UNASSIGNED: To investigate the relationship between sagittal alignment and coronal deformity in patients with adolescent idiopathic scoliosis (AIS) through analysis of the spinal imaging data.
UNASSIGNED: Four hundred and fifty-four AIS patients who underwent anteroposterior and lateral radiography of the while spine were enrolled, and the spinal parameters of Cobb angle, cervical lordosis, C1-C2 angle, T1 slope, thoracic kyphosis, lumbar lordosis, sacral slope, pelvic tilt (PT), pelvic incidence (PI), cervical sagittal vertical axis (SVA), and spinal SVA were analyzed.
UNASSIGNED: The patients were divided into two groups according to the size of the Cobb angle: group A (Cobb angle ≤45°, n=414) and group B (Cobb angle >45°, n=40). In group A, the Cobb angle was in a medium negative correlation with the cervical lordosis angle (r=-0.637, P<0.001), a weak positive correlation (|r|<0.3, P<0.05) with C1-C2 angle, T1 slope and thoracic kyphosis. In group B, the Cobb angle was in a mild positive correlation (P<0.05) with PT (r=0.398) and PI (r=0.360). The cervical lordosis angle was significantly (P<0.05) different between male and female patients in both groups. In Group A, the cervical lordosis angle was in a significantly (P<0.01) positive correlation with the T1 slope (r=0.586), thoracic kyphosis (r=0.490), and sagittal vertical axis (r=0.135), and a significantly (P<0.01) negative correlation with cervical sagittal vertical axis (r=-0.128) and C1-C2 angle (r=-0.155). In group B, the cervical lordosis angle was in a significantly (P<0.05) positive correlation with T1 slope (r=0.661), thoracic kyphosis (r=0.608), lumbar lordosis (r=0.425), sacral slope (r=0.434), and sagittal vertical axis (r=0.335).
UNASSIGNED: In AIS patients with the Cobb angle ≤45º, a significant negative correlation exists between the cervical lordosis and the Cobb angle. The sagittal morphology of the cervical spine in AIS patients is affected by the spinal coronal deformity, which plays an important role in the treatment of AIS.

BACKGROUND: Post-operative misalignment of the lower limb mechanical axis following total knee arthroplasty (TKA) is thought to be associated with clinical failure. In a balanced knee, a neutral global mechanical axis following the use of intra-medullary (IM) guidance does not necessarily imply a horizontal TKA joint line. Using femoral and tibial axes separately would be more accurate in evaluating TKA alignment. Thus, the aim of the study is to define a pre-operative mechanical tibial and/or femoral angle threshold value for post-operative optimal alignment correction using IM guides.
METHODS: This single-center prospective continuous pilot study included 50 patients treated with a TKA for primitive osteoarthritis. Femoral and tibial cuts were performed using intramedullary (IM) guide. Three angles were calculated and analyzed pre and post-operatively on standing antero-posterior views using long-leg radiographs: femorotibial angle (FTA), mechanical femoral angle (MFA), and mechanical tibial angle (MTA). Statistical analysis was performed for the whole sample and for the three following FTA subgroups; normo-axial, varus and valgus.
RESULTS: The pre-operative MTA is the only parameter for which a threshold value was observed; when pre-operative MTA exceeded the value of 94°, an optimal correction might not be obtained post-operatively.
CONCLUSIONS: Our results suggest that the bony correction obtained via IM guiding depends exclusively on the primary deformation of the tibia. In cases of a varus of more than 94°, the IM guide was found to yield sub-optimal corrections. Thus, other solutions need to be investigated.