OBJECTIVE: To report a case series of extra-articular osteotomies for the management of intra-articular tibial plateau malunions and to assess the ability to correct deformity and improve knee range of motion (ROM).
METHODS:  .
METHODS: Retrospective case series.
METHODS: Academic, tertiary, referral center.
UNASSIGNED: Adult patients with tibial plateau fracture malunion treated with extra-articular osteotomy of the femur and/or tibia between 2014 and 2023.
UNASSIGNED: Mechanical axis deviation (MAD), medial proximal tibia angle (MPTA), lateral distal femoral angle (LDFA), and posterior proximal tibia angle (PPTA) correction; knee ROM; and time to weight bearing.
RESULTS: There were 7 patients included, 6 (85.7%) were female and 1 (14.3%) were male. The median age was 43.5 years (IQR 38.5-51, range 32-62). Four (57.1%) patients were treated with a high tibial osteotomy (HTO), and 3 (42.9%) patients were treated with an HTO and distal femoral osteotomy. One patient had concomitant supramalleolar osteotomy with HTO to address distal tibia procurvatum and valgus. Four were treated with hexapod frames, and 3 were treated with plates and screws. Median follow-up was 22.5 months (IQR 10.5-107 months, range 7-148 months). Surgical intervention corrected median radiographic measures of valgus malalignment preoperatively relative to postoperative values. This included MAD (42.5 mm-0 mm), valgus angle (12.5 degrees-1.5 degrees), MPTA (95 degrees-88.0°), and LDFA (86.0°-87.3 degrees). Surgical intervention increased maximal knee range of motion preoperatively to postoperatively. Median time to full weight bearing was 81.5 days (IQR 46-57 days, range 41-184 days). Two patients were converted to total knee arthroplasty after 5 and 10 years following HTO with hexapod frame.
CONCLUSIONS: Extra-articular osteotomy is an effective treatment for addressing intra-articular malunion after tibia plateau fractures. It is effective in correcting the MAD, valgus deformity, MPTA, LDFA, PPTA, and improving knee ROM (measured through knee extension and flexion).
METHODS: Therapeutic Level IV. See Instructions for Authors for a complete description of levels of evidence.

The incidence of complex articular fractures of the distal humeral in adults has increased and will be growing in the future due to the greater incidence of high-energy trauma and to the higher percentage of the elderly population. Successful treatment is challenging for the needed balance between the stability of often comminuted fractures and early motion. Malunion is a common complication after distal humerus fractures that is influenced by a variety of factors, such as biology, particularly the blood supply of the metaphysis, the nonanatomical reduction of the fracture, the methods of fixation, and mechanical failure. These can involve the intra-articular or extra-articular areas. The clinical presentation may be mainly with pain and instability as for the cubitus varus, or with disfunction and stiffness as for an intra-articular malunion. However, the symptoms will depend on the degree of articular surfaces damage and the degree of deformities in specific planes. The surgical treatment can be challenging, varying from supracondylar osteotomies and re-contouring arthroplasty for extra-articular deformities to interposition arthroplasty, and elbow replacement for intra-articular deformities.

Standard volar plates often do not fit the surface of the malunited distal radius after osteotomy, necessitating an offset angle for accurate volar tilt correction. The correction can be achieved if the plate is held at the correct angle when the distal screws are locked. With the advantage of 3D surgical planning and patient-specific instruments, we developed a shim instrument to assist the surgeon in securing the plate at the intended angle when locking the distal screws, and evaluated radiological results. Five female patients aged 63-74 with dorsally angulated extra-articular malunions underwent surgery using 3D-printed guides and the shim instrument. The plate position, drilling guide alignment, screw placements, and distal radius correction on postoperative CTs were compared with the surgical plans. Errors were measured using an anatomical coordinate system, and standard 2D radiographic measures were extracted. Preoperative dorsal tilt ranged from 16° to 35°, and postoperative volar tilt from 1° to 11°. 3D analysis revealed mean absolute correction errors of 6.1° in volar tilt, 1.6° in radial inclination, and 0.6 mm in ulnar variance. The volar tilt error due to the shim instrument, indicated by the mean angle error of the distal screws to the plate, was 2.1° but varied across the five patients. Settling of the distal radius, due to tension during and after reduction, further contributed to a mean loss of 3.5° in volar tilt. The shim instrument helped with securing plates at the intended angle; however, further correction improvements should consider the tension between the fragments of osteoporotic bone.

暂无摘要。

While several proximal humerus fractures treated nonsurgically reach satisfactory outcomes, some become symptomatic malunions or nonunions with pain and dysfunction. When joint-preserving options such as malunion or nonunion repair are not optimal because of poor remaining bone stock or glenohumeral arthritis, shoulder arthroplasty is a good option. Because of the semiconstrained design of reverse shoulder arthroplasty, it is effective at improving function when there is notable bony deformity or a torn rotator cuff. Clinical studies have demonstrated reliable outcomes, and a classification system exists that is helpful for predicting prognosis and complications. By understanding the associated pearls and pitfalls and with careful management of the tuberosities, reverse shoulder arthroplasty is a powerful tool for managing proximal humerus fracture sequelae.

Clavicle fractures are a common injury in adults. Most patients are treated non-operatively. In this case report, a 53-year-old professional violinist had a midt shaft clavicula fracture and was treated non-operatively. The fracture healed, but the patient developed thoracic outlet syndrome (TOS) and a venous thrombosis when playing violin. Surgery with restoration of the normal anatomy alleviated the symptoms and six months later she was symptom free and playing violin again. TOS is a rare complication to clavicle fractures and the treating doctors should be aware of the diagnosis.

BACKGROUND: Grade III open tibial diaphyseal fractures are challenging to treat and controversy exists on whether to treat them with an intramedullary nail (IMN) or a circular frame (CF). This study aims to compare outcomes for intramedullary nail and circular frame in the treatment of open tibial diaphyseal fractures.
METHODS: Retrospective study at a major trauma center of all patients admitted with a grade III open tibial diaphyseal fracture between January 2016 and January 2022. The primary outcome measures were major complications: non-union, malunion, refracture, DBI and amputation. Secondary outcome measures were time to union and reoperation rates.
RESULTS: Fifty-five patients were included in the study, 32 patients in CF group and 23 patients in IMN group. There were no significant differences in the baseline demographics of patients in both groups. Major complications were recorded in 13 limbs (54%) in IMN group and in 18 limbs (56%) in CF group which were not statistically significant (p = 0.797). Deep bone infection rates were noted in 4 (12.5%) in the CF group, compared to 1 (4%) in IMN group; however, the result was not statistically significant (p = 0.240). Amputation rates as a result of infected non-unions were seen in 1 limb (4%) in IMN group and 2 limbs (6%) in CF group (p = 0.99). Median time to union was significantly shorter in IMN group at 30 weeks compared to 30 weeks for CF group (p = 0.04).
CONCLUSIONS: IMN should be the treatment of choice in the treatment of grade III open tibial diaphyseal fracture, but CF should be considered for delayed treatment and in patients with bone loss.

OBJECTIVE: To study the clinical, radiological, and functional outcomes after of radioscapholunate (RSL) fusion for intra-articular malunion of the distal radius.
METHODS: This retrospective study included 26 patients (17 males and 9 females) with intra-articular malunion of distal radius fractures who underwent RSL arthrodesis using locked miniplates (without distal scaphoid excision) between 2012 and 2020. Their mean age was 43 years (range, 32-56). Patients were assessed radiographically for union and clinically for range of motion, grip strength, and pain (assessed by Visual Analogue Scale (VAS) for pain). Functional evaluation was performed by using the Mayo modified wrist score (MMWS) and the Disabilities for the Arm, Shoulder, and Hand (DASH) questionnaire.
RESULTS: All patients showed complete healing at the fusion site after a mean of 8.7 weeks (range, 8-12). The mean follow-up period was 72 months (range, 60-84). The pinch strength improved from a mean of 6.2 kg (range, 3-12) to a mean of 9.8 kg (range, 5-18) which represents 80% of the contralateral side. The mean pinch strength was 7 kg (range, 5-18) which presents 80% of the other side. VAS for pain showed a mean improvement of 72.6%. The DASH score improved to a mean of 19.2 (range, 14-24). The MMWS improved to a mean of 68 (range, 45-86). At the final follow-up period, no degenerative changes were detected in the midcarpal joint.
CONCLUSIONS: RSL arthrodesis (using locked miniplates without distal scaphoid excision) is a reliable surgical procedure to manage cases of radiocarpal OA after intra-articular malunion of distal radius fractures with good clinical and radiological outcomes.
METHODS: Level IV- therapeutic.

OBJECTIVE: To introduce anterior peri-sacroiliac joint osteotomy (APSJO) through the lateral-rectus approach (LRA) for treating pelvic fracture malunion and nonunion, and to evaluate the safety, feasibility, and potential effectiveness.
METHODS: Data of 15 patients with pelvic fracture malunion and nonunion who underwent treatment by APSJO were selected and analyzed. The reduction quality was assessed using the Mears and Velyvis criteria, while the pre-operative and post-operative function was revealed by the Majeed scoring system. The British Medical Research Council (BMRC) grading system was recruited for the evaluation of lumbosacral plexus function.
RESULTS: The average operative duration was 264.00 ± 86.75 min, while the intra-operative blood loss was 2000 (600, 3000) mL. Anatomical reduction was complete in three cases, satisfactory in ten cases, and unsatisfactory in two cases. Among the seven patients with lumbosacral plexus injury, the pre-operative Majeed grades were good in two cases, fair in two cases, and poor in three cases, while the post-operative Majeed grades were excellent in three cases, good in three cases, and fair in one case. Muscle strength recovered to M5 in two cases, M4 in three cases, and showed no recovery in two cases. The pre-operative Majeed grades were good in five cases, fair in two cases, and poor in one case of the series without lumbosacral plexus injury, while the post-operative Majeed grades were excellent in seven cases and good in one case.
CONCLUSIONS: APSJO through LRA may be a feasible strategy for treating pelvic fracture malunion and nonunion with promising application.

OBJECTIVE: Rotational malalignment and leg length discrepancy after intramedullary nailing of femoral shaft are frequent. This study has three objectives: evaluate the rate of femoral rotational malalignment and leg length discrepancy using EOS imaging after antegrade intramedullary nailing of femoral shaft fracture, find a relevant clinical examination to detect malrotation and identified risk factors.
METHODS: We performed a retrospective single-centre study between January 2014 and January 2022. Fifty-eight patients were clinically and radiographically assessed at a minimum of three months.
RESULTS: The femoral rotation of the operated side was significantly greater by a mean of 15.4° in internal rotation compared to the healthy side. There was no statically significant difference for the femoral length (p = 0.08).
CONCLUSIONS: When using EOS stereography following antegrade intramedullary nailing of post-traumatic diaphyseal femur fractures, a statistically significant difference of more than 15.4° in internal rotation was found for femoral rotation on the operated side compared to the healthy side.Please confirm if the author names are presented accurately and in the correct sequence (given name, middle name/initial, family name). Author 1 Given name: [B. Poirot] Last name [Seynaeve]. Also, kindly confirm the details in the metadata are correct.The last name of the first author was corrected : Given name = B. and last name = Poirot Seynaeve The details in matadata are correct LEVEL OF EVIDENCE: III.