Monochlorpropanediol fatty acid esters (MCPDE) and glycidyl fatty acid esters (GE) are mainly considered to be processing contaminants and their concentration can rise during high temperature refining and deodorization of edible oils. Free forms formed during digestive hydrolysis of esters such as 3-monochloropropane-1,2-diol (3-MCPD), 2-MCPD and glycidol can provoke a negative effect on human health. Therefore the quantitative determination of MCPDE and GE in edible oils, fats and fat blends is needed. The aim - this manuscript deals with MCPDE and GE concentration measured as free 3-MCPD, 2-MCPD and glycidol in different edible oils, fats and fat blends of Russian market. Material and methods. 55 edible oil and fat samples sold on Russian market including refined and non-refined oils and fat blends such as spreads, dairy fat replacers, and margarines have been analyzed. Slow alkaline transesterification method with GC-MS/MS was used. Results. According to the data obtained, the highest concentrations of the contaminants were detected in fat blends: <0.10-5.03 mg/kg for 3-MCPD, <0.10-2.50 mg/kg for 2-MCPD and 0.1 5-11.17 mg/kg for glycidol. In palm oils and its fractions concentration of 3-MCPD was <0.10-6.61 mg/kg, 2-MCPD - <0.10-2.69 mg/kg and glycidol - <0.10-6.29 mg/kg. The content of glycidol in sunflower oils fluctuated in the range <0.10-1.19 mg/kg, 3-MCPD was <0.10-2.47 mg/kg, and 2-MCPD <0.10-0.67 mg/kg. Non-refined edible oils and olive oils had no or little MCPDE or GE. Conclusion. In this work we indicate high importance of monitoring MCPDE and GE in edible oils and fats both as ready-to-eat products and as ingredients prior to the Russian market release. There is strong need in mitigation of these process contaminants during fat blends manufacturing.

Currently, the authentication analysis of edible fats and oils is an emerging issue not only by producers but also by food industries, regulators, and consumers. The adulteration of high quality and expensive edible fats and oils as well as food products containing fats and oils with lower ones are typically motivated by economic reasons. Some analytical methods have been used for authentication analysis of food products, but some of them are complex in sampling preparation and involving sophisticated instruments. Therefore, simple and reliable methods are proposed and developed for these authentication purposes. This review highlighted the comprehensive reports on the application of infrared spectroscopy combined with chemometrics for authentication of fats and oils. New findings of this review included (1) FTIR spectroscopy combined with chemometrics, which has been used to authenticate fats and oils; (2) due to as fingerprint analytical tools, FTIR spectra have emerged as the most reported analytical techniques applied for authentication analysis of fats and oils; (3) the use of chemometrics as analytical data treatment is a must to extract the information from FTIR spectra to be understandable data. Next, the combination of FTIR spectroscopy with chemometrics must be proposed, developed, and standardized for authentication and assuring the quality of fats and oils.

Per- and polyfluoroalkyl substances (PFASs) are man-made chemicals that have been identified as global pollutants. Their widespread occurrence, including in food, is a potential concern for consumers. This work focuses on the application of a simple and reliable analytical method for the simultaneous determination of ten perfluoroalkyl acids in highly complex fatty matrices (fats and oils). The perfluoroalkyl substances were extracted by the QuEChERS method, based on the dispersive-Solid Phase Extraction using styrene-divinylbenzene bulk sorbent, and quantitatively analysed by micro-high performance liquid chromatography tandem mass spectrometry. Recoveries ranged from 72 to 104% with an acceptable relative standard deviation below 10%. Limits of quantification were within the range 0.002-0.075 ng/g depending on the perfluoroalkyl compound. The most predominant compound in fat and oil food samples was perfluorooctanoic acid (PFOA) with a detection frequency of 100%, and the highest levels were found for perfluorobutanoic acid (PFBA). The estimated exposure to PFOA, which was 46% and 19% of the existing TWI for the EU and Polish population, respectively, is relatively high and indicates a potential risk to human health.

Shipping of edible fats and oils into Europe is permitted in bulk tanks, provided that the previous cargo is included in a positive list. The European Commission requested EFSA to evaluate the acceptability of calcium lignosulfonate as previous cargo for fats and oils. The evaluation was based on the same criteria as those used for the evaluation of the substances currently on the list in the Annex to Commission Directive 96/3/EC as a acceptable previous cargoes for edible fats and oils. In 2017, the EFSA Panel on Contaminants in the Food Chain (CONTAM Panel) concluded that calcium lignosulfonate did not meet the acceptability criteria, due to uncertainties as regards the composition and toxicity of its low-molecular weight fraction (LMWF) below 1,000 Da. In the current evaluation, new information, showing lack of genotoxicity of the LMWF isolated from a technical grade of calcium lignosulfonate was provided. Due to uncertainties regarding the presence of lignosulfonate components below 200 Da in this LMWF tested for genotoxicity, the CONTAM Panel concluded that the information provided was insufficient to assess the acceptability of calcium lignosulfonate as previous cargo. The Panel recommends a better analysis of the LMWF and a new genotoxicity test using this LMWF, including components < 200 Da, and evidence that the tested material is representative of the LMWF in products intended to be shipped as previous cargo for edible fat and oils.

Shipping of edible fats and oils into Europe is permitted in bulk tanks, provided that the previous cargo is included in a positive list. The European Commission requested EFSA to evaluate the acceptability as previous cargoes for fats and oils the substances calcium lignosulphonate, methyl acetate, ethyl tert-butyl ether (ETBE) and ammonium sulphate. The evaluation was based on the same criteria as those used for the evaluation of the substances currently on the list in the Annex to Commission Directive 96/3/EC as acceptable previous cargoes for edible fats and oils. Methyl acetate and ETBE meet the criteria for acceptability as previous cargoes. Due to uncertainties, mainly with regard to the composition and toxicity of the low molecular mass fraction, and the fact that the toxicological database is limited to the 40-65 grade and does not cover all grades of calcium lignosulphonate shipped as previous cargoes, the EFSA Panel on Contaminants in the Food Chain (CONTAM Panel) concluded that calcium lignosulphonate does not meet the criteria for acceptability as a previous cargo. Only food-grade ammonium sulphate meets the criteria for acceptability as a previous cargo due to uncertainties about impurities in other (non-food) grades.

Oil is a prominent, but multifaceted material class with a wide variety of applications. Technical oils, crude oils as well as edibles are main subclasses. In this review, the question is addressed how low-field NMR can contribute in oil characterization as an analytical tool, mainly with respect to quality control. Prerequisite in the development of a quality control application, however, is a detailed understanding of the oils and of the measurement. Low-field NMR is known as a rich methodical toolbox that was and is explored and further developed to address questions about oils, their quality, and usability as raw materials, during production and formulation as well as in use.

Edible fats and oils are among the basic components of the human diet, along with carbohydrates and proteins, and they are the source of high energy and essential fatty acids such as linoleic and linolenic acids. Edible fats and oils are used in for pan- and deep-frying, and in salad dressing, mayonnaise and processed foods such as chocolates and cream. The physical and chemical properties of edible fats and oils can affect the quality of oil foods and hence must be evaluated in detail. The physical characteristics of edible fats and oils include color, specific gravity, refractive index, melting point, congeal point, smoke point, flash point, fire point, and viscosity, while the chemical characteristics include acid value, saponification value, iodine value, fatty acid composition, trans isomers, triacylglycerol composition, unsaponifiable matters (sterols, tocopherols) and minor components (phospholipids, chlorophyll pigments, glycidyl fatty acid esters). Peroxide value, p-anisidine value, carbonyl value, polar compounds and polymerized triacylglycerols are indexes of the deterioration of edible fats and oils. This review describes the analytical methods to evaluate the quality of edible fats and oils, especially the Standard Methods for Analysis of Fats, Oils and Related Materials edited by Japan Oil Chemists\' Society (the JOCS standard methods) and advanced methods.