This study investigated the adsorption of CO2 molecules on transition metal ions (TM) porphyrins induced carbon nanocone (TM-PICNC) (TM = Sc2+, Ti2+, V2+, Cr2+, Fe2+, Co2+, Ni2+, Cu2+, and Zn2+) using density functional theory (DFT) to determine the stabilities, energetic, structural, and electronic properties. The results showed that the CO2 molecule is adsorbed on TM-PICNC with adsorption energies ranging from 0.03 to -12.12 kcal/mol. The weak interactions of CO2 gas with Cr, Ni, Cu, and Zn-PICNC were observed, while strong adsorption was found on Sc, Ti, and V-PICNC. The Ti, V, and Cr-PCNC structures were shown to have a suitable energy gap (Eg) for sensing ability because of the effective and physical interaction between these structures and CO2 gas, leading to a short recovery time. DFT calculations also revealed that V-PCNC had a high %ΔEg (about %56.79) and hence high sensitivity to CO2 gas, making it a promising candidate for having good sensing ability to CO2 gas in presence of O2 and H2O gas.

The photophysical properties of Cu(II) complexes with 5,10,15,20-meso-tetrakis(phenyl)porphyrin and 5,10,15,20-meso-tetrakis(N-methylpyridium-4-yl)porphyrin are examined via the luminescence and femtosecond time-resolved absorbance methods, respectively. These studies are supported by DFT and TD-DFT calculations, which highlight the important role played by ligand-to-metal charge-transfer states in directing the system toward either intersystem crossing to the triplet hypersurface or coordinative expansion to a five-coordinate quasi-stable intermediate. The latter processes occur when the porphyrin is photolyzed in the presence of suitably located Lewis bases. Femtosecond time-resolved absorbance measurements of Cu(II)-5,10,15,20-meso-tetrakis(N-methylpyridium-4-yl)porphyrin confirm that the coordinative expansion in water occurs in approximately 700 fs, while crossing to the triplet hypersurface takes approximately 140 fs in the same solvent. These processes are mutually exclusive, although both can occur simultaneously depending on the environment of the porphyrin. The ratio of the two processes depends on the relative orientation of the Lewis base with respect to the copper atom at the time of excitation. As a consequence, copper porphyrins such as these are excellent probes in the environment of the porphyrin and can be used to identify the location of the porphyrin when interacting with DNA fragments.

OBJECTIVE: This study assessed the presence of dental biofilm with fluorescence spectroscopy associated with porphyrin (Photogen®) in users of orthodontic appliances.
METHODS: This cross-sectional observational clinical trial included 21 patients with metallic orthodontic fixed appliances. The presence of biofilm was evaluated by fluorescence spectroscopy (Evince-MMÓptics. São Carlos-SP, Brazil) with a porphyrin photo-evidence device (Photogen®). Digital images of the buccal surface of the upper anterior teeth (central and lateral incisors and canines) without and with porphyrin were analyzed using the histogram R (red) function in ImageJ software. The results were analyzed using the maximum and mode values of the red pixels from the histograms. The statistical analysis considered the significance level of 5%.
RESULTS: The maximum values and modes of the red pixels were significantly higher in biofilms analyzed by porphyrin-associated optical spectroscopy compared to optical spectroscopy alone.
CONCLUSIONS: Porphyrin-associated fluorescence spectroscopy was able to detect dental biofilm in the oral environment of patients with orthodontic treatment. This method better evidenced the presence of biofilm on the buccal surfaces of the upper teeth compared to that observed with fluorescence spectroscopy without porphyrin.

The coronavirus disease 2019 (COVID-19) caused by the SARS-CoV-2 coronavirus has spread rapidly around the world in a matter of weeks. Most of the current recommendations developed for the use of antivirals in COVID-19 were developed during the initial waves of the pandemic, when resources were limited and administrative or pragmatic criteria took precedence. The choice of drugs for the treatment of COVID-19 was carried out from drugs approved for medical use. COVID-19 is a serious public health problem and the search for drugs that can relieve the disease in infected patients at various stages is still necessary. Therefore, the search for effective drugs with inhibitory and/or virucidal activity is a paramount task. Accessory proteins of the virus play a significant role in the pathogenesis of the disease, as they modulate the host\'s immune response. This paper studied the interaction of one of the SARS-CoV-2 accessory proteins ORF10 with macroheterocyclic compounds - protoporphyrin IX d.m.e., Fe(III)protoporphyrin d.m.e. and 5,10,15,20-tetrakis(3\'-pyridyl)chlorin tetraiodide, which are potential inhibitors and virucidal agents. The SARS-CoV-2 ORF10 protein shows the highest affinity for Chlorin, which binds hydrophobically to the alpha structured region of the protein. Protoporphyrin is able to form several complexes with ORF10 close in energy, with alpha- and beta-molecular recognition features, while Fe(III)protoporphyrin forms complexes with the orientation of the porphyrin macrocycle parallel to the ORF10 alpha-helix. Taking into account the nature of the interaction with ORF10, it has been suggested that Chlorin may have virucidal activity upon photoexposure. The SARS-CoV-2 ORF10 protein was expressed in Escherichia coli cells, macroheterocyclic compounds were synthesized, and the structure was confirmed. The interaction between macrocycles with ORF10 was studied by spectral methods. The results of in silico studies were confirmed by experimental data.

The purpose of this study was to investigate the effectiveness in photodynamic therapy of iron oxide nanoparticles (γ-Fe2O3 NPs), synthesized by laser pyrolysis technique, functionalized with 5,10,15,20-(Tetra-4-sulfonatophenyl) porphyrin tetraammonium (TPPS) on human cutaneous melanoma cells, after only 1 min blue light exposure. The efficiency of porphyrin loading on the iron oxide nanocarriers was estimated by using absorption and FTIR spectroscopy. The singlet oxygen yield was determined via transient characteristics of singlet oxygen phosphorescence at 1270 nm both for porphyrin functionalized nanoparticles and rose bengal used as standard. The irradiation was performed with a LED (405 nm, 1 mW/cm2) for 1 min after melanoma cells were treated with TPPS functionalized iron oxide nanoparticles (γ-Fe2O3 NPs_TPPS) and incubated for 24 h. Biological tests revealed a high anticancer effect of γ-Fe2O3 NPs_TPPS complexes indi-cated by the inhibition of tumor cell proliferation, reduction of cell adhesion, and induction of cell death through ROS generated by TPPS under light exposure. The biological assays were combined with the pharmacokinetic prediction of the porphyrin.

Background: Photodynamic therapy activity against different biological systems has been reported for porphyrins. Porphyrin modifications through peripheral groups and/or by metal insertion inside the ring are main alternatives for the improvement of its photo-physical properties. In this study, we synthesized and characterized 5,10,15,20-tetrakis(4-bromophenyl)porphyrin and the dicloro-5,10,15,20-tetrakis(4-bromophenyl)porphyrinato Sn(IV). Methods: Metal-free porphyrin was synthesized using the Alder method, while the Sn(IV)-porphyrin complex was prepared by combining metal-free porphyrin with stannous chloride in DMF; the reaction yields were 47% and 64% respectively. Metal-free porphyrin was characterized by UV-Vis, FT-IR, ESI-mass spectrometry and 13C-NMR. Additionally, the Sn(IV) -porphyrin complex was characterized using UV-Vis and FT-IR. Cyclic voltammetry tests in four different solvents. The fluorescence quantum yield (Φ f) was measured using fluorescein as a standard, the singlet oxygen quantum yield (Φ D) was estimated using the standard 5,10,15,20-(tetraphenyl)porphyrin (H2TPP) and the quencher of singlet oxygen 1,3-diphenylisobenzofuran (DPBF). Results: UV-Vis assay showed typical Q and Soret bands for porphyrin and its metallo-porphyrin complex. Compounds showed photoluminescence at the visible range of electromagnetic spectrum. The inclusion of the metal in the porphyrin core changed the Φ f from 0.15 to 0.05 and the Φ D increased from 0.55 to 0.59. Finally, the effect of the compounds on the viability of L. panamensis was evaluated by means of the MTT test. The results showed that both compounds decreased the viability of the parasite; this inhibitory activity was greater under light irradiation; the porphyrin compound had IC 50 of 16.5 μM and the Sn(IV)-porphyrin complex had IC 50 of 19.2 μM. Conclusion: The compounds were synthesized efficiently, their characterization was carried out by different spectroscopy techniques and their own signals were evidenced for both structures, both compounds decreased the cell viability of L. panamensis.

Porphyrins are a widespread group of pigments in nature which are believed to contribute to shell colors in mollusks. Previous studies have provided candidate genes for porphyrin shell coloration, however, the linkage analysis between functional genes and porphyrin pigmentation remains unclear in mollusks. RNA interference is a powerful molecular tool for analyzing the loss of functions of genes in vivo and alter gene expression. In this study, we used unicellular alga Platymonas subcordiformis and Nitzschia closterium f. minutissima as vectors to feed oysters with Escherichia coli strain HT115 engineered to express double-stranded RNAs targeting specific genes involved in porphyrin synthesis. A strain of Crassostrea gigas with orange shell was used to target key haem pathway genes expression using the aforementioned approach. We show here that feeding the oysters with E. coli, containing dsRNA targeting pigmentation genes, can cause changes in the color of the newly deposited shell. For example, the RNAi knockdown of CgALAS and CgPBGD resulted in the loss of uroporphyrin pigmentation from the shell due to the accumulation of the pigment in the oyster\'s mantle. The study probed the crucial role of ALAS and PBGD genes potential functions of uroporphyrin production and shell color pigmentation in C. gigas.

Using coarse-grained dissipative particle dynamics (DPD) with explicit electrostatics, we performed (i) an extensive series of simulations of the electrostatic co-assembly of asymmetric oppositely charged copolymers composed of one (either positively or negatively charged) polyelectrolyte (PE) block A and one water-soluble block B and (ii) studied the solubilization of positively charged porphyrin derivatives (P+) in the interpolyelectrolyte complex (IPEC) cores of co-assembled nanoparticles. We studied the stoichiometric mixtures of 137 A10+B25 and 137 A10-B25 chains with moderately hydrophobic A blocks (DPD interaction parameter aAS=35) and hydrophilic B blocks (aBS=25) with 10 to 120 P+ added (aPS=39). The P+ interactions with other components were set to match literature information on their limited solubility and aggregation behavior. The study shows that the moderately soluble P+ molecules easily solubilize in IPEC cores, where they partly replace PE+ and electrostatically crosslink PE- blocks. As the large P+ rings are apt to aggregate, P+ molecules aggregate in IPEC cores. The aggregation, which starts at very low loadings, is promoted by increasing the number of P+ in the mixture. The positively charged copolymers repelled from the central part of IPEC core partially concentrate at the core-shell interface and partially escape into bulk solvent depending on the amount of P+ in the mixture and on their association number, AS. If AS is lower than the ensemble average ⟨AS⟩n, the copolymer chains released from IPEC preferentially concentrate at the core-shell interface, thus increasing AS, which approaches ⟨AS⟩n. If AS>⟨AS⟩n, they escape into the bulk solvent.

The interaction of three cationic porphyrins-meso-tetrakis (N-methylpyridinium-4-yl) porphyrin (TMPyP), meso-tetrakis (1,3-dimethylimidazolium-2-yl) porphyrin (TDMImP), and meso-tetrakis (1,2-dimethylpyrazolium-4-yl) porphyrin (TDMPzP)-with five heavy metals was studied computationally, and binding constants were calculated based on data obtained by an experimental method and compared. The reactivity and stability of their complexes formed with lead, cadmium, mercury, tin, and arsenic ions were observed in DFT global chemical reactivity descriptors: the electronic chemical potential (µ), chemical hardness (η), and electrophilicity (ω). The results show that M-TDMPzP has higher chemical hardness and lower electrophilicity compared to M-TMPyP and M-TDMImP, indicating the reaction of TDMPzP with metals will form a more stable complex. Specifically, Cd-TDMPzP complexes can stabilize the system, with a lower energy and electronic chemical potential, higher chemical hardness, smaller electrophilicity, and higher binding constant value compared to Pb-TDMPzP and Hg-TDMPzP. This result suggests that the interaction of the Cd2+ ion with TDMPzP will produce a stable complex.

In this work, we studied the anthracene oxidation by hydroxyl radicals. Hydroxyl radical was generated by reaction of 5,10,15,20-tetrakis(4-carboxyphenyl)porphyrin Fe (III) (TPPFe) with hydrogen peroxide under visible radiation at a nitrogen atmosphere. The TPPFe was synthesized by Adler Method followed by metal complexation with Fe (III) chloride hexahydrate. Hydroxyl radical was detected by fluorescence emission spectroscopy and we studied kinetic of anthracene selective oxidation by hydroxyl radicals through the differential method. The TPPFe was characterized by UV-Vis spectrophotometry, Dynamic Light Scattering (DLS) and Scanning Electron Microscopy (SEM) measurements. The results indicated that TPPFE was compound by micro-particles with a size distribution of around 2500 nm. Kinetic results showed that the apparent rate constant for the oxidation of anthracene increased exponentially on as temperature increases, furthermore, the activation energy for the Anthracene oxidation by hydroxyl radicals under visible irradiation was 51.3 kJ/mol. Finally, anthraquinone was the main byproduct generated after oxidation of anthracene by TPP-Fe under visible irradiation.