The kinetics of amyloid aggregation was studied indirectly by monitoring the changes in the polydispersity of mixed dispersion of amyloid β peptide (1-40) and composite liposomes. The liposomes were prepared from the 1,2-dioleoyl-sn-glicero-3-phoshocholine (DOPC) phospholipid and stabilised by the electrostatic adsorption of κ-carrageenan. The produced homotaurine-loaded and unloaded liposomes had a highly negative electrokinetic potential and remarkable stability in phosphate buffer (pH 4 and 7.4). For the first time, the appearance and evolution of the aggregation of Aβ were presented through the variation in the standard percentile readings (D10, D50, and D90) obtained from the particle size distribution analysis. The kinetic experiments indicated the appearance of the first aggregates almost 30 min after mixing the liposomes and peptide solution. It was observed that by adding unloaded liposomes, the size of 90% of the particles in the dispersion (D90) increased. In contrast, the addition of homotaurine-loaded liposomes had almost minimal impact on the size of the fractions of larger particles during the kinetic experiments. Despite the specific bioactivity of homotaurine in the presence of natural cell membranes, this study reported an additional inhibitory effect of the compound on the amyloid peptide aggregation due to the charge effects and \'molecular crowding\'.

Chitosan (CS) has a natural origin and is a biodegradable and biocompatible polymer with many skin-beneficial properties successfully used in the cosmetics and pharmaceutical industry. CS derivatives, especially those synthesized via a Schiff base reaction, are very important due to their unique antimicrobial activity. This study demonstrates research results on the use of hydrogel microspheres made of [chitosan-graft-poly(ε-caprolactone)]-blend-(ĸ-carrageenan)], [chitosan-2-pyridinecarboxaldehyde-graft-poly(ε-caprolactone)]-blend-(ĸ-carrageenan), and chitosan-sodium-4-formylbenzene-1,3-disulfonate-graft-poly(ε-caprolactone)]-blend-(ĸ-carrageenan) as innovative vitamin carriers for cosmetic formulation. A permeation study of retinol (vitamin A), L-ascorbic acid (vitamin C), and α-tocopherol (vitamin E) from the cream through a human skin model by the Franz Cell measurement system was presented. The quantitative analysis of the release of the vitamins added to the cream base, through the membrane, imitating human skin, showed a promising profile of its release/penetration, which is promising for the development of a cream with anti-aging properties. Additionally, the antibacterial activity of the polymers from which the microspheres are made allows for the elimination of preservatives and parabens as cosmetic formulation ingredients.

UNASSIGNED: This study explored the utilization of luffa sponge (LS) in enhancing acetification processes. LS is known for having high porosity and specific surface area, and can provide a novel means of supporting the growth of acetic acid bacteria (AAB) to improve biomass yield and acetification rate, and thereby promote more efficient and sustainable vinegar production. Moreover, the promising potential of LS and luffa sponge coated with κ-carrageenan (LSK) means they may represent effective alternatives for the co-production of industrially valuable bioproducts, for example bacterial cellulose (BC) and acetic acid.
UNASSIGNED: LS and LSK were employed as adsorbents for Acetobacter pasteurianus UMCC 2951 in a submerged semi-continuous acetification process. Experiments were conducted under reciprocal shaking at 1 Hz and a temperature of 32 °C. The performance of the two systems (LS-AAB and LSK-AAB respectively) was evaluated based on cell dry weight (CDW), acetification rate, and BC biofilm formation.
UNASSIGNED: The use of LS significantly increased the biomass yield during acetification, achieving a CDW of 3.34 mg/L versus the 0.91 mg/L obtained with planktonic cells. Coating LS with κ-carrageenan further enhanced yield, with a CDW of 4.45 mg/L. Acetification rates were also higher in the LSK-AAB system, reaching 3.33 ± 0.05 g/L d as opposed to 2.45 ± 0.05 g/L d for LS-AAB and 1.13 ± 0.05 g/L d for planktonic cells. Additionally, BC biofilm formation during the second operational cycle was more pronounced in the LSK-AAB system (37.0 ± 3.0 mg/L, as opposed to 25.0 ± 2.0 mg/L in LS-AAB).
UNASSIGNED: This study demonstrates that LS significantly improves the efficiency of the acetification process, particularly when enhanced with κ-carrageenan. The increased biomass yield, accelerated acetification, and enhanced BC biofilm formation highlight the potential of the LS-AAB system, and especially the LSK-AAB variant, in sustainable and effective vinegar production. These systems offer a promising approach for small-scale, semi-continuous acetification processes that aligns with eco-friendly practices and caters to specialized market needs. Finally, this innovative method facilitates the dual production of acetic acid and bacterial cellulose, with potential applications in biotechnological fields.

The demand for crayfish surimi products has grown recently due to its high protein content. This study examined the effects of varying κ-carrageenan (CAR) and crayfish surimi (CSM) concentrations on the gelling properties of CAR-CSM composite gel and its intrinsic formation process. Our findings demonstrated that with the increasing concentration of carrageenan, the quality of CAR-CSM exhibited rising trend followed by subsequently fall. Based on the textural qualities, the highest quality CAR-CSM was achieved at 0.3% carrageenan addition. With the exception of chewiness, and the cooking loss of the gel system was 1.62%, whiteness was 82.35%, and the percentage of β-sheets increased to 57.18%. Further increase in CAR (0.4-0.5%) addition resulted in internal build-up of LCAR-CSM, conversion of intermolecular forces into disulfide bonds and gel breakage. This study exudes timely recommendations for extending the CAR application for the continuous development of crayfish surimi and its derivatives and its overall economic worth.

Problems with minced pork include water release and low gel strength. This study aimed to investigate the effect of treatments with κ-carrageenan (κ-CAR), egg white powder (EWP), wheat gluten (WG), soy isolate protein (SPI), and a combination of these treatments on the gel properties and protein structures of minced pork. The cooking loss and trapped water within minced pork increased when additives were incorporated; in particular, the SPI group reached 1.31 ± 0.01% and 91.42 ± 0.20%. The hardness and chewiness of minced pork reached their maximum values (38.91 ± 0.80 N, 14.73 ± 0.41 N) when the WG was added. The κ-CAR/WG-minced pork gel network structure was the densest and most stable, characterized by increased hydrophobic interactions, disulfide bonds in the mince gel, and enthalpy value. The α-helix content with κ-CAR/WG treatment decreased from 27% to 7.8%, transforming into other secondary structures. This suggests that the addition of κ-CAR/WG can be a more effective combination for improving the quality of minced pork.

κ-Carrageenan is a sulfated polysaccharide from red seaweed with substantial antioxidant activities. This study aimed to investigate the effect of κ-Carrageenan treatment on frozen-thawed (FT) porcine semen quality. Therefore, the spermatozoa were diluted and cryopreserved in a freezing extender supplemented with 0 (control), 0.2, 0.4, 0.6, and 0.8 mg/mL κ-Carrageenan. Sperm kinematics were assessed immediately after thawing (AT) and post-incubation for 120 min. The viability, acrosome integrity, lipid peroxidation, mitochondrial membrane potential (MMP), and intracellular caspase activity were measured AT. The results indicated that 0.2 mg/mL κ-Carrageenan increased total and progressive motility AT and post-incubation for 120 min (p < 0.05). Moreover, the viable sperm percentage and MMP after 0.2 mg/mL treatment were higher than those after control and other κ-Carrageenan concentration treatments. The proportion of acrosome-intact spermatozoa was significantly higher after 0.2 and 0.4 mg/mL κ-Carrageenan treatment than that after control and other κ-Carrageenan concentration treatments. The intracellular caspase activity was not significantly different among the experimental groups. However, the MDA concentration after 0.2 mg/mL κ-Carrageenan treatment was lower (p < 0.05) than that after the control treatment. Taken together, adding κ-Carrageenan to the porcine semen freezing extender improved the FT sperm quality mainly by influencing membrane stability and protecting against oxidative stress.

Plant-based hard capsules have gained considerable attention because of their great properties. Accordingly, designing and developing of these kinds of capsules will be a difficult task. Herein, an innovative pullulan-based hard capsule formulation was prepared for the first time. A series of characterization approaches, including Fourier transform infrared, field emission scanning electron microscope, and rheology analysis, were utilized to figure out the straightforward preparation of a designed hard capsule. Many tests and experiments were performed to achieve the optimum capsule formulation. Based on the obtained results, specifications such as uniform downfall and non-desirable adhesion, and other ideal characteristics of the capsule display the critical function. The gelling promoter of divalent cationic salts is more beneficial than its single-valent counterparts. With respect to the key role of gelling promoter, the presence of chosen MgSO4.7H2O salt and the source of selected carrageenan are important parameters to achieve optimal formulation. Moreover, field emission scanning electron microscope images illustrate that the weight ratio of 3.5 (gelling agent to salt) displays uniform surface morphology without any impurities or other foreign materials. Likewise, the outcomes of the rheology test also illustrated that the weight ratio of 3.5 is preferable. Considering the different weight ratios, the benefits of a weight ratio of 3.5 outweigh the other investigated ratios. Overall, the current research addresses substantial information about developing pullulan-based hard capsules for target usage.

To accurately, efficiently, and environmentally prepare carrageenan oligosaccharides, we have developed a method that uses H2O2 and TiO2 as catalysts for the photodegradation of κ-carrageenan (KC). The photodegradation of KC was monitored using various amounts of TiO2 and H2O2 and different concentrations of KC via HPLC and it could decrease the average molecular weight of KC into 1.6 kDa within 2 h. Further research under optimal conditions. As a control, the effects of UV, UV/H2O2, UV/TiO2, and H2O2/TiO2 treatments were studied. In contrast, UV/H2O2/TiO2 treatments showed a coordinated effect. The effect of degradation on the structure of KC was investigated by FT-IR, XRD, and there was no obvious remotion of sulfate groups. Furthermore, oral administration of KCO prolonged the healthy lifespan of nematodes induced by ultraviolet stress and significantly regulated oxidative stress. This study suggests that the precise preparation and application of KCO may be beneficial.

More understanding of the relationship among the microstructure, mechanical property, and digestive behavior is essential for the application of emulsion gels in the food industry. In this study, heat-denatured pea protein isolate particles and κ-carrageenan were used to fabricate cold-set emulsion gels induced by CaCl2, and the effect of κ-carrageenan concentration on the gel formation mechanism, microstructure, texture, and digestive properties was investigated. Microstructure analysis obtained by confocal microscopy and scanning electron microscopy revealed that pea protein/κ-carrageenan coupled gel networks formed at the polysaccharide concentration ranged from 0.25% to 0.75%, while the higher κ-carrageenan concentration resulted in the formation of continuous and homogenous κ-carrageenan gel networks comprised of protein enriched microdomains. The hydrophobic interactions and hydrogen bonds played an important role in maintaining the gel structure. The water holding capacity and gel hardness of pea protein emulsion gels increased by 37% and 75 fold, respectively, through increasing κ-carrageenan concentration up to 1.5%. Moreover, in vitro digestion experiments based on the INFOGEST guidelines suggested that the presence of 0.25% κ-carrageenan could promote the digestion of lipids, but the increased κ-carrageenan concentration could delay the lipid and protein hydrolysis under gastrointestinal conditions. These results may provide theoretical guidance for the development of innovative pea protein isolate-based emulsion gel formulations with diverse textures and digestive properties.

This article presents research on biodegradable stretch sensors produced using biological material. This sensor uses a piezoresistive effect to indicate stretch, which can be used for force measurement. In this work, an attempt was made to develop the composition of a sensitive material and to design a sensor. The biodegradable base was made from a κ-carrageenan compound mixed with Fe2O3 microparticles and glycerol. The influence of the weight fraction and iron oxide microparticles on the tensile strength and Young\'s modulus was experimentally investigated. Tensile test specimens consisted of 10-25% iron oxide microparticles of various sizes. The results showed that increasing the mass fraction of the reinforcement improved the Young\'s modulus compared to the pure sample and decreased the elongation percentage. The GF of the developed films varies from 0.67 to 10.47 depending on composition. In this paper, it was shown that the incorporation of appropriate amounts of Fe2O3 microparticles into κ-carrageenan can achieve dramatic improvements in mechanical properties, resulting in elongation of up to 10%. The developed sensors were experimentally tested, and their sensitivity, stability, and range were determined. Finally, conclusions were drawn on the results obtained.