (n = 22) that were traditionally produced were collected from salt farms and local vendors. Salt water (n = 15), macroalgae (n = 6), and clay of pond floors (n = 6) were collected from ponds subjected to different production (stabilization, evaporation, and concentration and crystallization concentration) processes. All samples were analyzed for MP abundance and characteristics. The potential sources of MP contamination in the salt were also investigated. The mean abundance of MPs in the salt water and clay of pond floor increased progressively throughout the production process and reached its highest level in the concentration and crystallization ponds (7400 MP particles/m3 in salt water and 19,336 MP particles/m2 in the clay of the pond floor). A maximum of 26,500 MP particles/kg of macroalgal material indicated the potential sink of MPs on the surface of the algae. Approximately 34-2377 MP particles/kg salt were found in the crude sea salt samples. However, the mean abundance (378 MP particles/kg of salt) indicated nonsignificant impacts of different harvesting processes on MP contamination. Most MP size distributions, shapes and polymer types in the salts were similar to those found in the salt water, macroalgae and clay of the pond floor. Approximately 99% of the MPs were fragments that were suspected to be decomposed from larger plastic debris and plastic machinery and tools used at the salt farm. Similar patterns of polymer distribution, in which PP > PE > PET > PS, were found for all samples studied.

In Europe, respiratory protective devices must be certified before they can be marketed. Among the parameters of interest, inward leakage (IL) characterizes the tightness between the face seal and the face, to verify that the device is well-designed. European standard EN 13274-1 (2001) and International Organization for Standardization (ISO) standard ISO 16900-1 (2019) specify that IL should be measured using sodium chloride (NaCl) aerosol or sulfur hexafluoride (SF6) gas. For reusable masks made of nonporous materials, both test agents are considered equally acceptable. However, the few studies that have compared IL values measured with various aerosols and gases have come to divergent conclusions. This work then aimed to measure IL with the test agents recommended by the standards to determine whether they are really equivalent. Since krypton (Kr) is an interesting candidate for replacing SF6 in standard tests, IL was assessed with SF6 and Kr simultaneously, and with NaCl aerosol using various calculation methods. Tests were carried out on 5 models of full-face masks donned on a headform connected to a breathing machine simulating 3 sinusoidal breathing rates of various intensities. The respirator fit on the headform was evaluated using a controlled negative pressure method to determine a manikin fit factor. Four scenarios were then tested to represent very poor, bad, good, and excellent fit. Gas concentration was measured using a mass spectrometer, and IL was calculated for SF6 and Kr. A combination of 3 devices allowed the determination of the number-based concentration of particles with diameters between 20 nm and 2 µm, and IL was calculated for each of the 33 channels, as well as using a cumulative number concentration. In addition, to comply with standards, a conversion was carried out to calculate IL using a cumulative mass concentration. The results of this work evidenced that the IL values measured with NaCl were systematically lower than those determined with gases. IL was also shown to vary with particle size, with a maximum value exceeding that calculated with cumulative concentrations (in number or mass). As part of the revision of the standards, protocols for measuring inward leakage should be redefined. On the one hand, acceptability thresholds should be re-evaluated according to the nature of the test agent (gas or aerosol), as it is clear that the 2 options do not give the same results for a given configuration. On the other hand, the aerosol leakage measurement protocol needs to be reworked to enable the measurement of a well-defined, robust, and reproducible inward leakage value.

Miscanthus is a perennial grass suitable for the production of lignocellulosic biomass on marginal lands. The effects of salt stress on Miscanthus cell wall composition and its consequences on biomass quality have nonetheless received relatively little attention. In this study, we investigated how exposure to moderate (100 mM NaCl) or severe (200 mM NaCl) saline growing conditions altered the composition of both primary and secondary cell wall components in the stems of 15 Miscanthus sinensis genotypes. The exposure to stress drastically impacted biomass yield and cell wall composition in terms of content and structural features. In general, the observed compositional changes were more pronounced under severe stress conditions and were more apparent in genotypes with a higher sensitivity towards stress. Besides a severely reduced cellulose content, salt stress led to increased pectin content, presumably in the form of highly branched rhamnogalacturonan type I. Although salt stress had a limited effect on the total lignin content, the acid-soluble lignin content was strongly increased in the most sensitive genotypes. This effect was also reflected in substantially altered lignin structures and led to a markedly reduced incorporation of syringyl subunits and p-coumaric acid moieties. Interestingly, plants that were allowed a recovery period after stress ultimately had a reduced lignin content compared to those continuously grown under control conditions. In addition, the salt stress-induced cell wall alterations contributed to an improved enzymatic saccharification efficiency.

Viral diseases are a serious threat to humans while the most antiviral drugs have low efficiency and side effects on human health. Therefore, using microbial biopolymers as the drugs alternate to treat viral infections seems cost-effective and human friendly option. In the present study, thirty-four exopolysaccharides (EPSs) producing bacteria were isolated, and EPSs production capacity of five salt-tolerant isolates was determined under 0, 100 and 150 mM NaCl. Among these, two isolates exhibiting high anti-coliphage activity were identified through 16S rRNA gene analysis. Moreover, the EPSs were characterized by Fourier-transform infrared (FTIR) spectroscopy and X-ray diffraction (XRD) analysis, and their composition was determined. Five salt-tolerant bacteria (MK1, MK2, MK10, MK22 and MK29) exhibited higher production of EPSs at 100 mM NaCl compared to that under non-saline control. At 100 mM NaCl, the yield of EPSs ranged between 105 and 330 mg 100 mL-1 broth. The EPSs produced by the isolates MK1 and MK2 exhibited higher anti-coliphage activity (plaque forming unit decreased from 43 × 106 mL-1 to 3 × 106 and 4 × 106 mL-1, respectively), and were comprised of glucose, fructose, galactose, sucrose, lactose and xylose sugars. FTIR spectroscopy depicted that EPSs are mainly composed of hydroxyl, aliphatic, carboxyl, sulfate and phosphate functional groups, which could have bound coliphage and thus conferred higher anti-coliphage activities to the EPSs. Phylogenetic analysis revealed that MK1 and MK2 isolates formed clades within genus Priestia and Bacillus sequences, respectively. High EPSs production capacity of bacterial isolates under saline condition and high anti-coliphage activity of the EPSs implies that bacterial biopolymers could be useful in antiviral drugs therapy.

Carbon recovery from waste activated sludge has been attracting considerable attention. However, the migration and transformation patterns of carbon sources between the phases have rarely been reported. In this study, a novel strategy using cation exchange resin (CER) coupled with sodium chloride (NaCl) to enhance carbon recovery through anaerobic fermentation (AF) was proposed. The results demonstrated that CER coupled with NaCl destroyed OH and CO stretching in amide I while promoting the formation of β-sheet and random coil structures, leading to sludge disintegration. This significantly improved the kinetics of endogenous carbon release, resulting in the release of 1146.33 mg/L of carbon from the solid sludge into the liquid phase. Approximately 75.61 % of the initial carbon source was bio-transformed into short-chain fatty acids. Correspondingly, carbon recovery was significantly increased up to 852.23 mg C/L, 4.57 times that of the control. Mechanism exploration revealed that carbon source recovery was significantly elevated by the synergistic effect of CER and NaCl. CER effectively removed high-valence cations from extracellular polymeric substance (EPS), weakening its bridging and adsorption-electro neutralization capabilities, promoting protein deflocculation, and triggering EPS disruption to release extracellular carbon sources. NaCl disrupted the ionic strength and distribution inside and outside microbial cells, creating an osmotic pressure difference that resulted in cell plasmolysis and lysis, ultimately inducing the release of intracellular carbon sources. Economic and carbon emission reduction benefit analyses verified that the CER coupled with NaCl pretreatment is a cost-effective sludge treatment strategy. This study illustrates the carbon source migration and transformation pathways in the CER coupled with NaCl-assisted AF process, providing guidance for sustainable sludge management.

暂无摘要。

OBJECTIVE: To determine whether balanced solutions can reduce the incidence of acute kidney injury after off-pump coronary artery bypass surgery compared with saline.
METHODS: Randomized controlled trial.
METHODS: Single tertiary care center.
METHODS: Patients who underwent off-pump coronary artery bypass surgery between June 2014 and July 2020.
METHODS: Balanced solution-based chloride-restrictive intravenous fluid strategy.
RESULTS: The primary outcome was acute kidney injury within 7 postoperative days, as defined by the 2012 Kidney Disease: Improving Global Outcomes Clinical Practice Guideline. The incidence of acute kidney injury was 4.4% (8/180) in the balanced group and 7.3% (13/178) in the saline group. The difference was not statistically significant (risk difference, -2.86%; 95% confidence interval [CI], -7.72% to 2.01%; risk ratio, 0.61, 95% CI, 0.26 to 1.43; p = 0.35). Compared with the balanced group, the saline group had higher levels of intraoperative serum chloride and lower base excess, which resulted in a lower pH.
CONCLUSIONS: In patients undergoing off-pump bypass surgery with a normal estimated glomerular filtration rate, the intraoperative balanced solution-based chloride-restrictive intravenous fluid administration strategy did not decrease the rate of postoperative acute kidney injury compared with the saline-based chloride-liberal intravenous fluid administration strategy.