The flavonoid compounds in C. caudatus K., known for their various benefits, are prone to quick degradation, leading to reduced biological activity. This research aimed to evaluate the types of coatings: gum Arabic (GA), maltodextrin (MD), and a combination of both (MDGA) in C. caudatus K. extract microcapsules. The extract of C. caudatus K. was encapsulated by different coating materials, GA, MD, and MDGA, and then dried using a freeze-drying technique. The evaluation was carried out by comparing the encapsulation efficiency values, biological activity, and release tests of each type of microcapsule coating. The research results indicate that coating agents have impacts significantly at p < 0.05 on efficiency encapsulation. Flavonoids were retained up to 79.67% by the MDGA coating, compared with 72.8% and 47.66%a retained by single GA and MD coatings, respectively. The results of the encapsulation efficiency are supported by the results of characterization using a scanning electron microscope (SEM), where MDGA has rounder shapes with smoother surfaces compared with a single coating alone, like GA or MD. In addition, by particle size analysis using a particle size analyzer (PSA), the average sizes of MDGA, GA, and MD microcapsules were shown at 154.13 µm, 152 µm, and 166.81 µm, respectively. The three microcapsules showed an order of activities as MDGA > GA > MD coatings in alpha-amylase inhibition assay. Similar results were also shown in the antioxidant assay, which demonstrated that the three microcapsules had moderate antioxidant activities, again in the order of MDGA > GA > MD. The three different coating types showed greater release at pH 7.4 compared to those at pH 2.2 in the controlled release test, which ran from 30 to 120 min. In summary, freeze-drying microencapsulation using biodegradable polymers was identified as a viable method for harnessing the health benefits of C. caudatus K. extracts. This process produced a convenient powder form that could be used in drug delivery systems. The use of MDGA mixed coating resulted in better impact based on %EE value and biological activity, as well as improved characteristics of microcapsules compared with single coating.

Forest frog\'s oviduct oil (FFOO) is highly susceptible to microbial spoilage during storage, which causes serious safety concerns and economic losses. However, little information is available regarding the preservation of it up to now. The aim of this research is to understand the dominant microbial community of FFOO spoilage, and based on this, develop a kind of edible nanoemulsion coating for preserving FFOO. Microbial metagenomic analysis indicated that the Aspergillus genus increased significantly during storage. In the present study, gum arabic and whey protein isolate were chosen as the coating matrix, the natural compounds sanguinarine and glabridin were selected as antimicrobial agents to prepare double-layer nanoemulsion edible coating. When the ratio of sanguinarine and glabridin in the nanoemulsion was 1:3, it exhibited strongest storage stability and antifungal activity. The mycelial inhibition rate of 1:3 nanoemulsion against dominant microbial community (Aspergillus niger and Aspergillus glaucus) reached 88.89 ± 1.37 % and 89.68 ± 1.37 %, respectively. The experimental results indicated that the edible nanoemulsion coating not only had outstanding antifungal activity, but also had excellent fresh-keeping effect on FFOO. This nanoemulsion coating could be a promising and potential candidate for food preservation.

This study investigated spray drying a method for microencapsulating Lacticaseibacillus rhamnosus GG using a gastrointestinal resistant composite matrix. An encapsulate composite matrix comprising green banana flour (GBF) blended with maltodextrin (MD) and gum arabic (GA). The morphology of resulted microcapsules revealed a near-spherical shape with slight dents and no surface cracks. Encapsulation efficiency and product yield varied significantly among the spray-dried microencapsulated probiotic powder samples (SMPPs). The formulation with the highest GBF concentration (FIV) exhibited maximum post-drying L. rhamnosus GG viability (12.57 ± 0.03 CFU/g) and best survivability during simulated gastrointestinal digestion (9.37 ± 0.05 CFU/g). Additionally, glass transition temperature (Tg) analysis indicated good thermal stability of SMPPs (69.3 - 92.9 ℃), while Fourier Transform infrared (FTIR) spectroscopy confirmed the structural integrity of functional groups within microcapsules. The SMPPs characterization also revealed significant variation in moisture content, water activity, viscosity, and particle size. Moreover, SMPPs exhibited differences in total phenolic and flavonoid, along with antioxidant activity and color values throughout the study. These results suggested that increasing GBF concentration within the encapsulating matrix, while reducing the amount of other composite materials, may offer enhanced protection to L. rhamnosus GG during simulated gastrointestinal conditions, likely due to the gastrointestinal resistance properties of GBF.

This study investigated the effect of heat treatments on the pungency and aroma profiles of a spice oleoresin blend, and the emulsion stability with different surfactants, encapsulating agents, and homogenization mechanisms. Total pungency increased with heat until 120 °C and drastically reduced at 150 °C. Thermal processing induced aroma release, and 46 compounds were identified at 90 °C, predominantly comprising sesquiterpenes. Tween 80 dispersed the highest oleoresin mass (6.21 ± 0.31 mg/mL) and reported the maximum emulsion stability index. The oleoresin percentage significantly influenced the emulsion stability, with 1% oleoresin producing the most stable emulsion. High-pressure homogenization applied on gum Arabic resulted in a greater encapsulation efficiency, exceeding 86%, and the lowest creaming index (4.70 ± 0.06%), while Hi-Cap 100 produced the best flow properties. The findings provide insights into incorporating lipophilic spice oleoresin blends in aqueous food systems and understanding the release of flavor compounds during thermal food processing.

This research focused on synthesizing an eco-friendly FeZn/GA@Cu nanocomposite using spent coffee grounds and Gum Arabic (GA). The study aimed to investigate its effectiveness as both a photocatalyst and an adsorbent, specifically for removing nitrates from aqueous solutions. The prepared nanocomposite was characterized using various analytical techniques, including XRD, TGA, FESEM with EDS, TEM, BET, FTIR, zeta potential, UV-DRS, and VSM. The RSM method, an impressive removal efficiency of 95.28 % for nitrate was projected under the specific conditions of an optimal dose of 1.82 g/L, an initial concentration of 60.00 mg/L, a pH level of 5.85, and a reaction duration of 48.90 min. It was ascertained that the peak efficiency of 98.25 % could be achieved with a carefully calibrated dose of 1.94 g/L, an initial concentration of 62.69 mg/L, a pH of 5.16, and a reaction time contained within 45.75 min. The synthesized nanocomposites have shown potential antibacterial activity against gram+ve (Staphylococcus aureus) and gram-ve (Escherichia coli) pathogens. This study suggests that the FeZn/GA@Cu nanocomposite synthesized using spent coffee grounds has potential as a photocatalyst for removing nitrate from aqueous solutions.

Hibiscus extract exhibits considerable antioxidant activity and a high anthocyanin content, which suggesting potential health benefits. However, these compounds are highly susceptible to environmental factors. The aim of this study was to establish the optimal conditions for the encapsulation of Hibiscus sabdariffa extract (HSE) using mixed porous maize starch-gum Arabic to enhance the stability of bioactive compounds under accelerated aging conditions. Response surface methodology (RSM) was used to optimize microencapsulation conditions through spray drying. The optimal conditions for microencapsulation of HSE by RSM were determined to be 126 °C at the inlet temperature (IT) and 8.5 % at the total solid content (TSC). Using these conditions, the amount of bioactive compounds in optimized microcapsules (OMs) was 2368 mg GAE/100 g, 694 mg QE/100 g, and 930 mg EC3G/100 g, of phenolic compounds, flavonoids, and anthocyanin, respectively. The release rate of anthocyanins during in vitro digestion was more effectively regulated in the OM sample, which retained up to 40 % of anthocyanins compared with 10 % in the HSE. The experimental values in this study exhibit high assertiveness, which renders the optimization model technologically and financially viable for the encapsulation of bioactive compounds with potential use in the food and pharmaceutical industries.

UNASSIGNED: Prior studies on magnetite (Fe3O4) NPs and carbon nanotubes (CNTs) cytotoxic effects against acute myeloid leukemia (AML) are inconclusive rather than definitive.
UNASSIGNED: Investigation of the effects of Gum Arabic (GA)-stabilized/destabilized Fe3O4 NPs and CNTs, alone or in combination, on AML cell proliferation.
UNASSIGNED: Hybrid NPs were synthesized, characterized, and assessed for their cytotoxicity against Kasumi-1, HL-60, and THP-1 in comparison to normal primary bone marrow CD34+ cells. The molecular pathways of nanostructures\' cytotoxicity were also investigated.
UNASSIGNED: The Fe3O4 NPs were effectively synthesized and attached to the surface of the CNTs, resulting in the formation of a novel hybrid through their interaction with the GA colloidal solution in an aqueous media. Although the evaluated nanostructured nanoparticles had significant growth suppression ability against the leukemia cell lines, with IC50 values ranging from 42.437 to 189.842 μg/mL, they exhibited comparatively modest toxicity towards normal hematopoietic cells (IC50: 113.529‒162.656 μg/mL). The incorporation of Fe3O4 NPs with CNTs in a hybrid nanocomposite significantly improved their effectiveness against leukemia cells, with the extent of improvement varying depending on the specific cell type. The nanostructured particles were stabilized by GA, which enhances their ability to inhibit cell proliferation in a manner that depends on the specific cell type. Also, nanoparticles exhibit cytotoxicity due to their capacity to stimulate the production of intracellular ROS, halt the cell cycle at the G1 phase, and induce apoptosis. This is supported by the activation of p53, BAX, cytochrome C, and caspase-3, which are triggered by ROS. The nanostructures lead to an increase in the expression of genes encoding proteins related to oxidative stress (SIRT1, FOXO3, NFE2L2, and MAP3K5) and cyclin-dependent kinase inhibitors (CDKN1A and CDKN1B) in response to ROS.
UNASSIGNED: We provide an effective Fe3O4 NPs/CNTs nano-hybrid composite that induces apoptosis and has strong anti-leukemic capabilities. This hybrid nanocomposite is promising for in vivo testing and validation.

Erythromycin (ERY) molecules are robust to the environment and hard to remove due to their aromatic structure. Nowadays, numerous researches have reported that the ERY amount in water is above the standard level and its removal is necessary. Here, we prepared three solid adsorbents: graphitic carbon nitride (g-C3N4), potassium carrageenan beads (Cr), and graphitic carbon nitride/gum Arabic/potassium carrageenan composite (g-ACr). Several techniques such as XRD, SEM, TEM, TGA, ATR-FTIR, Zeta potential, and N2 adsorption were employed to characterize the fabricated adsorbents. Five essential factors of adsorbent dose, initial ERY concentration, contact time, temperature, and pH were optimized to investigate the batch adsorption of ERY. The maximum adsorption capacity of 356.12 mg/g was attained by g-ACr composite at an adsorbent dose of 1.25 g/L, contact time of 6 h, and pH 7 at 15 °C. The data showed that the experimental findings exhibited the best agreement with Langmuir, Temkin, and DR isotherm models, in addition to the kinetic models of pseudo-second-order, Elovich, and intra-particle diffusion. The evaluated thermodynamic factors designated that the ERY adsorption is endothermic, physisorption, favorable, and spontaneous process. The g-ACr reusability displayed a decline in the adsorption capacity after seven adsorption/desorption runs by 5.7 %. Finally, this work outcomes depict that g-ACr composite is an efficient reusable adsorbent for ERY elimination from wastewater.

This study explores the synthesis and characterization of superabsorbent hydrogels derived from chemically modified gum Arabic, designed for controlled folic acid release. The synthesis involves a two-step process: carboxymethylation followed by grafting with 2-hydroxyethyl methacrylate via gamma irradiation. The resulting hydrogels exhibit enhanced mechanical strength and controlled diffusivity, essential for nutrient delivery systems. Key factors such as copolymer composition and irradiation dose are investigated, affecting the synthesis process. Systematic studies of swelling behaviors reveal that the hydrogel achieves a maximum swelling of 888.1% at 40 °C. The hydrogels are loaded with folic acid, and in vitro, sustained release profiles are examined under various pH conditions. The maximum release of 83.3% is observed after 24 h at pH 7.0, following a Korsmeyer-Peppas release mechanism. Different characterization techniques, confirm the successful synthesis and unique properties of the superabsorbent hydrogels. Rheological behavior analysis, scanning electron microscopy, and biocompatibility assessments provide a comprehensive understanding of the hydrogel structures. Gamma irradiation ensures a homogeneous network structure, crucial for optimal swelling behavior and mechanical properties. This research highlights the potential of eco-friendly biopolymer hydrogels in precise drug delivery applications, leveraging the safety and process control benefits of gamma irradiation.

Copper selenide nanoparticles (Cu2-x Se NPs) have received a lot of attention in recent decades due to their interesting properties and potential applications in various areas such as electronics, health, solar cells, etc. In this study, details of the synthesis and characterization of copper selenide nanoparticles modified with gum arabic (GA) are reported. Also, through transmission electronic microscopy (TEM) analysis, the transformation of the morphology and particle size of copper selenide nanoparticles in aqueous solution was studied. In addition, we present an antimicrobial study with different microorganisms such as Staphylococcus aureus (S. aureus), Escherichia coli (E. coli) and Candida albiacans (C. albicans). Copper selenide nanoparticles were characterized by X-ray diffraction (XRD), Fourier-transform infrared spectroscopy (FTIR), thermogravimetric analysis (TGA), differential scanning calorimetry analysis (DSC) and TEM. XRD confirmed the crystal-line structure of the nanoparticles such as cubic berzelanite with a particle size of 6 nm ± 0.5. FTIR and TGA corroborated the surface modification of copper selenide nanoparticles with gum arabic, and DSC suggested a change in the structural phase from cubic to hexagonal. TEM analysis demonstrated that the surface modification of the Cu2-x Se NPs stabilized the nanostructure of the particles, preventing changes in the morphology and particle size. The antimicrobial susceptibility analysis of copper selenide nanoparticles indicated that they have the ability to inhibit the microbial growth of Staphylococcus aureus, Escherichia coli and Candida albicans.