There is growing emphasis on developing green composites as a substitute for oil-based materials. In the pursuit of studying and enhancing the mechanical properties of these composites, tensile tests are predominantly employed, often overlooking the flexural properties. This study focuses on researching the flexural properties of abaca-fiber-reinforced bio-based high-density polyethylene (BioPE) composites. Specifically, composites containing 30 wt% of abaca fiber (AF) were treated with a coupling agent based on polyethylene functionalized with maleic acid (MAPE). The test results indicate that incorporating 8 wt% of the coupling agent significantly improved the flexural strength of the composites. Thereafter, composites with AF content ranging from 20 to 50 wt% were produced and subjected to flexural testing. It was observed that flexural strength was positively correlated with AF content. A micromechanics analysis was conducted to evaluate the contributions of the phases. This analysis involved assessing the mechanical properties of both the reinforcement and matrix to facilitate the modeling of flexural strength. The findings of this study demonstrate the feasibility of replacing oil-based matrices, such as high-density polyethylene (HDPE), with fully bio-based composites that exhibit comparable flexural properties to their oil-based counterparts.

The ECETOC NanoApp was developed to support industry in the registration of sets of nanoforms, as well as regulators in the evaluation of these registration dossiers. The ECETOC NanoApp uses a systematic approach to create and justify sets of similar nanoforms, following the ECHA guidance in a transparent and evidence-based manner. The rational and decision rules behind the ECETOC NanoApp are described in detail in \"Janer, G., R. Landsiedel, and W. Wohlleben. 2021. [Rationale and Decision Rules Behind the ECETOC NanoApp to Support Registration of Sets of Similar Nanoforms within REACH. Nanotoxicology 15 (2): 145-122. https://doi.org/10.1080/17435390.2020.1842933]\". The decision criteria apply to human health and environmental hazards and risks. Here, we focus mostly on human health hazards; the decision rules are applied to a series of case studies, each consisting of real nanoforms: two barium sulfate nanoforms, four colloidal silica nanoforms, eight ceria nanoforms, and four copper phthalocyanine nanoforms. For each of them, we show step by step how the ECETOC NanoApp rules are applied. The cases include nanoforms that are justified as members of the same set of similar nanoforms based on sufficient similarity of their intrinsic properties (Tier 1). They also include other nanoforms with a relatively high (but insufficient) similarity of intrinsic properties; their similarity could be justified by functional properties (Tier 2). The case studies also include nanoforms that are concluded not to belong to the same set of similar nanoforms. These outcomes of the NanoApp were overall consistent (sometimes conservative) with available in vivo data. We also noted that datasets for various nanoforms were limited and use of the NanoApp may require the generation of data relevant to the decision criteria.