OBJECTIVE: To evaluate the efficacy of calvarial graft (CG) in craniovertebral fusion procedures in children at a single single center.
METHODS: Paediatric patients in whom CG had been used as the sole construct, or to augment a semi-rigid construct were identified from a prospective operative database. Age, underlying diagnosis and clinical presentation were obtained from review of the electronic patient record. The primary outcome was bony fusion confirmed on CT. Additional outcome measures were donor site morbidity and need for further surgery.
RESULTS: From 82 paediatric CVJ procedures, CG was used in 15 patients with a mean age of 4.1 (± 3.52) years. Aetiology comprised skeletal dysplasia (n = 12), congenital anomaly of segmentation (n = 1) and cervical trauma (n = 2). Myelopathy was the most common clinical finding (9/15), followed by cervical pain (3/15). The indications for surgery comprised atlanto-axial subluxation (8/15), basilar invagination with compression (2/15), and cervicomedullary compression without instability but deemed at risk of instability following decompression (4/15). CG was used in three scenarios: (i) CG + wire only (n = 10); (ii) CG + semirigid instrumentation (n = 3); (iii) CG to augment rigid instrumented fixation (n = 2). In 13 patients a Halo-body Jacket was used peri-operatively. At a mean time of 4.4 months following surgery, 80% of cases had radiological evidence of fusion.
CONCLUSIONS: Full thickness calvarial bone graft is readily available, has good structural integrity and is associated with minimal donor site morbidity. CG should be considered for use as a sole construct, or to augment semi-rigid constructs when instrumented fixation is precluded.

BACKGROUND: Calvarial grafts represents a superior option for orbital floor reconstruction, however the difficulty of intraoperative moulding and placement remains as a major limitation. We used patient specific guides and sterolithographic models to facilitate this procedure.
METHODS: The study was conducted on 10 patients with orbital floor blow out fracture. A graft harvesting guide was virtually constructed based on the defect using mirroring of the normal side. The virtual guide and the defective orbital floor were then printed. The graft was harvested using the guide and adjusted to the defect using the model, finally seated in place.
RESULTS: All patients showed no enophthalmos or diplopia. Orbital volume was comparable for both traumatised and normal orbits with no statistical significance difference (p value 0.28), and orbital volume ratio was 101.76 ± 4.7%.
CONCLUSIONS: The use of graft harvesting guide and orbital floor models for intraoperative graft moulding showed promising results.

Objectives To evaluate the average thickness of the parietal bones in their different regions to identify the ideal site(s) for calvarial bone graft harvest. Methods and Materials Thickness of the parietal bones of 25 wet cranial vaults of New Zealand European origin was measured in 135 different locations using an electronic caliper. Analyses to identify the ideal harvest sites were conducted so that the sites fit the features of an ideal harvest site described in the literature as: (1) 6 mm of minimum thickness and (2) 2 cm away from the midline. Results and Conclusion The overall average thickness was 6.69 ± 0.22 mm. The average thickness at different sites within the same bone ranged from 2.85 to 6.93 mm. In keeping with previous studies, the report observed a progressive thickening of the parietal bone in medial and posterior directions. Of the 135 different locations measured, only 20% exceeded an average thickness of 6 mm as well as being 2 cm away from the sagittal midline. These locations were mainly located between 6 to 11 cm posterior to the coronal suture and 2 to 5 cm away from the sagittal suture. Conclusion Harvesting the calvarial bone graft in the area 6 to 11 cm posterior to the coronal suture and 2 cm away from the midline is recommended based on our study using cadaveric cranial vaults of New Zealand Europeans.