This study aimed to histologically evaluate the effects of XPEED® and SLA surface on the mineral apposition rate (MAR) at 3 and 5 weeks in titanium dental implants placed in human bone. In total, 17 titanium dental implants with XPEED® surface (n = 9) used as test and SLA surface (n = 8) used as control were included in this study. Each patient received four doses of tetracycline 500 mg at 12 h intervals 2 weeks prior to biopsy retrieval. Implant retrieval was performed, and retrieved biopsies were carefully treated for histomorphometric evaluation under epifluorescence microscopy. At 3 and 5 weeks, newly formed bone appeared in direct contact with both types of tested surfaces. At 3 weeks, the MAR value was, respectively, 2.0 (±0.18) μm/day for XPEED® implants and 1.5 (±0.10) μm/day for SLA implants (p = 0.017). At 5 weeks, lower MAR values for both XPEED® and SLA implants were noted, with 1.2 (±0.10) μm/day and 1.1 (±0.10) μm/day, respectively (p = 0.046). The overall evaluation by linear regression analysis for both time and implant surfaces showed a decreased osteoblast activity at 5 weeks compared to 3 weeks (p < 0.005). The results of the present study show that the bone apposition rate occurs faster around implants with XPEED® surface at 3 weeks and 5 weeks of healing. MAR values may support the use of implants with XPEED® surfaces in early loading protocols.

For some individuals with severe socket-related problems, prosthesis osseointegration directly connects a prosthesis to the residual limb creating a bone-anchored limb (BAL). We compared dynamic gait stability and between-limb stability symmetry, as measured by the Margin of Stability (MoS) and the Normalized Symmetry Index (NSI), for people with unilateral transfemoral amputation before and one-year after BAL implantation. The MoS provides a mechanical construct to assess dynamic gait stability and infer center of mass and limb control by relating the center of mass and velocity to the base of support. Before and one-year after BAL implantation, 19 participants walked overground at self-selected speeds. We quantified dynamic gait stability anteriorly and laterally at foot strike and at the minimum lateral MoS value. After implantation, we observed decreased lateral MoS at foot strike for the amputated (MoS mean(SD) %height; pre: 6.6(2.3), post: 5.9(1.3), d = 0.45) and intact limb (pre: 6.2(1.2), post: 5.8(1.0), d = 0.38) and increased between-limb MoS symmetry at foot strike (NSI mean(SD) %; anterior-pre: 10.3(7.3), post: 8.4(3.6), d = 0.23; lateral-pre: 18.8(12.4), post: 12.4(4.9), d = 0.47) and at minimum lateral stability (pre: 28.1(18.1), post: 19.2(6.8), d = 0.50). Center of mass control using a BAL resulted in dynamic gait stability more similar between limbs and may have reduced the adoption of functional asymmetries. We suggest that improved between-limb MoS symmetry after BAL implantation is likely due to subtle changes in individual limb MoS values at self-selected walking speeds resulting in an overall positive impact on fall risk through improved center of mass and prosthetic limb control.

OBJECTIVE: To describe and evaluate the combination of osseointegration and nerve transfers in 3 transhumeral amputees.
METHODS: Case series.
METHODS: Three male patients with a unilateral traumatic transhumeral amputation.
METHODS: Patients received a combination of osseointegration and targeted muscle reinnervation surgery. Rehabilitation included graded weight training, range of motion exercises, biofeedback, table-top prosthesis training, and controlling the actual device. The impairment in daily life, health-related quality of life, and pain before and after the intervention was evaluated in these patients. Their shoulder range of motion, prosthesis embodiment, and function were documented at a 2- to 5-year follow-up.
RESULTS: All 3 patients attended rehabilitation and used their myoelectric prosthesis on a daily basis. Two patients had full shoulder range of motion with the prosthesis, while the other patient had 55° of abduction and 45° of anteversion. They became more independent in their daily life activities after the intervention and incorporated their prosthesis into their body scheme to a high extent.
CONCLUSIONS: These results indicate that patients can benefit from the combined procedure. However, the patients\' perspective, risks of the surgical procedures, and the relatively long rehabilitation procedure need to be incorporated in the decision-making.

This case report describes a dual full-arch rehabilitation focusing on a modified buccal incision for installation of four implants for full-arch rehabilitation of an edentulous maxilla. A modified buccal incision was performed in the subcrestal buccal region to promote direct access to the periosteum without incising the muscles in the region. For the installation of anterior implants, an 8.5 mm implant was locked in the cortical bone of the alveolar ridge and in the cortical bone of the floor of the pyriform cavity. The drilling point of the posterior implants was defined using the anterior implants as a visual reference, and the entry point could be visually estimated from the topography of the palatal surface of the maxilla. After bone leveling, the drilling enlargement sequence was carried out using drills that allowed the installation of long implants (18 mm). Straight mini-abutments were installed in the anterior implants and angled at 30º in the posterior implants. The flap was then perforated in the exact region where the mini-abutments were located. The buccal incision line was sutured with continuous 5-0 nylon suture. On the following day, aesthetic tests were carried out with teeth mounting. The patient presented minimal edema, and the lip motricity and smile width were completely preserved. The prosthesis was delivered five days after surgery. The suture was removed, and the prosthesis was installed while maintaining compression on the gingival tissue. The patient reported no pain during the prosthesis installation. The modified buccal flap enables implant placement for full-arch rehabilitation of an edentulous maxilla.

When edentulism is accompanied by an impacted tooth, conventional treatment usually involves traumatic tooth extraction, which would inevitably destroy the surrounding alveolar bone and cause unfavorable esthetics, especially for anterior teeth. Recently, implant placement through the impacted tooth or residual root has been proposed as an alternative to invasive extraction. A particular type of integration has been observed between dentin/cementum and titanium implant, while enamel-implant contact has not been reported. In this article, an implant was placed through the impacted maxillary central incisor, thereby avoiding an invasive extraction surgery. The buccal section of the tooth, including crown enamel, was retained in situ for buccal alveolar ridge preservation. The follow-up results were satisfactory, and a stable enamel-implant contact was observed. Combining with previous similar studies, this technique opens intriguing possibilities and brings fresh insight for the concept of dentointegration. More histological and clinical studies with long-term follow-up are warranted before endorsing this technique in routine application.

METHODS: A 38-year-old man with congenital pain insensitivity underwent bilateral below-knee amputations. After his subsequent bilateral osseointegration (OI) limb replacements, he rapidly developed severe bilateral knee arthritis and varus deformity. In lieu of performing bilateral above-knee amputations, he underwent bilateral staged total knee arthroplasties (TKA) with excellent clinical and radiographic evaluation at 1-year follow-up.
CONCLUSIONS: To address both the limited bone stock and OI implant stem location, TKA after OI limb replacement in congenital pain insensitivity patients can be successfully achieved with a nonkeeled cementless tibial component and augmentation with a tibial cone.

OBJECTIVE: To evaluate the feasibility of reversing a primary failure through therapeutic mechanical stimulation induced by transcutaneous application of acoustic waves (ESWT) in the peri-implant tissues. Materials and Μethods: This clinical report evaluates the outcome of a new protocol proposed to treat a primary failure (loosened oral implant); application of three cycles of ESWT, once session per week for 3 consecutive weeks, with an equivalent positive energy of 0,18 mJ/mm² (therapeutic dose: 2000 impulses/ 8Hz/ 4.0 bar). Standardized intraoral radiographs, Cone Beam Computed Tomography (CBCT), Implant Stability Quotient (ISQ) and clinical evaluations were performed.
RESULTS: It was possible to verify a progressive increase in the ISQ value after the ESWT protocol; 17 (initial), 46 (after two months) and 68 (after four months), which led to successful implant prosthetic rehabilitation (35 N/cm measured). Our evaluation at 6 years of follow-up confirms that the new bone-implant interface is preserved and ESWT as a safe non-invasive treatment.
CONCLUSIONS: In the context of the new dynamic model of osseointegration, the Foreign Body Equilibrium (FBE), this represents the first report of a host-Implant equilibrium re-established after an early failure process. However, it is necessary to perform studies to determine both the medical device and the most effective therapeutic range for clinical applications of this technology in oral implantology.

Objective.The advent of surgical reconstruction techniques has enabled the recreation of myoelectric controls sites that were previously lost due to amputation. This advancement is particularly beneficial for individuals with higher-level arm amputations, who were previously constrained to using a single degree of freedom (DoF) myoelectric prostheses due to the limited number of available muscles from which control signals could be extracted. In this study, we explore the use of surgically created electro-neuromuscular constructs to intuitively control multiple bionic joints during daily life with a participant who was implanted with a neuromusculoskeletal prosthetic interface.Approach.We sequentially increased the number of controlled joints, starting at a single DoF allowing to open and close the hand, subsequently adding control of the wrist (2 DoF) and elbow (3 DoF).Main results.We found that the surgically created electro-neuromuscular constructs allow for intuitive simultaneous and proportional control of up to three degrees of freedom using direct control. Extended home-use and the additional bionic joints resulted in improved prosthesis functionality and disability outcomes.Significance.Our findings indicate that electro-neuromuscular constructs can aid in restoring lost functionality and thereby support a person who lost their arm in daily-life tasks.

OBJECTIVE: To evaluate the survival rates of dental implants with a hybrid macrostructure and the surface biomimetically coated with nanohydroxyapatite, placed in horizontally atrophic maxillae previously submitted to the guided bone regeneration (GBR) procedure, associated with the use of a deproteinized bovine bone graft (DBB).
METHODS: Twenty-five patients who received 196 implants were involved in this study. First, these patients were submitted to GBR procedures and maxillary sinus lift, where DBB was used as the grafting material. The dental implants were placed after a minimum period of 6 months of the grafting procedures. The patients were followed up every six months and clinical/radiographic examinations were performed to assess the implants, using the following indicators as a reference: (1) Absence of mobility; (2) Absence of pain. Data about the age, surgery time, smoking status, implant size, and time between the grafting procedure and implant placement were correlated with implant failures.
RESULTS: Twelve implants failed, generating a survival rate of 94.23%. None of the variables analysed correlated with the implant failures.
CONCLUSIONS: Implants with a hybrid macrostructure and surface biomimetically coated with nanohydroxyapatite present good survival rates in horizontally atrophic maxillae grafted with DBB.

BACKGROUND: Simvastatin (SMV), a lipid lowering drug, can modulate the process of bone regeneration at the molecular and cellular levels. Its effect on the osseointegration of implants has been studied extensively on animals with assuring results with limited research on human subjects.
OBJECTIVE: To estimate the effect of simvastatin gel in the osseointegration of dental implants using bone scintigraphy, Materials and Methods: 20 participants with missing mandibular first molars and D2 type bone were assigned equally to Group A receiving 1.2% simvastatin and Group B receiving Placebo gels during the placement of implants. The participants were subjected to bone scintigraphy to determine the osteoblastic activity at baseline, 30th day and 90th day after implant placement.
RESULTS: Group A revealed a significant increase in osteoblastic activity between baseline, day 30 and 90 (P<.05) with a higher mean of 100.06±21.644% on day 30. Group B revealed a significant increase in osteoblastic activity only between baseline and day 30, and baseline and day 90 (P<.05) whereas there was no difference between day 30 and 90 (P>.05) with a higher mean of 79.20±18.255% on day 30. Bivariate analysis at different time periods revealed a significant difference between groups A and B on day 30.
CONCLUSIONS: Implants placed with 1.2% simvastatin gel showed enhanced osteoblastic activity on the fourth week of implant placement, indicating faster rate of osseointegration at an early stage.