This study aims to conduct a comprehensive analysis of switching disinfectants from sodium hypochlorite bleach to chlorine dioxide (ClO2) in the water distribution system of Geyikbayiri, Antalya. For this purpose, bulk decay rates of ClO2 at various water temperatures were determined in laboratory studies. The study revealed ClO2 bulk decay rates of 0.12639 day-1, 0.17848 day-1, and 0.19621 day-1 at temperatures 15°C, 20°C, and 30°C, respectively. The EPANET, a widely employed computer program for simulating the extended-period behavior of hydraulic and water quality in pressurized pipes, was utilized for the analysis of the fate and transport of ClO2. A hydraulic model was first developed, calibrated, and verified using distinct data sets. The Hazen-Williams friction coefficient of the PSA was determined to be 120 by the trial-and-error method with a mean absolute error (MAE) of 0.408 m. A ClO2 model was then integrated with the calibrated and verified hydraulic model, revealing a wall decay rate of 0.01 m/day and an average MAE of 0.034 mg/l. After calibration and verification of the ClO2 model, several management scenarios were developed, and ClO2 dosing rates were determined. The study showed that ClO2 dosing rates of 0.40 mg/l and 0.45 mg/l should be applied to keep ClO2 concentrations within certain limits. PRACTITIONER POINTS: Disinfectants must maintain a sufficient residual in water distribution systems. Chlorine dioxide requires less contact time and is not affected by pH fluctuations. Modeling serves as a decision-making tool for the management of disinfectants. Bulk and wall decay rates of chlorine dioxide are crucial for management strategies. Chlorine dioxide is a good alternative as a disinfectant in such systems.

Disinfection byproducts (DBPs) have demonstrated cardiovascular and reproductive toxicity. However, the associations and mechanisms of DBP exposure in relation to hypertension among healthy young men, which are critical for gaining new insights into the prevention and treatment of male subfertility, remain unclear. In 2017-2018, we recruited 1162 healthy Chinese men. A single blood sample was collected and measured for trihalomethane (THM) concentrations (n = 956). Up to 2930 repeated urinary samples were collected at baseline and during follow-up periods and determined for haloacetic acid concentrations. Oxidative stress (OS) biomarkers were measured in within-subject pooled urinary samples (n = 1003). In total, 403 (34.68 %) participants were diagnosed with stage 1-2 hypertension (≥130/80 mmHg) and 108 (9.29 %) stage 2 hypertension (≥140/90 mmHg). In adjusted models, blood bromodichloromethane (BDCM) concentrations were positively associated with the risk of stage 1-2 and stage 2 hypertension [ORs= 1.48 (95 % CI: 1.15, 1. 91) and 1.65 (95 % CI: 1.08, 2.51), respectively, per 2.7-fold increase in BDCM concentrations]. Additionally, we found positive associations between DBP exposure biomarkers and urinary concentrations of 4-hydroxy-2-nonenal-mercapturic acid and 8-hydroxy-2-deoxyguanosine. However, these OS biomarkers were unrelated to hypertension. Our results suggest that BDCM exposure may be associated with a greater risk of hypertension among healthy young men.

Since the onset of the SARS-CoV-2 pandemic in early 2020, there has been a notable rise in sodium hypochlorite disinfectants. Sodium hypochlorite undergoes hydrolysis to generate hypochlorous acid for virus eradication. This chlorine-based disinfectant is widely utilized for public disinfection due to its effectiveness. Although sodium hypochlorite disinfection is convenient, its excessive and indiscriminate use can harm the water environment and pose a risk to human health. Hypochlorous acid, a reactive oxygen species, plays a crucial role in the troposphere, stratospheric chemistry, and oxidizing capacity. Additionally, hypochlorous acid is vital as a reactive oxygen species in biological systems, and its irregular metabolism and level is associated with several illnesses. Thus, it is crucial to identify hypochlorous acid to comprehend its environmental and biological functions precisely. Here, we constructed a new fluorescent probe, utilizing the twisted intramolecular charge transfer mechanism to quickly and accurately detect hypochlorous acid in environmental water and biosystems. The probe showed a notable increase in fluorescence when exposed to hypochlorous acid, demonstrating its excellent selectivity, fast response time (less than 10 seconds), a large Stokes shift (∼ 102 nm), and a low detection limit of 15.5 nM.

Although biocides are important materials in modern society and help protect human health and the environment, increasing exposure to combined biocides can cause severe side effects in the human body, such as lung fibrosis. In this study, we developed a receptonics system to screen for biocides in combined household chemical products based on biocides. The system contains transient receptor potential ankyrin 1 (TRPA1) nanovesicles (NVs) to sense biocides based on pain receptors and a side-gated field-effect transistor (SGFET) using a single-layer graphene (SLG) micropattern channel. The binding affinities between the TRPA1 receptor and the various biocides were estimated by performing biosimulation and using a calcium ion (Ca2+) assay, and the sensitivity of the system was compared with that of TRPA1 NV receptonics systems. Based on the results of the TRPA1 NV receptonics system, the antagonistic and potentiation effects of combined biocides and household chemical products depended on the concentration. Finally, the TRPA1 NV receptonics system was applied to screen for biocides in real products, and its performance was successful. Based on these results, the TRPA1 NV receptonics system can be utilized to perform risk evaluations and identify biocides in a simple and rapid manner.

Wastewater treatment plants and water reclamation facilities are reservoirs of antimicrobial resistance genes (ARGs). These ARGs are not limited solely to intracellular DNA (inARGs) but include extracellular DNA (exARGs) present in wastewater. The release of exARGs from cells can be exacerbated by treatment processes, including chlorine disinfection, which disrupts bacterial cells. Given the potential for exARGs to drive horizontal gene transfer and contribute to the proliferation of antimicrobial resistance, it is imperative to recognize these fractions as emerging environmental pollutants. In this study, we conducted a comprehensive year-long assessment of both inARGs and exARGs, further differentiating between dissolved exARGs (Dis_exARGs) and exARGs adsorbed onto particulate matter (Ads_exARGs), within a full-scale wastewater treatment and water reclamation facility. The results revealed that Ads_exARGs comprised up to 30 % of the total ARGs in raw sewage with high biomass content. Generally, treatments at low and high doses of chlorine increased the abundance of Dis_exARGs and Ads_exARGs. The fate of ARG levels that varied depending on the type of ARGs suggested variations in the susceptibility of the host bacteria to chlorination. Moreover, co-occurrence of several potential opportunistic pathogenic bacteria and ARGs were observed. Therefore, we propose higher doses of chlorination as a prerequisite for the effective removal of inARGs and exARGs.

Infectious diseases are a leading cause of losses in the aquaculture industry and conservation programs globally. Simultaneously, infectious diseases pose a substantial risk to fish being hatchery-reared and released into natural habitats for conservation purposes, including the Great Lakes lake sturgeon (Acipenser fulvescens, i.e., GL-LST). Recently, an alloherpesvirus (lake sturgeon herpesvirus 2, i.e., LSHV-2) capable of inducing disease and/or mortality in adult and juvenile GL-LSTs was detected in two adult GL-LST populations. To begin developing disease prevention and/or control methods, in vitro experiments were designed to determine the susceptibility of LSHV-2 to disinfectants commonly used in hatchery and aquaculture facilities (Virkon®-Aquatic: potassium peroxymonosulfate; Ovadine®: polyvinylpyrrolidone iodine complex; and Perox-Aid®: hydrogen peroxide). Cultured LSHV-2 was exposed to each disinfectant at two concentrations (Virkon®-Aquatic: 0.5% and 1%; Ovadine®: 50 and 100 ppm; and Perox-Aid®: 500 and 1000 ppm) in duplicate for durations of 1, 10, and 30 min. Following exposure, the disinfectant was neutralized, and after a 14-day incubation period on a white sturgeon × lake sturgeon hybrid cell line (WSxLS), percent reduction was calculated by comparing the 50% tissue culture infectious doses (TCID50/mL) of the virus with and without disinfectant exposure. When exposed to Perox-Aid®, LSHV-2 percent reduction ranged from 58.7% to 99.5%. When exposed to Ovadine®, the percent reduction ranged from 99.4% to 100%. Lastly, the percent reduction when exposed to Virkon®-Aquatic was 100% for both concentrations and all timepoints. The results herein provide evidence that both Virkon®-Aquatic and Ovadine® are virucidal to LSHV-2 and may represent a means to reduce virus transmission risk under field settings.

Viruses impose a significant public health burden globally, and one of the key elements in controlling their transmission is the ability to inactivate them using disinfectants. However, numerous challenges to inactivating foodborne viruses exist due to inherent viral characteristics (such as recalcitrance to commonly used inactivation agents) and external factors (such as improper cleaning before application of inactivation agent, improper contact time, etc.). Given the potential for improper application of disinfectants (such as shorter than recommended contact time, improper disinfectant concentration, etc.), understanding the performance of a disinfectant in the presence of an organic load is important. To accomplish this, the introduction of simulated organic loads is often used when studying the efficacy of a disinfectant against different viruses. However, the different types of simulated organic loads used in foodborne virus inactivation studies or their relative effects on inactivation have not been reviewed. The purpose of this review is to survey different simulated organic load formulations used in studying foodborne virus inactivation, as well as present and compare the influence of these different formulations on viral inactivation. The findings included in this review suggest that many simulated organic load formulations can reduce disinfectants\' efficacy against viruses. Based on the findings in this review, blood, particularly serum or feces, are among the most commonly used and efficacious forms of simulated organic load in many tests.

Glabridin is an antimicrobial compound which can be extracted from plants, such as liquorice (Glycyrrhiza glabra) roots. Although its activity against foodborne pathogens and spoilage microorganisms has already been reported, the investigation of potential applications as a surface disinfectant is still largely unexplored. Hence, this study evaluated the disinfectant efficacy of glabridin against Listeria monocytogenes. The activity of glabridin was first tested in vitro in a nutrient-rich medium against eight strains of L. monocytogenes, including food isolates and the model strain EGDe. The tested strains showed similar susceptibility with minimal inhibitory and bactericidal concentrations of 12.5 µg/mL and 25 µg/mL, respectively. Subsequently, L. monocytogenes L6, FBR17 and EGDe were selected to assess the efficacy of glabridin against dried cells (according to the European standard EN 13697:2015 + A1:2019) and biofilm cells on stainless steel surfaces. Moreover, the impact of food residual organic matter was investigated using skim milk, cantaloupe and smoked salmon solution as soiling components. Our results showed that applying 200 µg/mL of glabridin resulted in a substantial reduction (>3 log10) of dried and biofilm cells of L. monocytogenes in standard conditions (i.e. low level of residual organic matter). Cantaloupe soiling components slightly reduced the activity of glabridin, while the efficacy of glabridin when tested with salmon and skim milk residuals was substantially affected. Comparative analysis using standardized protein contents provided evidence that the type of food matrices and type of proteins may impact the activity of glabridin as a disinfectant. Overall, this study showed low strain variability for the activity of glabridin against L. monocytogenes and shed light on the possible application of this natural antimicrobial compound as a surface disinfectant.

Sanitizer spray and brush roller treatments have been documented as an effective means of reducing Salmonella on the surface of produce. The purpose of this study was to evaluate the efficacy of chlorine (NaOCl), peroxyacetic acid (PAA), and chlorine dioxide (ClO2) sprays to reduce Salmonella populations on the surface of mangoes during washing with brush or polyvinyl chloride (PVC) rollers. Whole mangoes were spot inoculated with 100 µL of a rifampicin-resistant Salmonella (8 log CFU/mL) cocktail at the equator and dried for 1 h. Mangoes were washed with a lab-scale roller system with either ground water (control), or sanitizers (100 ppm NaOCl, 80 ppm PAA, or 5 ppm ClO2) for 0, 5, 15, 30, or 60 s (n = 15 mangoes). Dey/Engley buffer (100 mL) was used to rinse mangoes before plating on media supplemented with rifampicin. NaOCl, PAA, and ClO2 spray (except for ClO2 at 30 s) had significantly higher reduction on Salmonella population than water spray at all treatment times (P ≤ 0.05) when brush rollers were used. All tested sanitizers also achieved a significantly higher reduction than water at 5 s when PVC rollers were used (P ≤ 0.05). Salmonella reductions achieved by brush and PVC rollers was not statistically different (P > 0.05). After a 5 s treatment on brush and PVC rollers, NaOCl, PAA, and ClO2 spray had ca. 3.03 and 3.45 log, 3.96 and 3.28 log, and 2.54 and 2.00 log CFU/mango reductions, respectively, whereas water spray achieved 1.75 and 0.98 log CFU/mango reduction. Addition of sanitizers to spray water used during brush or PVC washing in mango packinghouses can reduce Salmonella on mango surfaces.

Marine biofouling, caused by the deposition and accumulation of marine organisms on submerged surfaces, represents a huge concern for the maritime industries and also contributes to environmental pollution and health concerns. The most effective way to prevent this phenomenon is the use of biocide-based coatings which have proven to cause serious damage to marine ecosystems. Several research groups have focused on the search for new environmentally friendly antifoulants, including marine and terrestrial natural products and synthetic analogues. Some of these compounds have been incorporated into marine coatings and display interesting antifouling activities caused by the interference with the biofilm-forming species as well as by the inhibition of the settlement of macroorganisms. This review highlights the proof-of-concept studies of emerging natural or synthetic antifouling compounds in coatings, from lab-made to commercial ones, performed between 2019 and 2023 and their results in the field or in in vivo laboratorial tests.