OBJECTIVE: To investigate the chemical changes affecting different types of gutta-percha and endodontic sealers during heating, and correlate changes with the heating capacity of different heat carriers.
METHODS: The heating capacity of three endodontic heat carriers was evaluated using thermocouples to produce heat profiles. The devices were activated at different temperature set-ups, in continuous or cut-out modes. Chemical changes of six brands of gutta-percha and four types of sealers were assessed in real time during heating using micro-Raman spectroscopy equipped with a heating stage. Raman spectra of each tested material were averaged and compared at different temperature levels. The sealers were further assessed by Fourier transform infrared (FT-IR) spectroscopy.
RESULTS: None of the tested heat carriers achieved the temperature levels that were set by the devices and recommended by the manufacturer. The use of continuous heating mode resulted in higher rises in temperature than the 4 s cut-out mode that reached 110 °C. The various brands of gutta-percha exhibited different chemical changes in response to heat. Some changes even occurred below temperature levels generated by the heating devices. All sealers revealed changes in their chemical composition upon heating. Changes in epoxy resin- and zinc oxide-eugenol-based sealers were detectable at 100 °C, with structural alterations beyond that temperature and irreversible changes after cooling. Water loss was irreversible in BioRoot, but its chemical structure was stable as well as for the TotalFill.
CONCLUSIONS: The heating capacity of endodontic heat carriers needs to be standardized, so that the temperatures delivered by the tips are the same as that set on the dial. Practitioners should be aware of the actual temperatures generated by these devices, and the suitability of sealers to be used at the temperature levels achieved.

The cancer-associated P187S polymorphism in the NAD(P)H:quinone oxidoreductase 1 (NQO1) abolishes enzyme activity by strongly reducing FAD binding affinity. A single mammalian consensus mutation (H80R) protects P187S from inactivation. To provide mechanistic insight into these effects, we report here a detailed structural and thermodynamic characterization of FAD binding to these NQO1 variants. Our results show that H80R causes a population shift in the conformational ensemble of apo-P187S, remodelling the structure and dynamics of the FAD-binding site and reducing the energetic penalization arising from the equilibrium between apo- and holo-states. Our analyses illustrate how single amino acid changes can profoundly affect structural and mechanistic features of protein functional traits, with implications for our understanding of protein evolution and human disease.

Catalytically inactive oxidized O2-sensitive [NiFe]-hydrogenases are characterized by a mixture of the paramagnetic Ni-A and Ni-B states. Upon O2 exposure, enzymes in a partially reduced state preferentially form the unready Ni-A state. Because partial O2 reduction should generate a peroxide intermediate, this species was previously assigned to the elongated Ni-Fe bridging electron density observed for preparations of [NiFe]-hydrogenases known to contain the Ni-A state. However, this proposition has been challenged based on the stability of this state to UV light exposure and the possibility of generating it anaerobically under either chemical or electrochemical oxidizing conditions. Consequently, we have considered alternative structures for the Ni-A species including oxidation of thiolate ligands to either sulfenate or sulfenic acid. Here, we report both new and revised [NiFe]-hydrogenases structures and conclude, taking into account corresponding characterizations by Fourier transform infrared spectroscopy (FTIR), that the Ni-A species contains oxidized cysteine and bridging hydroxide ligands instead of the peroxide ligand we proposed earlier. Our analysis was rendered difficult by the typical formation of mixtures of unready oxidized states that, furthermore, can be reduced by X-ray induced photoelectrons. The present study could be carried out thanks to the use of Desulfovibrio fructosovorans [NiFe]-hydrogenase mutants with special properties. In addition to the Ni-A state, crystallographic results are also reported for two diamagnetic unready states, allowing the proposal of a revised oxidized inactive Ni-SU model and a new structure characterized by a persulfide ion that is assigned to an Ni-\'Sox\' species.

Fourier transform infrared spectroscopy (FT-IR) has been used together with pattern recognition methodology to study isolates belonging to the species Campylobacter coli and Campylobacter jejuni and to compare FT-IR typing schemes with established genomic profiles based on enterobacterial repetitive intergenic consensus PCR (ERIC-PCR). Seventeen isolates were cultivated under standardized conditions for 2, 3, and 4 days to study variability and improve reproducibility. ERIC-PCR profiles and FT-IR spectra were obtained from strains belonging to the species Campylobacter coli and C. jejuni, normalized, and explored by hierarchical clustering and stepwise discriminant analysis. Strains could be differentiated by using mainly the first-derivative FT-IR spectral range, 1,200 to 900 cm(-1) (described as the carbohydrate region). The reproducibility index varied depending on the ages of the cultures and on the spectral ranges investigated. Classification obtained by FT-IR spectroscopy provided valuable taxonomic information and was mostly in agreement with data from the genotypic method, ERIC-PCR. The classification functions obtained from the discriminant analysis allowed the identification of 98.72% of isolates from the validation set. FT-IR can serve as a valuable tool in the classification, identification, and typing of thermophilic Campylobacter isolates, and a number of types can be differentiated by means of FT-IR spectroscopy.

Reaction-induced infrared difference spectroscopy (RIDS) has been used to investigate the nature of interactions of human annexin A6 (ANXA6) with nucleotides. RIDS results for ANXA6, obtained after the photorelease of GTP-gamma-S, ATP, or P(i) from the respective caged compounds, were identical, suggesting that the interactions between the nucleotide and ANXA6 were dominated by the phosphate groups. Phosphate-induced structural changes in ANXA6 were small and affected only seven or eight amino acid residues. The GTP fluorescent analogue, 2\'(3\')-O-(2,4,6-trinitrophenyl)guanosine 5\'-triphosphate (TNP-GTP), quenched tryptophan fluorescence of ANXA6 when bound to the protein. A binding stoichiometry of 1 mol of nucleotide/mol ANXA6 was established with a K(D) value of 2.8 microM for TNP-GTP. The bands observed on RIDS of ANXA6 halves (e.g., N-terminal half, ANXA6a, and C-terminal half, ANXA6b) were similar to those of the whole molecule. However, their amplitudes were smaller by a factor of 2 compared to those of whole ANXA6. TNP-GTP bound to both fragments of ANXA6 with a stoichiometry of 0.5 mol/mol. However, the binding affinities of ANXA6a and ANXA6b differed from that of ANXA6. Simulated molecular modeling revealed a nucleotide-binding site which was distributed in two distinct domains. Residues K296, Y297, K598, and K644 of ANXA6 were less than 3 A from the bound phosphate groups of either GTP or ATP. The presence of two identical sequences in ANXA6 with the F-X-X-K-Y-D/E-K-S-L motif, located in the middle of ANXA6, at residues 293-301 (within ANXA6a) and at 641-649 (within ANXA6b), suggested that the F-X-X-K-Y-D/E-K-S-L motif was the putative sequence in ANXA6 for nucleotide binding.

The E7 and E6 proteins are the main oncoproteins of human papillomavirus types 16 and 18 (HPV-16 and HPV-18), and possess unknown protein structures. E7 interacts with the cellular tumour-suppressor protein pRB and contains a zinc-binding site with two Cys-Xaa2-Cys motifs spaced 29 or 30 residues apart. E6 interacts with another cellular tumour-suppressor protein p53 and contains two zinc-binding sites, each with two Cys-Xaa2-Cys motifs at a similar spacing of 29 or 30 residues. By using the GOR I/III, Chou-Fasman, SAPIENS and PHD methods, the effectiveness of consensus secondary structure predictions on zinc-finger proteins was first tested with sequences for 160 transcription factors and 72 nuclear hormone receptors. These contain Cys2His2 and Cys2Cys2 zinc-binding regions respectively, and possess known atomic structures. Despite the zinc- and DNA-binding properties of these protein folds, the major alpha-helix structures in both zinc-binding regions were correctly identified. Thus validated, the use of these prediction methods with 47 E7 sequences indicated four well-defined alpha-helix (alpha) and beta-sheet (beta) secondary structure elements in the order beta beta alpha beta in the zinc-binding region of E7 at its C-terminus. The prediction was tested by Fourier transform infrared spectroscopy of recombinant HPV-16 E7 in H2O and 2H2O buffers. Quantitative integration showed that E7 contained similar amounts of alpha-helix and beta-sheet structures, in good agreement with the averaged prediction of alpha-helix and beta-sheet structures in E7 and also with previous circular dichroism studies. Protein fold recognition analyses predicted that the structure of the zinc-binding region in E7 was similar to a beta beta alpha beta motif found in the structure of Protein G. This is consistent with the E7 structure predictions, despite the low sequence similarities with E7. This predicted motif is able to position four Cys residues in proximity to a zinc atom. A model for the zinc-binding motif of E7 was constructed by combining the Protein G coordinates with those for the zinc-binding site in transcription factor TFIIS. Similar analyses for the two zinc-binding motifs in E6 showed that they have different alpha/beta secondary structures from that in E7. When compared with 12 other zinc-binding proteins, these results show that E7 and E6 are predicted to possess novel types of zinc-binding structure.

Low density lipoprotein receptor domains (LDLrs) represent a large cell surface receptor superfamily of consensus length 39 residues. Alignment of 194 sequences indicated highly conserved Cys and Asp/Glu residues, and a consensus secondary structure with three beta-strands was predicted. Sequence threading against known protein folds indicated consistency with small beta-sheet proteins. Complement factor I contains two LDLrs, and the second of these was successfully expressed using a bacterial pGEX system. FT-IR spectroscopy on this indicated a small amount of beta-sheet together with turns and loops. LDLr is proposed to have a beta-sheet structure in which the five biologically important Asp/Glu residues are located on an exposed loop.