N,N-Diethyl-3-toluamide (DEET) is a commonly used insect repellent, which acts as an organic chemical contaminant in water and considered as an emerging contaminant which has been observed worldwide. It gets discharged into the environment through sewage waste. The various methods have been used to degrade DEET, such as UV based, ozonation, photocatalytic degradation, and biodegradation (based on the metabolic activity of fungi and bacteria). However, less research has been done on the degradation of DEET by deploying nanoparticles. Therefore, biodegradation and nanotechnology-based methods can be the potential solution to remediate DEET from the environment. This review is an attempt to analyze the routes of entry of DEET into the atmosphere and its environmental health consequences and to explore physical, chemical, and biological methods of degradation. Furthermore, it focuses on the various methods used for the biodegradation of the DEET, including their environmental consequences. Future research is needed with the application of biological methods for the degradation of DEET. Metabolic pathway for biodegradation was explored for the new potent microbial strains by the application of physical, chemical, and microbial genomics; molecular biology; genetic engineering; and genome sequencing methods.

Electrospun beta-cyclodextrin (βCD)-based polymers can combine a high surface-to-volume ratio and a high loading/controlled-release-system potential. In this work, pyromellitic dianhydride (PMDA)/βCD-based nanosponge microfibers were used to study the capability to host a common insect repellent (N,N-diethyl-3-toluamide (DEET)) and to monitor its release over time. Fibrous samples characterized by an average fibrous diameter of 2.8 ± 0.8 µm were obtained and subsequently loaded with DEET, starting from a 10 g/L diethyl ether (DEET) solution. The loading capacity of the system was assessed via HPLC/UV⁻Vis analysis and resulted in 130 mg/g. The releasing behavior was followed by leaving fibrous DEET-loaded nanosponge samples in air at room temperature for a period of between 24 h and 2 weeks. The releasing rate and the amount were calculated by thermogravimetric analysis (TGA), and the release of the repellent was found to last for over 2 weeks. Eventually, both the chemical composition and sample morphology were proven to play a key role for the high sample loading capacity, determining the microfibers\' capability to be applied as an effective controlled-release system.