BACKGROUND: Myocardial infarction is one of the major health challenges. It is of great significance to develop potential delivery carriers for new anti-myocardial infarction drugs. In this paper, based on first-principles calculations, monolayer WS2 with excellent photoelectric properties was verified as a carrier for the anti-myocardial infarction drug amiodarone (AMD). Studies have shown that the WS2-adsorbed AMD system (WS2@AMD) maintains structural stability and produces an adsorption energy of-2.12 eV. Mulliken charge analysis shows that electrons are transferred from WS2 atoms to AMD atoms. Among them, C, N and O obtained the maximum values of 0.51,0.37 and 0.56 e electrons, respectively, while H and I lost the maximum values of 0.32 and 0.24 e electrons, respectively. The optical response of WS2 adsorbed AMD system is similar to that of WS2. The light absorption coefficients of the two materials in the near ultraviolet region and the visible region can reach the order of 105 cm-1 and 104 cm-1, and the strain makes the light absorption peak red-shifted. The feasibility of temperature-controlled release mechanism of WS2 as AMD carrier was discussed. This theoretical work helps to improve the performance of two-dimensional nanomaterials and make them better as drug delivery carriers to improve the therapeutic effect of myocardial infarction. These results indicate that the WS2 monolayer has potential applications in the development of drug delivery carriers.
METHODS: In this study, based on first-principles calculations, the CASTEP simulation software package was used to study the structure and properties of materials. The interaction between electrons and ions is considered by using Ultrasoft pseudopotentials. In order to eliminate the spurious interaction between adjacent structures caused by periodic calculations, a vacuum space no less than 18 Å is placed in the vertical direction if necessary. Different functions may produce different density functional calculation results. Due to the low sensitivity of the crystal structure to the calculation details, the PBE functional under the generalized gradient approximation (GGA) was initially used for structural optimization, and the energy cutoff value was set to 500 eV. Grimme \'s dispersion correction was used to make the results more accurate. The Brillouin zone (BZ) is sampled by a 7 × 7 × 1 K-point grid to ensure the reliability of the original lattice calculation. The lattice vector and atomic coordinates are relaxed, and the tolerance of each atom is less than 0.01 eV/Å. The energy tolerance at the atomic position is less than 10-7 eV/atom. When calculating the band gap, the HSE06 hybrid functional is used to modify the optimized structure of the PBE functional to obtain more accurate results. Spin-polarized DFT calculations were performed to calculate the electronic structure.

As a kind of aminoglycoside antibiotics, kanamycin (KAN) is widely applied to animal husbandry and aquaculture. However, the abuse of KAN causes the large-scale discharge of it into rivers, lakes and groundwater, which threatens environmental safety and human health. Therefore, it is imperative to develop a method that is applicable to detect KAN in an efficient and accurate way. The colorimetric method based on enzymes provides a feasible solution for the detection of organic pollutants. However, the extensive application of natural enzymes is constrained by high cost and low stability. Herein, a polyoxometalate-based nanozyme, namely [H7SiW9V3O40(DPA)3]·4H2O (SiW9V3/DPA) (DPA = dipyridylamine), is synthesized. As a low-cost nanozyme with high stability compared to natural enzymes, SiW9V3/DPA performs well in laccase-mimicking activity. It can be used to induce chromogenic reaction between 2,4-dichlorophenol (2,4-DP) and 4-aminoantipyrine (4-AP), which generates red products. With the addition of KAN, the color fades. That is to say, KAN can be detected with colorimetric assay in the concentration range 0.1 to 100 μM with high selectivity and low limit of detection (LOD) of 6.28 μM. Moreover, SiW9V3/DPA is applied to KAN detection in lake and river water and milk with satisfactory results. To sum up, polyoxometalate-based nanozyme is expected to provide a promising solution to the detection of organic pollutants in the aquatic environment.

Diabetes-related slow healing of wounds is primarily driven by bacterial infections and angiogenesis disorder and presents a substantial hurdle in clinical treatment. To solve the above problems, an advanced multifunctional hydrogel system based on natural polymer was created here to facilitate wound healing in patients with chronic diabetes. The prepared dressing was composed of an outer hydrogel containing polyvinyl alcohol and hydroxypropyl methyl cellulose in dimethyl sulfoxide and water as binary solvents, and an inner hydrogel containing chitosan quaternary ammonium salt, flaxseed gum, and polyvinyl alcohol. Thus, a polysaccharide based bilayer hydrogel (BH) with superior mechanical strength and biocompatibility was created. This bilayer hydrogel could easily bind to dynamic tissue surfaces, thereby generating a protective barrier. Meanwhile, L-arginine-modified polyoxometalate (POM@L-Arg) nanoclusters were loaded in the inner hydrogel. They released NO when stimulated by the peroxide microenvironment of diabetic wounds. NO as a signal molecule regulated vascular tension and promoted cell proliferation and migration. Additionally, because of the synergistic effect of NO and the chitosan quaternary ammonium salt, the hydrogel system exhibited excellent antibacterial performance. The NO released reduced the levels of proinflammatory factors IL-6 and TNF-α in the diabetic wounds, which thus accelerated wound healing. In short, BH + POM@L-Arg is expected to serve as an ideal wound dressing as it exerts a good promotion effect on diabetes-related wound healing.

A tungsten disulfide (WS2) nanosheet-based aptamer sensor was developed to detect patulin (PAT). The 5\'-end of the PAT aptamer was modified with a cyanine 3 (Cy3) fluorophore, which self-assembled on WS2 nanosheets. The interaction between the Cy3 fluorophore at the 5\'-end of the PAT aptamer and the WS2 nanosheets resulted in reduced fluorescence (FL) intensity due to fluorescence resonance energy transfer (FRET). The introduction of PAT into this sensing system led to hybridization with the PAT aptamer, forming a G-quadruplex/PAT complex with low affinity for the WS2 nanosheet surface. This hybridization increased the distance between the Cy3 fluorophore and the WS2 nanosheets, inhibiting FRET and producing a strong FL signal. Under optimal experimental conditions, the FL intensity of the sensing system demonstrated an excellent linear correlation with PAT concentrations ranging from 0.5 to 40.0 ng mL-1, and it achieved a detection limit (S/N = 3) of 0.23 ng mL-1. This sensing system offers enhanced specificity for PAT detection and has the potential for broad application in detecting other toxins by substituting the sequence of the recognition aptamer.

The Preyssler-type polyoxotungstate ({P5W30}) belongs to the family of polyanionic metal-oxides formed by group V and VI metal ions, such as V, Mo and W, commonly known as polyoxometalates (POMs). POMs have demonstrated inhibitory effect on a significant number of ATP-binding proteins in vitro. Purinergic P2 receptors, widely expressed in eukaryotic cells, contain extracellularly oriented ATP-binding sites and play many biological roles with health implications. In this work, we use the immortalized mouse hippocampal neuronal HT-22 cells in culture to study the effects of {P5W30} on the cytosolic Ca2+ concentration. Changes in cytosolic Ca2+ concentration were monitored using fluorescence microscopy of HT-22 cells loaded with the fluorescent Ca2+ indicator Fluo3. 31P-Nuclear magnetic resonance measurements of {P5W30} indicate its stability in the medium used for cytosolic Ca2+ measurements for over 30 min. The findings reveal that addition of {P5W30} to the extracellular medium induces a sustained increase of the cytosolic Ca2+ concentration within minutes. This Ca2+ increase is triggered by extracellular Ca2+ entry into the cells and is dose-dependent, with a half-of-effect concentration of 0.25 ± 0.05 μM {P5W30}. In addition, after the {P5W30}-induced cytosolic Ca2+ increase, the transient Ca2+ peak induced by extracellular ATP is reduced up to 100% with an apparent half-of-effect concentration of 0.15 ± 0.05 μM {P5W30}. Activation of metabotropic purinergic P2 receptors affords about 80% contribution to the increase of Fluo3 fluorescence elicited by {P5W30} in HT-22 cells, whereas ionotropic receptors contribute, at most, with 20%. These results suggest that {P5W30} could serve as a novel agonist of purinergic P2 receptors.

Recently, the hazardous effects of antibiotic micropollutants on the environment and human health have become a major concern. To address this challenge, semiconductor-based photocatalysis has emerged as a promising solution for environmental remediation. Our study has developed Bi2WO6/g-C3N4 (BWCN) photocatalyst with unique characteristics such as reactive surface sites, enhanced charge transfer efficiency, and accelerated separation of photogenerated electron-hole pairs. BWCN was utilized for the oxidation of tetracycline antibiotic (TCA) in different water sources. It displayed remarkable TCA removal efficiencies in the following order: surface water (99.8%) > sewage water (88.2%) > hospital water (80.7%). Further, reusability tests demonstrated sustained performance of BWCN after three cycles with removal efficiencies of 87.3, 71.2 and 65.9% in surface water, sewage, and hospital water, respectively. A proposed photocatalytic mechanism was delineated, focusing on the interaction between reactive radicals and TCA molecules. Besides, the transformation products generated during the photodegradation of TCA were determined, along with the discussion on the potential risk assessment of antibiotic pollutants. This study introduces an approach for utilizing BWCN photocatalyst, with promising applications in the treatment of TCA from various wastewater sources.

Zinc tungstate is a semiconductor known for its favorable photocatalytic, photoluminescence, and scintillation properties, coupled with its relatively low cost, reduced toxicity, and high stability in biological and catalytic environments. In particular, zinc tungstate evinces scintillation properties, namely the ability to emit visible light upon absorption of energetic radiation such as x rays, which has led to applications not only as radiation detectors but also for biomedical applications involving the delivery of optical light to deep tissue, such as photodynamic therapy and optogenetics. Here, we report on the synthesis of zinc tungstate nanorods generated via an optimized but facile method, which allows for synthetic control over the aspect ratio of the as-synthesized anisotropic motifs via rational variation of the solution pH. We investigate the effect of aspect ratio on their resulting photoluminescent and radioluminescent properties. We further demonstrate the potential of these zinc tungstate nanorods for biomedical applications, such as photodynamic therapy for cancer treatment, by analyzing their toxicological profile within cell lines and neurons.

Here we report the liquid-solid interaction in droplet-based triboelectric nanogenerators (TENG) for estimation of human Na+/K+levels. The exploitation of PVDF-HFP encapsulated WS2as active layer in the droplet-based TENG (DTENG) leads to the generation of electrical signal during the impact of water droplet. Comparison over the control devices indicates that surface quality and dielectric nature of the PVDF-HFP/WS2composite largely dictates the performance of the DTENG. The demonstration of excellent sensitivity of the DTENG towards water quality indicates its promising application towards water testing. In addition, the alteration in output signal with slightest variation in ionic concentration (Na+or K+) in water has been witnessed and is interpreted with charge transfer and ion transfer processes during liquid-solid interaction. The study reveals that the ion mobility largely affects the ion adsorption process on the active layer of PVDF-HFP/WS2and thus generates distinct output profiles for diverse ions like Na+and K+. Following that, the DTENG characteristics have been exploited to artificial urine where the varying output signals have been recorded for variation in urinary Na+ion concentration. Therefore, the deployment of PVDF-HFP/WS2in DTENG holds promising application towards the analyse of ionic characteristics of body fluids.

The reduction of carbon dioxide (CO2) and nitrogen (N2) to value-added products is a substantial area of research in the fields of sustainable chemistry and renewable energy that aims at reducing greenhouse gas emissions and the production of alternative fuels and chemicals. The current work deals with the synthesis of pyrochlore-type europium stannate (Eu2Sn2O7: EuSnO), tungsten disulfide (WS2:WS), and novel EuSnO/WS heterostructure by a simple and facile co-precipitation-aided hydrothermal method. Using different methods, the morphological and structural analyses of the prepared samples were characterized. It was confirmed that a heterostructure was formed between the cubic EuSnO and the layered WS. Synthesized materials were used for photocatalytic CO2 and N2 reduction under UV and visible light. The amount of CO and CH4 evolved due to CO2 reduction is high in EuSnO/WS (CO = 104, CH4 = 64 μmol h-1 g-1) compared to pure EuSnO (CO = 36, CH4 = 70 μmol h-1 g-1) and WS (CO = 22, CH4 = 1.8 μmol h-1 g-1) under visible light. The same trend was observed even in the N2 fixation reaction under visible light, and the amount of NH4+ produced was found to be 13, 26, and 41 μmol h-1 g-1 in the presence of WS, EuSnO and EuSnO/WS, respectively. Enhanced light-driven activity towards CO2 and N2 reduction reactions in EuSnO/WS is due to the efficient charge separation through the formation of type-II heterostructure, which is in part associated with photocurrent response, photoluminescence, and electrochemical impedence spectroscopic (EIS) results. The EuSnO/WS heterostructure\'s exceptional stability and reusability may pique the attention of pyrochlore-based composite materials in photocatalytic energy and environmental applications.

The cytotoxic of α-Ag2WO4 synthesized in different morphologies (cuboidal (AW-C), hexagonal rod-like (AW-HRL) and nanometric rod-like (AW-NRL) was analyzed to understand the impact of morphological modulation on the toxicity of 3 T3 cell lines in the dark and when photoactivated by visible light. Pathways of toxicity were examined, such as parameters and electrostatic interaction, uptake, ion release and ROS production. Cytotoxicity was observed for all samples after reaching concentrations exceeding 7.8 μg/mL. Uptake tests demonstrated that the samples were not internalized by cells, likely due to their negative surface charge. AW-NRL exhibited autophagy in the absence of light and during photoactivation, primarily attributed to its ability to generate singlet oxygen. Analyzing intercellular ROS and RNS production, AW-HRL induced an increase in NO through exposure to photo-generated hydroxyl radicals, while AW-NRL showed increases only at non-photoactivated concentrations and AW-C did not exhibit increases. Interestingly, in the dark, these cells showed a low propensity for apoptosis, with late apoptosis and necrosis being more pronounced. When photoactivated, this behavior changed, revealing predominantly apoptotic and late apoptotic cell death. There is a need for an understanding of how morphology can alter the biological properties of α-Ag2WO4 to predict and optimize its effects on cellular responses.