Total syntheses of borolithochromes H1, H2, I1, and I2, the red pigments isolated from fossils of Jurassic putative red alga Solenopora jurassica, have been achieved. The naphthoquinone possessing a chiral sec-butyl side chain has been synthesized from (S)-2-methylbutanol. The Diels-Alder reaction of the chiral naphthoquinone and the previously reported diene was followed by one pot S-methylation/intramolecular Corey-Chaykovsky reaction/epoxide rearrangement to provide the benzo[gh]tetraphene skeleton. Complexation of the resulting ligand with trimethyl borate and the following O-demethylation furnished a 1:1 mixture of borolithochromes I1 and I2, which were separated by HPLC using CHIRALPAK IC® to afford optically pure borolithochromes I1 (6) and I2 (7). On the other hand, borolithochromes H1 and H2 were not separated by HPLC in our laboratory. Fortunately, the mixture of the methyl ethers of borolithochromes H1 and H2 were separated and O-demethylation with magnesium iodide furnished optically pure borolithochromes H1 (4) and H2 (5).

Improving the spatial resolution of a fluorescence microscope has been an ongoing challenge in the imaging community. To address this challenge, a variety of approaches have been taken, ranging from instrumentation development to image postprocessing. An example of the latter is deconvolution, where images are numerically deblurred based on a knowledge of the microscope point spread function. However, deconvolution can easily lead to noise-amplification artifacts. Deblurring by postprocessing can also lead to negativities or fail to conserve local linearity between sample and image. We describe here a simple image deblurring algorithm based on pixel reassignment that inherently avoids such artifacts and can be applied to general microscope modalities and fluorophore types. Our algorithm helps distinguish nearby fluorophores, even when these are separated by distances smaller than the conventional resolution limit, helping facilitate, for example, the application of single-molecule localization microscopy in dense samples. We demonstrate the versatility and performance of our algorithm under a variety of imaging conditions.

The synthesis of a chiral supramolecular organogel via the hierarchical helical self-assembly of optically active riboflavin and melamine derivatives is described herein. Owing to the photocatalysis of riboflavin and the supramolecular chirality induced in the helically stacked riboflavin/melamine complex, the gel is observed to act as a light-stimulated chiral sensor of optically active alcohols by detecting the change in color from yellow to green. The gel also served as an efficient chiral adsorbent, enabling optical resolution of a racemic compound with high chiral recognition ability.

In this work, a facile and versatile strategy for the synthesis of contorted polycyclic aromatic hydrocarbons (PAHs) starting from the functionalized pentacene was established. A series of novel PAHs 1-4 and their derivatives were synthesized through a simple two-step synthesis procedure involving an intramolecular reductive Friedel-Crafts cyclization of four newly synthesized pentacene aldehydes 5-8 as a key step. All the molecules were confirmed by single-crystal X-ray diffraction and their photophysical and electrochemical properties were studied in detail. Interestingly, the most striking feature of 1-4 is their highly contorted carbon structures and the accompanying helical chirality. In particular, the optical resolution of 2 was successfully achieved by chiral-phase HPLC, and the enantiomers were characterized by circular dichroism and circularly polarized luminescence spectroscopy. Despite the highly nonplanar conformations, these contorted PAHs exhibited emissive properties with moderate-to-good fluorescence quantum yields, implying the potential utility of this series PAHs as high-quality organic laser dyes. By using a self-assembly method with the help of epoxy resin, a bottle microlaser based on 3 a was successfully illustrated with a lasing wavelength of 567.8 nm at a threshold of 0.3 mJ/cm2 . We believe that this work will shed light on the chemical versatility of pentacene and its derivatives in the construction of novel functionalized PAHs.

Improving the spatial resolution of a fluorescence microscope has been an ongoing challenge in the imaging community. To address this challenge, a variety of approaches have been taken, ranging from instrumentation development to image post-processing. An example of the latter is deconvolution, where images are numerically deblurred based on a knowledge of the microscope point spread function. However, deconvolution can easily lead to noise-amplification artifacts. Deblurring by post-processing can also lead to negativities or fail to conserve local linearity between sample and image. We describe here a simple image deblurring algorithm based on pixel reassignment that inherently avoids such artifacts and can be applied to general microscope modalities and fluorophore types. Our algorithm helps distinguish nearby fluorophores even when these are separated by distances smaller than the conventional resolution limit, helping facilitate, for example, the application of single-molecule localization microscopy in dense samples. We demonstrate the versatility and performance of our algorithm under a variety of imaging conditions.

The reported optical resolution method was designed to support high-throughput enantioseparation of molecular building blocks obtained by automated small-scale synthetic methods. Lipophilic esters of common resolving agents were prepared and used as liquid membranes on the indifferent polymer surface of a microtiter assay. Chiral model compounds were enriched in one of the enantiomers starting from the aqueous solutions of their racemic mixture. Enantiodiscrimination was provided by forming diastereomeric coordination complexes of lipophilic enantiopure esters with the enantiomers of the chiral building blocks inside the liquid membranes. This enantiomeric recognition resulted in a greater distribution ratio of the preferred isomer in the membrane phase, thus the process enables a simultaneous enantioenrichment of the solutions outside the membrane. This paper reports a novel microplate-integrated stereoselective membrane enrichment technique satisfying the need for automatable enantioseparation on a subpreparative scale.

The first total synthesis of loroxanthin (1) was accomplished by Horner-Wadsworth-Emmons reaction of C25-apocarotenal 8 having a silyl-protected 19-hydroxy moiety with C15-phosphonate 25 bearing a silyl-protected 3-hydroxy-ε-end group. Preparation of apocarotenal 8 was achieved via Stille coupling reaction of alkenyl iodide 10 with alkenyl stananne 9, whereas phosphonate 25 was prepared through treatment of ally alcohol 23 with triethyl phosphite and ZnI2. The ally alcohol 23 was derived from the known (3R,6R)-3-hydroxy C15-aldehyde 20, which was obtained by direct optical resolution of racemate 20 using a semi-preparative chiral HPLC column.

The optically active dibenzoyltartaric acid, tartaric acid, and its sodium salts were successfully applied to the optical resolution of (1R,2S)(1S,2R)-2-(methylamino)-1-phenylpropan-1-ol (EPH) and (1R,2R)(1S,2S)-2-amino-1-(4-nitrophenyl)propane-1,3-diol (AD) as resolving agents. It was observed that both compounds\' resolution using a mixture of salts of quasi-racemic resolving agents showed a change in chiral recognition under the same conditions compared to the result of the use of the single enantiomeric resolving agent. The changes are followed by detailed analytical (XRD, FTIR, and DSC) studies. Meanwhile, the DASH indexing software package was also tested on powder XRD patterns of pure initial materials and intermediate salt samples of high diastereomeric excess.

Stimulated emission depletion (STED) microscopy is one of the optical superresolution microscopy (SRM) techniques, more recently also referred to as nanoscopy, that have risen to popularity among biologists during the past decade. These techniques keep pushing the physical boundaries of optical resolution toward the molecular scale. Thereby, they enable biologists to image cellular and tissue structures at a level of almost molecular detail that was previously only achievable using electron microscopy. All the while, they retain the advantages of light microscopy, in particular with regards to sample preparation and flexibility of imaging. Commercially available SRM setups have become more and more available and also increasingly sophisticated, both in terms of optical performance and, importantly, ease of use. Institutional microscopy core facilities now offer widespread access to this type of systems. However, the field has grown so rapidly, and keeps growing, that biologists can be easily overwhelmed by the multitude of available techniques and approaches. From this vast array of SRM modalities, STED stands out in one respect: it is essentially an extension to an advanced confocal microscope. Most experienced users of confocal microscopy will find the transition to STED microscopy relatively easy as compared with some other SRM techniques. This also applies to STED sample preparation. Nonetheless, because resolution in STED microscopy does not only depend on the wavelength of the incident light and the numerical aperture of the objective, but crucially also on the square root of the intensity of the depletion laser and, in general, on the photochemical interaction of the fluorophore with the depletion laser, some additional considerations are necessary in STED sample preparation. Here we describe the single color staining of the somatostatin receptor subtype 2A (SSTR2A) and dual color staining of the trans-Golgi-network protein TGN 38 and the t-SNARE syntaxin-6 for STED in the endocrine cell line AtT20 and STED imaging of the samples, providing the protocols in as general a form as possible. The protocols in this chapter are used in this way in an institutional microscopy core facility.

Stereogenic silicon centres in functionalised tetracoordinated organosilanes generally exhibit very high configurational stability under neutral conditions. This stability drops completely when higher coordination states of the silicon centre are reached due to rapid substituent exchange. Herein we describe the synthesis of chiral and neutral pentacoordinate silicon derivatives with high configurational stability. The zwitterionic nature of these air- and water-tolerant species allows for the first time their direct and efficient optical resolution using chiral HPLC techniques. By means of this method, pentacoordinate silicon compounds exhibiting high Si-inversion have been obtained as single enantiomers. A rationalisation of the enantiomerisation pathways has been also carried out using DFT calculations.