Welding is a common method for joining metals by heating them to the welding temperature. Exposure to welding fumes has a serious effect on the health of welders. This study examined serum zinc variability and body composition as route for hyperlipidemia and dyslipidemia in welders exposed to welding fumes and smoking, exploring the possibilities for the risk of possible cardiovascular disease. The experimental case control design was adopted in the study. Forty apparently healthy adult males were randomly selected comprising of twenty control group (non-smokers and smokers without welding experience) and twenty experimental group (non-smokers and smokers with welding experience) welders. Data obtained were represented as Mean ± SEM while comparison of means across group was done by one-way ANOVA followed by Tukey\'s multiple comparison for post hoc test at p-value < 0.05 level of significance using Graph Pad prism version 8. The data obtained showed that the body mass index (BMI) of smokers (non-welders and welders) were slightly reduced while that of non-smoking welders was increased compared to the control. The serum zinc level increased among the smoking welders, while the smoking non-welders and non-smoking welders decreased when compared to the control group (p < 0.05). Exposure to welding fumes has been shown to increase total cholesterol levels compared to the control. Weld fumes significantly (p < 0.05) increased high-density lipoproteins (HDL) levels among smoking non-welders compared to the control group, while, HDL was reduced in non-smoking welders and smoking welders, respectively (p < 0.05). Triglyceride levels significantly (p < 0.05) increased in all experimental groups compared to control levels (p < 0.05). Exposure to welding fumes and smoking caused significant changes in serum zinc, HDL and triglycerides levels with implications for the formation of plaques around the arteries interfering with the effective flow of blood through the vascular system, with implications of hyperlipidemia and dyslipidemia. This study recommends that further studies should be done using biomarkers from urine or toe nails.

Occupational exposure to manganese (Mn) primarily occurs through the inhalation of manganese-containing fumes and dust, with welding environments being significant sources of such exposure. Elevated levels of Mn in welding fumes can lead to a neurological syndrome known as manganism. A 28-yr-old male welder with 14 yr of experience, is presenting with complaints of forgetfulness, reasoning disorder, and decreased mental functions persisting for 10 yr. Three months ago, when he started working at the new workplace, he underwent employment screening conducted by the workplace physician. During this screening process, the physician identified a high whole blood Mn level of 25.9 µg/l. The diagnosis of manganism in this patient was established based on exposure to Mn and its compounds, high levels of Mn detected in the whole blood, hyperactive patellar reflexes observed during the physical examination, cranial Magnetic Resonance Imaging (MRI) findings consistent with manganism and complaints reported by the patient that are characteristic of manganism. In this report, the aim is to emphasize the significance of taking a comprehensive occupational history and to draw attention the potential health hazards associated with Mn and its compounds.

UNASSIGNED: Occupational diseases can result in sickness absence, economic loss, disability, or death of workers. Several studies have revealed that occupational health and safety practice is still low in some occupational groups despite their knowledge and the occupational health legislation. This study assessed the level of knowledge, Background: Occupational health service delivery, includes the creation of a safe and healthy work environment. The protection and promotion of workers\' health; is at its infantile stages in the informal sector such as the welding industry in Nigeria. We determined the level and determinants of awareness of occupational hazards, determinants of use of personal protective equipment (PPE) and carried out a workplace risk assessment among the welders at the mechanic village in Abakaliki, Ebonyi State.
UNASSIGNED: We conducted a cross-sectional study among welders who work in the mechanic village, Abakaliki. A structured, pretested interviewer-administered questionnaire was used to extract information on awareness of occupational hazards, frequency of use of PPE, health-related complaints amongst others. Chi-square test and logistic regression analysis were conducted at a 5% level of significance.
UNASSIGNED: All the respondents were male with a mean age of 27.6± 10.1 years. We found a good awareness of occupational hazards in 60% of the respondents and though this was associated with being older than 30years (p=0.03), being an expert compared to apprentice (p=0.003), duration of work more than 5years (p=0.004), none of these factors, when modelled in logistic regression, were predictors of good awareness. Regular use of PPE was reported in 49.79% of respondents. Cuts, sparks, foreign bodies in the eye were the most common hazards they were aware of. Cuts were the most reported health complaint. Good awareness of hazards was associated with higher odds of sustaining cuts (adjusted odds ratio [AOR]: 3.1, 95% CI:1.46 - 6.69) and a predictor of regular use of PPE (AOR:2.6, 95%CI:1.12 - 5.88). The workplace risk assessment revealed a work environment not conducive to occupational safety and health.
UNASSIGNED: A good awareness of occupational hazards was moderately high, a predictor of regular use of PPE and not protective of sustaining cuts in the suboptimal work environment.

BACKGROUND: Our aimed to conduct a meta-analysis of cohort studies on risk of genitourinary (GU) cancers in workers exposed to welding fumes (WF).
METHODS: We performed a systematic review of studies published on Pubmed, Scopus and Embase following PRISMA criteria. Two researchers selected cohort studies on WF exposure. From 2582 articles, 7 non-overlapping studies were included. Quality of studies was scored according to CASP. We run a random effects meta-analysis to calculate the relative risk (RR) and 95% confidence intervals (CI) of GU cancer, overall and stratified by cancer, country, and quality score.
RESULTS: We included seven studies reporting results on GU cancers, including prostate, bladder and kidney cancer (PC, BC, and KC). The RR was 1.19 (95% CI = 1.07-1.32, 16 risk estimates) for GU cancer; 1.13 (95% CI = 0.90-1.42, 4 risk estimates) for PC; 1.26 (95% CI = 0.98-1.60, 7 risk estimates) for BC and 1.28 (95% CI = 1.12-1.47, 5 risk estimates) for KC. Heterogeneity was present in all meta-analyses (p < 0.001). The increased risk was more pronounced in North American than in European studies (respectively, OR = 1.35, 95% CI = 1.18-1.55; OR = 1.13, 95% CI = 1.01-1.27 p heterogeneity = 0.03). There was no heterogeneity according to quality score (p = 0.4). Data were insufficient to investigate associations by industry or welding type. Publication bias for each cancer was excluded.
CONCLUSIONS: This meta-analysis suggests increased risk of KC and BC, but not of PC, in workers exposed to WF. Confounding by other occupational and non-occupational risk factors could not be excluded. Data were not adequate to address the risk of specific exposure circumstances.

[This corrects the article DOI: 10.3389/fonc.2023.1001802.].

In response to increasing focus on occupational exposures to welding fume, a 10-year series of personal exposure measurements was analyzed for the two main welding processes (Shielded Metal Arc Welding or Stick and Tungsten Inert Gas welding or TIG) used in an oil refinery setting. Exposures from ancillary gouging and grinding were also analyzed. The operations were conducted under a permit-to-work system, which stipulated control measures in the form of ventilation and respiratory protective equipment (RPE) depending on the work environment, base metal, and welding process. The analysis focused on three health hazards of interest: total particulate (TP); hexavalent chromium (Cr (VI)); and manganese (Mn). The study\'s aims were the analysis of exposure levels related to operational conditions to verify the adequacy of required control measures and the generation of quantitative information for the development of predictive exposure models. Arithmetic mean exposures were 2.01 mg/m3 for TP (n = 94), 13.86 µg/m3 for Cr (VI) (n = 160), and 0.024 mg/m3 for Mn (n = 95). Requirements and practices for ventilation and use of RPE appeared adequate for maintaining exposure levels below maximum use concentrations. Predictive models for mean exposure levels were developed using multiple linear regression. Different patterns emerged for TP, Cr (VI), and Mn exposure determinants. Enclosed or confined work environments were associated with elevated exposure levels, regardless of the provision of local exhaust or general dilution ventilation. Carbon arc, used with gouging and grinding, contributed significantly to TP exposure (p = 0.006). The relative TP source strengths of the two main welding processes were comparable to the literature data. For Cr (VI), stick welding was associated with approximately 50-fold (p < 0.001) higher exposure potential than TIG welding. For Mn, this difference was approximately 2.5-fold. Differences were observed across the three analytes in exposure reduction efficiency of local exhaust ventilation (LEV) compared to natural ventilation, possibly due to ineffective use in confined spaces. These findings contribute to the overall understanding of TP, Cr (VI), and Mn exposures from welding and required controls in an oil refinery setting.

Legionellosis among welders and other metalworkers is a rare but potentially underappreciated occupational hazard. The same mechanisms that predispose welders to severe pneumonia from Streptococcus pneumoniae and Bacillus cereus may similarly predispose them to Legionella pneumophila infection. We present a case of a previously healthy, immunocompetent 31-year-old male welder presenting with three days of shortness of breath, hypoxia, high-grade fever, and blood-tinged sputum. Chest computed tomography (CT) revealed a lobar consolidation of the right middle and lower lobes. Laboratory evaluation showed borderline hyponatremia, hypophosphatemia, and elevated liver enzymes. The patient was ultimately intubated and started on broad-spectrum antibiotics. Multiple respiratory cultures were negative and Legionella urine antigen testing was also negative. Eventually, bronchial Legionella culture was positive for Legionella pneumophila, and a blood next-generation sequencing test also confirmed the diagnosis. He was extubated six days following admission and subsequently discharged.

OBJECTIVE: The mask fit test confirms whether the wearing condition of the wearer\'s face and the facepiece of the respirators are used appropriately. This study aimed to examine whether the results of the mask fit test affect the association between the concentration of metals related to welding fumes in biological samples and the results of time-weighted average (TWA) personal exposures.
METHODS: A total of 94 male welders were recruited. Blood and urine samples were obtained from all participants to measure the metal exposure levels. Using personal exposure measurements, the 8-h TWA (8 h-TWA) of respirable dust, TWA of respirable Mn, and 8-h TWA of respirable Mn were calculated. The mask fit test was performed using the quantitative method specified in the Japanese Industrial Standard T8150:2021.
RESULTS: Fifty-four participants (57%) passed the mask fit test. Only in the Fail group of the mask fit test, it was observed that blood Mn concentrations be positively associated with the results of TWA personal exposure after adjusting for multivariate factors (8-h TWA of respirable dust; coefficient, 0.066; standard error (SE), 0.028; P = 0.018, TWA of respirable Mn: coefficient, 0.048; SE, 0.020; P = 0.019, 8 h-TWA of respirable Mn: coefficient, 0.041; SE, 0.020; P = 0.041).
CONCLUSIONS: The results clarify that welders with high concentrations of welding fumes in their breathing air zone are exposed to dust and Mn if there is leaking air owing to the lack of fitness between respirators and the wearer\'s face when using human samples in Japan.

OBJECTIVE: There are some studies reporting the association between (manganese [Mn]) exposure to welding fume and neurological dysfunction. This study examined the relationship between Mn exposure and neurological behavior in Japanese male welders and non-welders using biological samples, which to date has not been assessed in Japan.
METHODS: A total of 94 male welders and 95 male non-welders who worked in the same factories were recruited. The blood and urine samples were obtained from all the participants to measure Mn exposure levels. Neurological function tests were also conducted with all participants. The sampling of the breathing air zone using a personal sampler was measured for welders only.
RESULTS: The odds ratios (ORs) for the Working Memory Index (WMI) scores were significantly higher among all participants in the low blood Mn concentration group than those in the high blood Mn concentration group (OR, 2.77; 95% confidence interval [CI], 1.24, 6.19; P = .013). The association of WMI scores and blood Mn levels in welders had the highest OR (OR, 3.73; 95% CI, 1.04, 13.38; P = .043). Although not statistically significant, a mild relationship between WMI scores and blood Mn levels was observed in non-welders (OR, 2.09; 95% CI, 0.63, 6.94; P = .227).
CONCLUSIONS: The results revealed a significant positive relationship between blood Mn and neurological dysfunction in welders. Furthermore, non-welders at the same factories may be secondarily exposed to welding fumes. Further research is needed to clarify this possibility.

A 49-year-old male who had been working in welding for more than 30 years was admitted to the hospital for a medical checkup that revealed a lung shadow without specific symptoms such as coughing and sputum. Imaging studies showed diffuse ground-glass changes in both lungs, wall cavities with wall nodules, multiple peripheral nodules, and some nodules with calcification. The patient has been engaged in welding work for more than 30 years and exposed to iron dust. Lung tissue biopsy, routine morphological and pathological fluid basis examination of alveolar lavage fluid, can be considered as pulmonary iron particles, which can be regarded as iron dust lung. Acid-fast bacilli were detected in both fibrobronchoscopic brush extract and alveolar lavage fluid acid-fast staining. As the pathological examination revealed granulomatous inflammation showed caseation necrosis, the patient was judged to have concomitant pulmonary TB. After the diagnosis was made, the patient was no longer exposed to dust and was treated with appropriate anti- tuberculosis (TB) therapy. Lung lesions caused by welding have been reported, but the simultaneous finding of siderosis with pulmonary TB is specific to the case presented here. By describing the imaging features, combining different staining methods of alveolar lavage fluid and pathological examination of lung tissue, we showed various morphological manifestations of this case, aiming at improving the morphological diagnosis level of laboratory physicians and enabling patients to be diagnosed and treated early.