The atomic-level structure and electronic properties of monazite were investigated using a first-principles method based on density functional theory (DFT). First, the geometric structure of monazite was optimized, followed by calculations of its Mulliken population, electron density, and density of states, which were subsequently analyzed. The findings of this analysis suggest that monazite is highly susceptible to cleavage along the {100} plane during crushing and grinding. When SPA was utilized as the collector, the recovery rate of monazite was higher than that when LF-P8 was used. The zeta potential and adsorption energy results indicated that the zeta potential after SPA adsorption tended towards negativity, and the adsorption energy was smaller, indicating that SPA exhibited stronger adsorption performance. LF-P8 was stably adsorbed on the monazite (100) surface via mononuclear double coordination. SPA was stably adsorbed on the surface of monazite (100) via binuclear double coordination. The results of this study provide valuable insights into the adsorption of monazite by commonly used flotation collectors. These findings are of substantial importance for future endeavors in designing flotation collectors capable of achieving selective monazite flotation.

With the growing need for high-purity rare-earth elements (REEs), the separation of these REEs has received much attention recently. The objective of this research is to produce chitosan from shrimp waste, then modify it with different functionality, and investigate the adsorption properties of chitosan adsorbents towards La(III) ions. First, from shrimp waste, chitosan (ch) with a significant degree of deacetylation, purity, and solubility was produced. The purified chitosan was cross-linked with epichlorohydrin (ep), and then, it was modified with 3,6,9,12-tetraazatetradecane-1,14-diamine (HA) to produce polyaminated chitosan (HA@ep@Ch). The polycarboxylated/imine chitosan (CM@HA@ep@Ch) was obtained by treating polyaminated chitosan with chloroacetic acid in isopropyl alcohol. The chitosan adsorbents were characterized and applied for lanthanum recovery from synthetic and monazite leach liquor samples. The factors controlling the recovery process were studied and discussed. The performance of the adsorbents was achieved through equilibrium, dynamic, and isothermal studies. HA@ep@Ch and CM@HA@ep@Ch showed good performance for lanthanum recovery with a maximum capacity of 114.52 and 141.76 mg/g at 330 K, respectively. The isotherm parameters refer to the monolayer of lanthanum adsorbed into the adsorbents through chelation and ion exchange mechanisms. A 0.5-M HCl solution was found effective to elute 95.8% of the adsorbed lanthanum on HA@ep@Ch, and 93.4% of the adsorbed lanthanum on CM@HA@ep@Ch. The adsorbents showed greater selectivity in extracting La, Ce, Pr, Nd, and Sm (62-75%) from REE leach liquid compared to extracting other REEs (20-41%).

Rare earth element (REE) recovery from waste streams, mine tailings or recyclable components using bioleaching is gaining traction due to the shortage and security of REE supply as well as the environmental problems that occur from processing and refining. Four heterotrophic microbial species with known phosphate solubilizing capabilities were evaluated for their ability to leach REE from a high-grade monazite when provided with either galactose, fructose or maltose. Supplying fructose resulted in the greatest amount of REE leached from the ore due to the largest amount of organic acid produced. Gluconic acid was the dominant organic acid identified produced by the cultures, followed by acetic acid. The monazite proved difficult to leach with the different carbon sources, with preferential release of Ce over La, Nd and Pr.

The adsorption behaviour of micro-organisms during the initial attachment stage of biofilm formation affects subsequent stages. The available area for attachment and the chemophysical properties of a surface affect microbial attachment performance. This study focused on the initial attachment behaviour of Klebsiella aerogenes on monazite by measuring the ratio of planktonic against sessile subpopulations (P:S ratio), and the potential role of extracellular DNA (eDNA). eDNA production, effects of physicochemical properties of the surface, particle size, total available area for attachment, and the initial inoculation size on the attachment behaviour were tested. K. aerogenes attached to monazite immediately after exposure to the ore; however, the P:S ratio significantly (p = 0.05) changed in response to the particle size, available area, and inoculation size. Attachment occurred preferentially on larger-sized (~50 µm) particles, and either decreasing the inoculation size or increasing the available area further promoted attachment. Nevertheless, a portion of the inoculated cells always remained in a planktonic state. K. aerogenes produced lower eDNA in response to the changed surface chemical properties when monazite was replaced by xenotime. Using pure eDNA to cover the monazite surface significantly (p ≤ 0.05) hindered bacterial attachment due to the repulsive interaction between the eDNA layer and bacteria.

Rare earth elements have received a lot of attention in recent years due to their increasing demand in high-tech industries. Cerium is of current interest and is commonly used in different industries and medical applications. Cerium\'s uses are expanding due to its superior chemical characteristics over other metals. In this study, different functionalized chitosan macromolecule sorbents were developed from shrimp waste for cerium recovery from a leached monazite liquor. The process involves demineralization, deproteinization, deacetylation, and chemical modification steps. A new class of two-multi-dentate nitrogen and nitrogen‑oxygen donor ligand-based macromolecule biosorbents was synthesized and characterized for cerium biosorption. The crosslinked chitosan/epichlorohydrin, chitosan/polyamines, and chitosan/polycarboxylate biosorbents have been produced from marine industrial waste (shrimp waste) using a chemical modification approach. The produced biosorbents were used to recover cerium ions from aqueous mediums. The affinity of the adsorbents towards cerium was tested in batch systems under different experimental conditions. The biosorbents showed high affinities for cerium ions. The percentage of cerium ions removed (%) from its aqueous system by polyamines and polycarboxylate chitosan sorbents is 85.73 and 90.92 %, respectively. The results indicated that the biosorbents have a high biosorption capacity for cerium ions from aqueous and leach liquor streams.

Rare earth elements (REEs) are important raw materials for green technologies. However, REE mining and production uses techniques that are often not environmentally sustainable. Life cycle assessment (LCA) is a well-recognized method for evaluating the environmental impacts of products and technologies. This article provides an overview of the environmental impacts based on published LCA results of primary REE production. Existing major REE deposits (Bayan Obo in China, Mountain Pass in the United States, Mount Weld in Australia, ion-adsorption deposits in several Chinese southern provinces) and currently possible production routes are compared. Alternative minerals, such as eudialyte, are also discussed. The article shows which environmental effects can be minimized by technology optimization and environmental safety strategies. Additionally, some of the environmental impacts discussed, may be difficult to mitigate, as they depend on the mineral type. Activities along the complex process chain of REEs production that have particularly high environmental impacts are identified.
UNASSIGNED:

Rare earth elements (REEs) are one of the most important elements used for transformation of the fossil era into a decarbonized future. REEs are essential for wind, electric and hybrid vehicles, and low-energy lighting. However, there is a general understanding that REEs come along with multiple environmental problems during their extraction and processing. Life cycle assessment (LCA) is a well-established method for a holistic evaluation of environmental effects of a product system considering the entire life cycle. This paper reviews LCA studies for determining the environmental impacts of rare earth oxide (REO) production from Bayan Obo and ion adsorption clays (IAC) in China, and shows why some studies lead to over- and underestimated results. We found out that current LCA studies of REE production provide a good overall understanding of the underlying process chains, which are mainly located in China. However, life cycle inventories (LCI) appear often not complete. Several lack accuracy, consistency, or transparency. Hence, resulting environmental impacts are subject to great uncertainty. This applies in particular to radioactivity and the handling of wastewater and slurry in tailing ponds, which have often been neglected. This article reviews 35 studies to identify suitable LCAs for comparison. The assessment covers the world\'s largest REO production facility, located in Bayan Obo, as well as in-situ leaching of IACs in the Southern Provinces of China. A total of 12 studies are selected, 8 for Bayan Obo and IACs each. The LCIs of these studies are reviewed in detail. The effects of over- and underestimated LCIs on the life cycle impact assessment (LCIA) are investigated. The partly controversial results of existing LCAs are analyzed thoroughly and discussed. Our results show that an increased consistency in LCA studies on REO production is needed.

Froth flotation of fine minerals has always been an important research direction in terms of theory and practice. In this paper, the effect and mechanism of Fe3+ on improving surface hydrophobicity and flotation of fine monazite using sodium octyl hydroxamate (SOH) as a collector were investigated through a series of laboratory tests and detection measurements including microflotation, fluorescence spectrum, zeta potential, and X-ray photoelectron spectroscopy (XPS). Flotation tests have shown that fine monazite particles (-26 + 15 μm) cannot be floated well with the SOH collector compared to the coarse fraction (-74 + 38 μm). However, adding a small amount of Fe3+ to the pulp before SOH can significantly improve the flotation of fine monazite. This is because the addition of Fe3+ promotes the adsorption of SOH and greatly improves the hydrophobicity of the monazite surface. This can result in the formation of a more uniform and dense hydrophobic adsorption layer, as shown by the fluorescence spectrum and zeta potential results. From the XPS results, Fe3+ reacts with surface O atoms on the surface of monazite to form a monazite-Osurf-Fe group that acts as a new additional active site for SOH adsorption. A schematic model was also proposed to explain the mechanism of Fe3+ for improving surface hydrophobicity and flotation of fine monazite using octyl hydroxamate as a collector. The innovative point of this study is using a simple reagent scheme to float fine mineral particles rather than traditional complex processes.

The present study evaluates the enrichment and distribution of radioelements along the eastern coast of India. India possesses the second largest reserve of thorium bearing monazite in the world, in terms of heavy minerals present primarily along its long coastline. Radioelement estimation of about 30 km long beach area along the eastern coast of India is reported and implications discussed. A total number of 822 data points were studied using a portable Geiger Muller counter, to estimate the variation of dose rates, due to the ambient radionuclides along two different trends. One was parallel (northeast-southwest) and the second one perpendicular to the coastline. Pre-selected samples from in-situ radiometric surveys on the heavy mineral placers were studied further, for quantitative estimation of the abundance of radioactive elements primarily uranium and thorium, using a High Purity Germanium detector. Radioelement concentration assessment of core samples (depth ~2 m), were studied from two different beaches. Radiological parameters like radium equivalent, annual effective doserate and absorbed dose rate has been calculated based on the 238U, 232Th and 40K concentrations. Heavy mineral placers along the shoreline indicate a very high thorium (avg - 2990.22 Bq kg-1) which is due to the extensive distribution indicative of monazite. The coastal area also exhibits relatively low uranium (avg - 319.1 Bq kg-1). Based on its high thorium concentration, the area can be considered as a high natural background radiation area. Based on the concentrations of uranium and thorium, the weathering conditions and depositional environment prevalent along the beach areas have been discussed.